Manualios.com

Black Horse Model L-13 Blanik Instruction Manual

Black Horse Model L-13 Blanik Manual Online:

3.95, 1630 votes
Black Horse Model L-13 Blanik User Manual
Black Horse Model L-13 Blanik User Guide
Black Horse Model L-13 Blanik Online Manual

Text of Black Horse Model L-13 Blanik User Guide:

  • Black Horse Model L-13 Blanik, Instruction Manual book SPECIFICATION    Wingspan : 2,700mm 106.30 in.    Length : 1,410 mm 55.51 in.    Weight : 2.5kg 5.50 Lbs. Parts listing required(not included).    Radio : 06 channels.    Servo : 07 mini servos.    Electric motor: Power Plant size 40.   Battery :3S-LIPo-11.1V-3,250mAh    Speed control : 60A    Propeller : 14x8 fo

  • Black Horse Model L-13 Blanik, 2 L-13 BLANIK Item code: BH138 . Instruction Manual This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your L-13 BLANIK. Use the parts listing below to identify all parts. WARNING. Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL RISK & RESPONSIBILITY. If you are inexperienced with basic R/C flight we strongly recommend you conta

  • 3 L-13 BLANIK Item code: BH138 . Instruction Manual Caution: this model is not a toy! If you are a beginner to this type of powered model, please ask an experienced model flyer for help and support. If you attempt to operate the model without knowing what you are doing you could easily injure yourself or somebody else.

  • Black Horse Model L-13 Blanik, 4 L-13 BLANIK Item code: BH138 . Instruction Manual REPLACEMENT LARGE PARTS REPLACEMENT SMALL PARTS 1) Install the rubber grommets and brass eyelets onto the aileron servos. I. AILERON. 1.INSTALLING THE AILERON SERVOS. F1.Aluminium tube Horizontal stabilizer. E. Aluminium tube wing dihedral brace. G. Decal sheet. K.Pilot F2.Aluminium tube vertical stabilizer. Temporary pin to keep hinge centered. Cut the covering away from the slot. 2. Plastic parts for pushrod 1.Landing gear. K G A. Fuselage. B. Wi

  • Black Horse Model L-13 Blanik, 5 L-13 BLANIK Item code: BH138 . Instruction Manual  2) Using a modeling knife, remove the cov- ering at possition show below.  3) Using the thread as a guide and using masking tape, tape the servo lead to the end of the thread: carefully pull the thread out. When you have pulled the servo lead out, re- move the masking tape and the servo lead from the thread.  4) Drill 1,6mm pilot holes through the block of wood for each of the four mounting screws provided with the servo. Servo tray.  5. Instal servo tray with aileron servo into the wing as same

  • Black Horse Model L-13 Blanik, 6 L-13 BLANIK Item code: BH138 . Instruction Manual Repeat the procedure for the other wing half. II. FLAP 1.INSTALLING THE FLAP SERVO Aileron control horn INSTALLING THE AILERON CONTROL HORN. Aileron control horn A+B Epoxy PLUS glue 40 mm. M2. Install aileron control horn as same as picture below. Installing the aileron linkages as pictures below. INSTALLING THE AILERON LINKAGES. Aileron. Bottom side Flap. Bottom side

  • 7 L-13 BLANIK Item code: BH138 . Instruction Manual 2x10mm. Secure. Repeat the procedure for the other wing half. thread Electric wire. Install flap control horn as same as pic- ture below. Control horn Flap. 2.INSTALLING THE FLAP CONTROL HORN. A+B Epoxy PLUS glue Installing the flap linkages as pictures below. 3.INSTALLING THE F

  • Black Horse Model L-13 Blanik, 8 L-13 BLANIK Item code: BH138 . Instruction Manual INSTALLING ELECTRIC MOTOR. Drill a hole 3.8mm diameter. Secure. 4x12mm See pictures below: Left bottom side. Right bottom side. 4x15mm

  • Black Horse Model L-13 Blanik, 10 L-13 BLANIK Item code: BH138 . Instruction Manual  2. Mount the servo to the tray using the mounting screws provided with your radio sys- tem.  1. Install the rubber grommets and brass collets into the elevator servo. Test fit the servo into the servo tray. ELEVATOR SERVO INSTALLATION. Elevator servo See pictures below: Top side. Elevator servo HORIZONTAL STABILIZER. Bottom side. ESC INSTALLING PROPELLER. Propeller not included Secure. Front view

  • Black Horse Model L-13 Blanik, 11 L-13 BLANIK Item code: BH138 . Instruction Manual Temporary pin to keep hinge centered. Assemble then apply drops of thin C/A to center of hinge,on both sides. Cut the covering away from the slot. 149 mm. Aluminium tube 6mm Bottom side. Right side Carbon tube. Epoxy glue. Right side stabilizer horizontal.

  • Black Horse Model L-13 Blanik, 12 L-13 BLANIK Item code: BH138 . Instruction Manual C/A glue. C/A glue. Epoxy glue. Elevator control horn install as same as the way of aileron control horn. Please see pic- tures below. Control horn of elevator. ELEVATOR CONTROL HORN INSTALLATION. A+B Epoxy PLUS glue. Left side stabilizer horizontal.

  • Black Horse Model L-13 Blanik, 13 L-13 BLANIK Item code: BH138 . Instruction Manual  Elevator pushrod install as same as the way of aileron pushrod. ELEVATOR PUSHROD INSTALLATION. bend 90 degree Elevator pushrod Elevator pushrod M2 lock nut. M2 Bottom side Elevator control. Elevator control Cut

  • Black Horse Model L-13 Blanik, 14 L-13 BLANIK Item code: BH138 . Instruction Manual Rudder servo install as same as method of elevator servo. See picture below: RUDDER SERVO INSTALLATION. Rudder servo Cut the covering away from the slot. Temporary pin to keep hinge centered. See picture below: VERTICAL INSTALLATION. Rudder servo. Assemble then apply drops of thin C/A to center of hinge,on both sides. 85mm Aluminium tube 6 mm

  • Black Horse Model L-13 Blanik, 15 L-13 BLANIK Item code: BH138 . Instruction Manual C/A glue. Epoxy glue. Right side. Rudder control horn install as same as the way of aileron control horn. Please see pic- tures below. Control horn of Rudder. RUDDER CONTROL HORN INSTALLA- TION. A+B Epoxy PLUS glue.

  • 16 L-13 BLANIK Item code: BH138 . Instruction Manual Rudder control horn  Rudder pushrod install as same as the way of aileron pushrod. RUDDER PUSHROD INSTALLATION. Rudder pushrod. M2 lock nut. M2 Bottom side. Bend and cut after Cut

  • Black Horse Model L-13 Blanik, 17 L-13 BLANIK Item code: BH138 . Instruction Manual Rudder pushrod. MOUNTING THE TAIL WHEEL BRACKET.    2. Using a pen, mark the locations of the two mounting screws. Remove the tail wheel bracket and drill 1mm pilot holes at the loca- tions marked.     1. Set the tail wheel assembly in place on the plywood plate. The pivot point of the tail wheel wire should be even with the rud- der hinge line and the tail wheel bracket should be centered on the plywood plate. bottom side. 3x10mm.    3. Secure the tail wheel bracket in p

  • Black Horse Model L-13 Blanik, 18 L-13 BLANIK Item code: BH138 . Instruction Manual Cut. Bottom side. C/A glue. Top side. INSTALLING THE RECEIVER AND BATTERY.     1. Plug the servo leads and the switch lead into the receiver. You may want to plug an aileron extension into the receiver to make plugging in the aileron servo lead easier when you are installing the wing . Plug the battery pack lead into the switch.    3. Position the battery pack and receiver is as picture below. D

  • Black Horse Model L-13 Blanik, 19 L-13 BLANIK Item code: BH138 . Instruction Manual Right side.  3.Insert two wing panels as pictures below. Letf side.  2. Attach the aluminium tube into the fuselage. Secure INSTALLING COCKPIT FUSELAGE . See picture below: A+B Epoxy PLus glue

  • Black Horse Model L-13 Blanik, 20 L-13 BLANIK Item code: BH138 . Instruction Manual  With the wing attached to the fuselage, all parts of the model installed ( ready to fly), and empty fuel tanks, hold the model at the marked balance point with the stabilizer level. Accurately mark the balance point on the top of the wing on both sides of the fuselage. The balance point is located 27mm back from the leading edge. This is the balance point at which your model should balance for your first flights. Later, you may wish to experiment by shifting the balance up to 10mm forward or back to change the flying characteristics.Moving the b

  • 21 L-13 BLANIK Item code: BH138 . Instruction Manual     1) We highly recommend setting up a plane using the control throws listed.     2) The control throws should be meas- ured at the widest point of each control sur- face.    3) Check to be sure the control surf

Related Products and Documents (Video Game Controller):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 MTD 119-072R000 Owner's manual mtd/119-072r000-538.pdf 17 Aug 2022 20
2 Animas IR 1250 Operation & user’s manual animas/ir-1250-1UJ.pdf 14 Sep 2023 114
3 Samsung DVDL25 - DVD L25 Mini Player Instruction manual samsung/dvdl25-dvd-l25-mini-player-X2R.pdf 23 Oct 2023 12 0.53 Mb
4 Wolf ICBWWD30 Use & care manual wolf/icbwwd30-19J.pdf 31 May 2023 36 4.41 Mb
5 Onkyo TX-NR636 Basic manual onkyo/tx-nr636-X1W.pdf 10 Aug 2023 20
6 Weider WEBE4496.0 Operation & user’s manual weider/webe4496-0-4D6.pdf 31 Oct 2023 36 5.16 Mb

Similar Resources:

  • Hobbico

    Superstar 40 ARF

    (24 pages)
    1610 Interstate Drive Champaign, IL 61822(217) 398-8970, Ext. [email protected] THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANTINSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.WARRANTYHobbico®guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This wa …
  • Thrustmaster

    360 Modena Force GT

    (5 pages)
    QUICK INSTALLTHRUSTMASTER®US TECHNICAL FEATURES 1 2 analog levers for progressive acceleration and breaking 2 Action buttons 3 8-way D-pad 4 Select button 5 Start button 6 Mode button 7 Mode LED 8 Vibration/ Force Effects switch D TECHNISCHE MERKMALE 1 2 analoge Hebel für progressives Beschleunigen und Bremsen 2 Aktions-Tasten 3 8-Wege-Richtungs …
  • Hama

    Outlandish

    (6 pages)
    00062866/05.07 PC Joystick »Outlandish«PC-GAMEAll listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied. PO Box 80 · 86651 Monheim/GermanyPhone: +49 9091 502-0Fax: +49 9091 [email protected]://www.hama.com00062866 …
  • Afterglow

    048-007-NA

    (1 pages)
    User’s GuidePRISMATIC CONTROLLER FOR XBOX ONEQUICK STARTConnect The Afterglow PrismaticController to your Xbox One via theincluded cable.048-007-NA048-007-EUCONNECTING THE AFTERGLOWPRISMATIC CONTROLLERENGLISH1 2Plug the small (micro) USB end of the cable intothe top of the controller.Connect the large (standard) USB end of thecable into the Xbox One via an …
  • Sony

    PLAYSTATION 4 PRO

    (2 pages)
    © 2018 Sony Interactive Entertainment Inc. Printed in China4-724-477-41(2)If children will be using the PS4™ system, parents or guardians can restrict access to certain content or features using parental controls.For details on what can be restricted and how to set restrictions, refer to the User's Guide.manuals.playstation.net/gb/01.htmlYou can res …
  • Unique Perspectives

    Point-It!

    (4 pages)
    Unique Perspectives Ltd. www.click2go.ie ● [email protected] Ballyline ● Callan ● Co. Kilkenny ● Ireland Phone: +353 56 7725913 ● Fax: +353 56 7725936 Page 1 of 4 October 2004 Quick Guide New options and improvements to the Point-It! joystick Light Action Version A light action version of the joystick is now available requiring only 2 …

Comments, Questions and Opinions: