Manualios.com

Manley LANGEVIN DUAL Owner's Manual

Manley LANGEVIN DUAL Manual Online:

4.4, 2358 votes
Manley LANGEVIN DUAL User Manual
Manley LANGEVIN DUAL User Guide
Manley LANGEVIN DUAL Online Manual

Text of Manley LANGEVIN DUAL User Guide:

  • Manley LANGEVIN DUAL, MANLEY LABORATORIES, INC. OWNER'S MANUAL LANGEVIN DUAL MONO MICROPHONE PREAMPLIFIER WITH EQ MANUFACTURED BY: MANLEY LABORATORIES, INC. 13880 MAGNOLIA AVE. CHINO, CA. 91710 USA TEL: (909) 627-4256 FAX: (909) 628-2482 email:[email protected] http://www.manleylabs.com REV 9-15-2004

  • Manley LANGEVIN DUAL, CONTENTS INTRODUCTION 3 MAINS CONNECTIONS 4 BASICS 5 CONNECTING YOUR PREAMPLIFIER 6 FRONT PANEL 8 REAR PANEL 9 TECH NOTES 10 SPECIFICATIONS 11 WARRANTY 12 WARRANTY REGISTRATION 13 APPENDIX A: WIRING YOUR OWN CABLES APPENDIX B: TEMPLATE FOR STORING SETTINGS SECTION PAGE

  • Manley LANGEVIN DUAL, INTRODUCTION THANK YOU!... for choosing the Langevin Dual Mono Microphone Preamplifier. Manley Labs bought all the rights to the Langevin name and circuits in 1992. Manley Labs uses the Langevin name for its solid state products including versions of an all discrete Pultec and Electro-Optical Limiter, as well as, other high performance non-tube products. This Mic Preamplifier uses an all discrete transistor audio path that simply sounds pretty damn good. We believe it is because the circuit has good audio performance before any negative feedback was used to lower the gain and further improve noise and distortion. This Micropho

  • Manley LANGEVIN DUAL, MAINS CONNECTIONS Your unit has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial badge, located on the rear panel. Check that this complies with your local supply. The voltage changeover switch is located inside the unit in the middle of the PCB near the power transformer. To change the voltage from 120 to 240 volts, simply remove the top cover by unscrewing the center fixing screw and sliding the top out towards the rear of the chassis. Turn the top of the voltage changeover switch with a f

  • Manley LANGEVIN DUAL, BASICS 5 This Microphone Preamp, like most mic preamps, is pretty easy to use. First we can discuss why outboard mic pre's have become "a must have item" in almost every studio even though your console probably has a bunch of them and that manufacturer claims that they are really great and you don't need outboard mic pre's. Then, why is everybody buying them, using them, and why are most people going back to tubes or vintage transistor based circuits? Good question. The signal from a typical mic is ver

  • Manley LANGEVIN DUAL, CONNECTING YOUR PREAMPLIFIER 6 Easy - Connect the mic to the Microphone Input XLR, then connect the Line Output to your tape machine or console. Read on, there are some things to consider. On the back panel are female XLR's labelled MIC INPUT A and MIC INPUT B. The signal from the MICROPHONES get plugged in here. Here are a few warnings and suggestions. These XLR connectors also "send" PHANTOM POWER to the mics. Some mics can be damaged by the 48 volts of phantom power. A few PZMs an

  • 7 Reversing the polarity or phase is often needed when two or more mics are picking up the same source. For example it would be needed when one mics the top and bottom of a snare - one skin is going towards one mic and the other skin is going away from the other mic. If one signal is not "reversed" then you lose lows. Polarity reverse can also help with so

  • Manley LANGEVIN DUAL, INPUT 80 Hz L.F. H.F.EQ IN 12 KHz PHANTOM 48V POWER ATTENUATE 40 Hz -10 +10 EQ OUT +10-10 8 KHz DISCRETE DUAL MONO MICROPHONE PREAMPLIFIER ATTENUATE INPUT +10-1040 Hz L.F.80 Hz 8 KHz 12 KHz +10-10 H.F. EQ OUT EQ IN PHANTOM 48V FRONT PANEL A B C D E F G I J K L M N O P A & P INPUT ATTENUATE This is the input level for the microphone signal. The best setting is achieved by watching the meters of the recording machine as you adjust this control. B & K LOW FREQ. SELECT Selects low frequency to be boosted or cut (80 Hz or 40 Hz). C & L LOW FREQUENCY ADJUST Continuo

  • Manley LANGEVIN DUAL, REAR PANEL 9 A B C D E F G H I A INSTRUMENT INPUT Optimised for Synths and drum machines but not for guitars or basses. Use a regular "DI" into the MIC INPUT for guitars and basses. Use only the instrument input or MIC INPUT but not both at the same time. B INPUT XLR (Right Channel) Balanced XLR input. PINOUT: Pin 1 Ground Pin 2 POSITIVE going phase (+) Pin 3 NEGATIVE going phase (-) C OUTPUT XLR (Right Channel) Balanced XLR output. PINOUT: Pin 1 Ground Pin 2 POSITIVE going phase (+) Pin

  • Manley LANGEVIN DUAL, TECH NOTES 10 PHANTOM POWER FUSE In earlier sections we explained most of the possible small disasters that can happen when phantom power is used. The big one is damage to other gear not designed for phantom. This includes old ribbon mics, non-pro battery powered mics and possibly other things we have yet to hear about. FOUR reasonable rules: 1) Most modern mics with 3 pin XLR connectors will be safe and there is no need to worry unless you own some exotic or real cheap mics. 2) ONLY FET condensor mics need phantom power and some direct boxes can either use it or use batteries.

  • Manley LANGEVIN DUAL, SPECIFICATIONS 11 Frequency Response 10 Hz to 20 KHz (+/- 1 dB) THD & Noise .1% (1Khz @ +10 dBm) Signal to Noise ratio 103 dB Headroom 27 dB (ref +4 dBv) Maximum Output +31 dBv (75 volts p to p) Maximum Input (with Input at max) 84 mV Maximum Gain (factory set for 45 dB) 38 dB to 53 dB (internal trimmer) Input Impedance 2400 Ohm, transformer coupled (optimised for mics with 100 to 600 ohm output impedances) 23,000 Ohm @ 1/4" input Output Impedance 11 Ohms (balanced) XLR Pin-Out (balanced) PIN 1 = Ground or Shield (not appropriate for driving unbalanced inputs) PIN 2 = HOT (+) PIN 3 = LOW (-) Power Consumption 12 watts Size 19&qu

  • Manley LANGEVIN DUAL, WARRANTY All Manley Laboratories equipment is covered by a limited warranty against defects in materials and workmanship for a period of 90 days from date of purchase to the original purchaser only. A further optional limited 5 year transferrable warranty is available upon proper registration of ownership within 30 days of date of first purchase. Proper registration is made by filling out and returning to the factory the warranty card attached to this general warranty statement, along with a copy of the original sales receipt as proof of the original date of purchase, or registration can be made online in the Tech Support section of www.manleylabs.com. This warranty is provi

  • WARRANTY REGISTRATION We ask, grovel and beg that you please fill out this registration form and send the bottom half to: MANLEY LABORATORIES REGISTRATION DEPARTMENT 13880 MAGNOLIA AVE. CHINO CA, 91710 USA Or you may FAX this form in to: +1 (909) 628-2482 or you may fill in the online warranty registration form found in the Tech Support section of our website www

More Instructions:

DOWNLOAD

Related Products and Documents (Microphone):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Edelbrock 651107 Installation instructions edelbrock/651107-5G9.pdf 02 Dec 2022 1 0.11 Mb
2 RCI 6005R Installation rci/6005r-GW5.pdf 24 Jul 2023 2
3 AOpen AX4BR-U Installation manual aopen/ax4br-u-OD1.pdf 05 Mar 2023 8 0.77 Mb
4 Philips 14GR1229 Manual  philips/14gr1229-J4D.pdf 08 Dec 2023 8 0.22 Mb
5 Network Electronics ASA Flashlink DA-T140 Operation & user’s manual network-electronics-asa/flashlink-da-t140-5D1.pdf 29 Apr 2023 16
6 Yamaha NS-6490 Owner's manual yamaha/ns-6490-NB9.pdf 15 Dec 2023 3 0.14 Mb

Similar Resources:

  • Alead

    BTMIC2

    (16 pages)
    P/N AMBM5C2XXXUSER GUIDE WIRELESS MICROPHONEBLUETOOTHFCC ID:TNZNSRX3C2XXX0678Declaration of Conformity. We declare that product AMBM5C2XXX conforms to the R&TTE Directive 1999/5/RC. BTMIC2 MICROPHONE …
  • MGC

    QMP-5101NV

    (7 pages)
    LT-6035 Rev 2 Nov 2014 Page 1 of 7QMP-5101NVNetwork Paging MicrophoneInstallation InstructionsQMP-5101NV Network Paging MicrophoneThe QMP-5101NV Network Paging Microphone module fits into the new BBX-FXMNS (MMX-BBX-FXMNS) Enclosure. It mounts on the inside dead front chassis (part of the BBX-FXMNS [MMX-BBX-FXMNS] door assembly).Figure 1: QMP-5101NV N …
  • Schoeps

    supercmit 2 u

    (20 pages)
    SuperCMIT 2 USuper-Richtrohr mit DSPSuper Shotgun Microphone with DSPBedienungsanleitungUser Guide - page 11Inhaltsverzeichnis SeiteAllgemeines 2Einsatzgebiete 3Anschließen / Bedienelemente 3Gain / Limiter 4Wichtige Hinweise 4Hinweise zur EMV 5Pflege und Wartung 5Technische Daten 6Firmware-Updates 8CE-Konformitätserklärung / Garantie 8Table of Contents pa …
  • Electro-Voice

    PC Boundary

    (2 pages)
    PolarChoice™...AND INTRODUCING THENEW POLARCHOICE PLUS™, THE FIRST TRULY UNIVERSAL PODIUM MICROPHONEThe New and ImprovedTHE NEW & IMPROVED POLARCHOICE™PolarChoice, the first podium microphone which allows you to select the polar pattern (omni, cardioid, supercardioid & hypercardioid), just got better. PolarChoice is now available in 3 different …
  • Sennheiser

    HMEC 372

    (1 pages)
    Features—Benefits• Active noise compensation • Lightweight and comfortable • Volume control• MKE 45 flexible boom mic for right or left-side use • Switchable mono/stereo• Single-sided, round cable• High-quality carrier bagTechnical DataTechnical Data - HeadphoneTransducer Principle Dynamic, closed backEar Coupling CircumauralFrequency respons …
  • Superlux

    E421B

    (2 pages)
    marketing and sales Superlux, [email protected] & logistics. Superlux Enterprise Development(Shanghai)Co., Ltd.superlux.tw1. Put the battery box PS4 onto the camera’s cold shoe2. Slide to open battery compartment3. Insert 4 x AA batteries, alkaline preferred4. Slide the battery cover back to place.5. Plug the …

Comments, Questions and Opinions: