Manualios.com

Black Horse Model BH117 Instruction Manual Book

Black Horse Model BH117 Manual Online:

3.35, 1193 votes
Black Horse Model BH117 User Manual
Black Horse Model BH117 User Guide
Black Horse Model BH117 Online Manual

Text of Black Horse Model BH117 User Guide:

  • 15 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual  9) To secure the fuel tank in place, apply a bead of silicon sealer to the forward area of the tank, where it exits the fuselage behind the engine mounting box and to the rear of the tank at the forward bulkhead. Do not secure the tank into place perma- nently until after

  • Black Horse Model BH117, 6 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual 4. Using the thread as a guide and using masking tape, tape the servo lead to the end of the thread: carefully pull the thread out. When you have pulled the servo lead out, re- move the masking tape and the servo lead from the thread. Mark point  3. Drill 1,5mm pilot holes through the block of wood for each of the four mounting screws provided with the servo. Install servo into ai- leron servo tray as same as picture below. Thread Electric wire  5. Instal servo tray with aileron servo into the wing as same as picture below. 2x10mm. Secure INSTALLING THE AILERON CONTROL HORN. Aileron contro

  • Black Horse Model BH117, 19 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Elevator servo Elevator servo See pictures below: HORIZONTAL STABILIZER. 3x 10mm 300mm Aluminium 12 mm 3 x 10mm Bottom side.

  • Black Horse Model BH117, 20 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Elevator pushrod Elevator pushrod Bottom side  Elevator pushrod install as same as the way of aileron pushrod. ELEVATOR PUSHROD INSTALLATION. Elevator control horn install as same as the way of aileron control horn. Please see pic- tures below. Control horn of elevator. M2 M2 lock nut. Elevator control horn A+B Epoxy Plus glue ELEVATOR CONTROL HORN INSTALLATION. Bottom side Secure After the epoxy has fully cured, remove the masking tape or T-pins used to hold the stabilizer in place and carefu

  • Black Horse Model BH117, 3 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Caution: this model is not a toy! If you are a beginner to this type of powered model, please ask an experienced model flyer for help and support. If you attempt to operate the model without knowing what you are doing you could easily injure yourself or somebody else. Please keep your safety and well-being in mind at all times. Important: before you start construction Even if you have already built a large number of RC models please read right through these instructions and check all the kit components against the parts list. We have taken great trouble to

  • Black Horse Model BH117, 23 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Secure. Cut. MOUNTING THE TAIL WHEEL BRACKET. Bottom side. Rudder pushrod Rudder cable.     1) Set the tail wheel assembly in place on the plywood plate. The pivot point of the tail wheel wire should be even with the rud- der hinge line and the tail wheel bracket should be centered on the plywood plate.    2) Secure the tail wheel bracket in place using three 3mm x 15mm wood screws. Be careful not to overtighten the screws. 3mm x 10mm 3mmx15mm 3x 15mm

  • Black Horse Model BH117, 2 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your P-47 THUNDERBOLT. Use the parts listing below to identify all parts. WARNING Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL RISK & RESPONSIBILITY. If you ar

  • Black Horse Model BH117, 14 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual  3) Carefully bend the second nylon tube up at a 45 degree angle (using a cigarette lighter). This tube will be the vent tube to the muffler.  4) Carefully bend the third nylon tube down at a 45 degree angle (using a cigarette lighter). This tube will be vent tube to the fueling valve. When the stopper assembly is installed in the tank, the top of the vent tube should rest just below the top surface of the tank. It should not touch th

  • Black Horse Model BH117, SPECIFICATION    Wingspan : 2,100 mm 82.68 in.    Length : 1,875 mm 73.82 in.    Weight : 7.5 kg 16.5 Lbs.    Radio : 08 channels.    Servo : 09 servos.    Engine : 33 - 45cc gas. Instruction Manual book Made in Vietnam. Item code:BH117

  • Black Horse Model BH117, 8 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Flap Control horn of the flap 2x10mm. secure. 2. INSTALLING THE FLAP CONTROL HORN. A+B Epoxy PLUS glue Installing the aileron linkages as pictures below. 3.INSTALLING THE FLAP LINKAGES. Electric wire M3 lock nut M3 75mm

  • Black Horse Model BH117, 31 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual     1) We highly recommend setting up a plane using the control throws listed.     2) The control throws should be meas- ured at the widest point of each control sur- face.    3) Check to be sure the control surfaces move in the correct directions. Ailerons : 15mm up 15mm down Flap : 35mm down Elevator : 20mm up 20mm down Rudder : 30mm right 30mm

  • Black Horse Model BH117, 22 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Control horn of Rudder. Rudder control horn install as same as the way of aileron control horn. Please see pic- tures below. RUDDER CONTROL HORN INSTALLA- TION.  1. Rudder pushrod install as same as the way of aileron control horn.  2. Rudder push - pull system install as same as picture below. RUDDER CABLE INSTALLATION. Bottom side Control horn of Rudder. A+B Epoxy PLUS Glue. Aluminium Cut. A+B Epoxy Plus glue  When you are sure that everything is a aligned correctly, mix up a gen

  • 4 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual REPLACEMENT LARGE PARTS REPLACEMENT SMALL PARTS B. Wing panel. C. Fuselage. A. Cowling. D . Horizontal stabilizer. F. Aluminium wing dihedral brace. E. Rudder B. A. B. C. D. D. E. F. 4x35mm 2. 3. 5. 1. 1. 4. 10. 11. 12. 4x 20mm 14. 15. 7. 8. 6. 9. 13. 16. G. G. Decal sheets.

  • Black Horse Model BH117, 28 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual     1. Plug the servo leads and the switch lead into the receiver. You may want to plug an aileron extension into the receiver to make plugging in the aileron servo lead easier when you are installing the wing . Plug the battery pack lead into the switch.    2. Wrap the receiver and battery pack in the protective foam to protect them from vi- bration. Use a rubber band or masking tape to hold the foam in place. Do not permanently secure the receiver and battery until after balancing the model. 

  • Black Horse Model BH117, 7 P- 47 THUNDERBOLT- ITEM CODE: BH117. Instruction Manual Repeat the procedure for the other wing half. Install aileron control horn as same as picture below. A+B Epoxy PLUS glue Control horn of the aileron A+B Epoxy PLUS glue A B Installing the aileron linkages as pictures below. 3.INSTALLING THE AILERON LINKAGES. II. FLAP. 1.INSTALLING THE FLAP SERVOS. Flap Thread 80mm 3x 10mm. M3

Related Products and Documents (Toy):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Clarion VRX938R Installation and wire connection manual clarion/vrx938r-2W5.pdf 11 Jan 2024 12 0.43 Mb
2 Telex TIF-4000 Operation & user’s manual telex/tif-4000-HN2.pdf 24 Feb 2024 18 0.97 Mb
3 Roland V-Piano Owner's manual roland/v-piano-3G4.pdf 28 Sep 2023 116 6.42 Mb
4 Craftsman 536.772320 Operator's manual craftsman/536-772320-8SJ.pdf 28 Aug 2022 56 3.72 Mb
5 Eden Nemesis NSP Series Owner's manual eden/nemesis-nsp-series-2ZK.pdf 04 Oct 2023 6 0.14 Mb
6 Quatech Serial Device Server Operation & user’s manual quatech/serial-device-server-686.pdf 10 Jan 2023 98 3.03 Mb

Similar Resources:

  • Black Horse Model

    BH129

    (30 pages)
    SPECIFICATIONInstruction Manual book Wingspan : 2,200 mm 86.61 in. Length : 1,760 mm 69.29 in. Weight : 7.4 kg 16.28 Lbs. Radio : 07 channes. Servo : 09 servos. Engine …
  • Fisher-Price

    Wild Adventures Off-Roader 77813

    (2 pages)
    Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.©2001 Mattel, Inc. All Rights Reserved.Fisher-Price and Wild Adventures are U.S. trademarks of Mattel, Inc.Printed in China 77813pr-0920 This trademark is owned by the Smithsonian Institution and is registered in the U.S. Patent and Trademark Office.Questions? We’d like to hear …
  • Fisher-Price

    Sit & Play

    (16 pages)
    1www.fisher-price.comSit & PlayJeu en position assiseSitzen und spielenZitten & spelenGioco da sedutiJuega sentadoSiddelegPara brincar sentadoIstu ja leikiSitte og lekeSitta och lekaΠαίζει ΚαθιστόStand & WalkJeu en position deboutStehen und gehenStaan & lopenPrimi passi centro attivitàPrimeros pasosStå- og gålegPara brincar de …
  • Pheonix Model

    SBACH

    (16 pages)
    I/C FLIGHT GUIDELINESMade in VietnamWhen ready to fly, first extend the transmitter aerial.Operate the control sticks on the transmitter and check that the control surfaces move freely and in the CORRECT directions.ALWAYS land the model INTO the wind, this ensures that the model lands at the slowest possible speed.Switch on the tran …
  • Fisher-Price

    LIL' MOVERS BOATING FUNTM H8090

    (2 pages)
    FCC Note (United States Only)Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.PRINTED IN CHINA H8090pr-0920Consumer Information H8090Instructions• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do no …
  • Velleman

    KSR4

    (37 pages)
    KSR4 "ESCAPE" ROBOT KIT KIT ROBOT "ESCAPE" ESCAPE ROBOTERBAUSATZ CONJUNTO ROBOT "ESCAPE" ZESTAW DO BUDOWY ROBOTA "ESCAPE" USER MANUAL 4 GEBRUIKERSHANDLEIDING 12 MODE D’EMPLOI 16 MANUAL DEL USUARIO 20 BEDIENUNGSANLEITUNG 24 INSTRUKCJA OBSŁUGI 28 MANUAL DO UTILIZADOR 32 …

Comments, Questions and Opinions: