Ambit U10C012 Operation & User’s Manual
|
Ambit U10C012, User’s Guide 53 Client List This page shows connected computer in client list. Tools – Client List • Refresh Click “Refresh” to get updated results.
Ambit U10C012, User’s Guide 42 Firewall Time Provision This page allows configuration of Time Provision to get the current time via specific provision mode. Firewall – Time Provision • TOD / NTP Check “TOD” to enable Time Provision using TOD. Check “NTP” to enable Time Provision using NTP. • NTP Primary Server: Specify NTP Primary Server IP address when in NTP Time Provision mode. • NTP Secondary Server: Specify NTP Secondary Server IP address when in NTP Time Provision mode. • Time Zone Select time zone from a given list when in NTP Time Provision mode. • Daynight Saving time
Ambit U10C012, User’s Guide 24 Troubleshooting the USB Installation None of the LEDs is on when I power on the LAN Cable Modem. Check the connection between the power adapter and the cable modem. Power off the LAN Cable Modem and wait for 5 Seconds and power on the modem again. If the problem still exists, you may have a hardware problem. When attempting to install the USB driver in Windows 98 SE, I receive the following error message: Device not installed at this time. Driver not found. This usually occurs when the wrong driver has been installed. To remove the wrong driver and install the correct driver: 1. Righ
Ambit U10C012, User’s Guide 20 Next to have Windows locate the necessary driver files. You will see the following screen. 5. Click Next to install the driver files for the cable modem. You will see the following screen.
User’s Guide 3 Cable Modem ................................................................................................................................................... 33 Cable Modem Information................................................................................................................... 33 Cable Modem Status............
Ambit U10C012, User’s Guide 21 7. Click Finish to complete the installation. 8. After the installation is completed, verify that the USB LED is lit on the front of you cable modem. If not, refer to the troubleshooting section later in this chapter.
Ambit U10C012, User’s Guide 39 Event Log • Contact E-mail Address Enter E-mail address for sending event log. • SMTP Server Name Enter SMTP Server Name for sending event log. • Apply Any configuration changes must be followed by “Apply” before changes will occur. • E-mail Log Send current event log to e-mail address specified. • Refresh Update event log. • Clear Log Clear event log.
Ambit U10C012, User’s Guide 5 Prepare Your Area for Cable Modem Installation Before installing your cable modem, you should first prepare your area. To do this: 1. Locate your cable outlet and ensure that it is located within proper distance of your cable modem and computer. Be sure not to bend the cable as this may strain the connector and cause damage. 2. Ensure that the temperature in the room where the cable modem will be operating is between 0 and 40°C (32 and 104°F) Gather Supplied and Requ
Ambit U10C012, User’s Guide 28 • If you are using a cable splitter, try removing the splitter and connect the cable modem directly to the cable wall outlet. Wait several minutes for the cable modem to re-establish communications with your cable service provider. • Your Ethernet or coaxial cable may be damaged. Try using another cable. • If none of these suggestions work, contact your cable service provider for further assistance.
Ambit U10C012, User’s Guide 31 5. Web User Interface Accessing the Web User Interface 1. The PC connected to the cable modem must support TCP/IP connection and dynamic DHCP IP address acquisition, and must have a web browser installed. 2. Open the web browser and set the URL location as: http://192.168.100.1 3. Click LOGIN. Enter user for User name and user for Password, and then click OK.
User’s Guide 13 7. If the above screen appears, you must insert the Windows 98 CD so that Windows can copy the remaining files. 8. After files copying is done, you will see the following screen: 9. Click Finish to complete the installation. You will see the following screen.
Ambit U10C012, User’s Guide 46 Uncheck “Enable” to disable ActiveX filter. • Filter Popup Windows Check “Enable” to enable Popup Windows filter. Uncheck “Enable” to disable Popup Windows filter • Block Fragmented IP Packets Check “Enable” to enable blocking Fragmented IP Packets. Uncheck “Enable” to disable blocking Fragmented IP Packets. "With this feature enabled, all packets are checked to determine if the packet contains a "fragment" flag. If the flag exists, the CM will discard the packet. This feature is used primarily to protec
Ambit U10C012, User’s Guide 51 Tools Ping This page provides ping diagnostics to help with IP connectivity problems. Tools - Ping • Ping Target Specify target IP address. • Start Test Click to start ping test. • Ping Size Specify ping packet size in bytes. • Abort Test Click to abort ping test. • No. of Pings Specify number of pings. • Clear Results Click to clear result messages. • Ping Interval Specify interval between pings in ms. • Refresh Click “Refresh” to get updated results.
Ambit U10C012, User’s Guide 4 1. Before You Begin Your new cable modem provides high-speed access to the Internet by an active Internet Connection through your cable service provider. This user guide describes how to set up and use the cable modem. Before installing the cable modem, you should read this user guide to ensure proper cable modem operation. Understand the Cable Modem’s Features Your cable modem has the following features to help you access and use the Internet: • Tw
Ambit U10C012, User’s Guide 11 4. Check the CD-ROM drive check box and verify that the CD is in the CD-ROM drive. Click Next to have Windows search for the necessary driver files. You will see the following: 5. Select the updated driver (Recommended) Ambit USB Cable Modem and click next. You will see the following screen.
Ambit U10C012, User’s Guide 48 Content Filter Setup This page allows configuration of URL content filter rules. Content Filter – Setup • URL Keyword Blocking Check “Enable” to enable URL Keyword Blocking. Uncheck “Enable” to disable URL Keyword Blocking. • URL Domain Blocking Check “Enable” to enable URL Domain Blocking. Uncheck “Enable” to disable URL Domain Blocking. • Add Keyword Specify Keyword and click “Add Keywork” to add keyword to the list. • Remove Keyword Select Keyword from the list and click “Remove Keywork” to delete keyword from the list. • Add Domain Specify Domain and click “Add Do
Ambit U10C012, User’s Guide 27 properly. Troubleshooting the Ethernet Installation None of the LEDs are on when I power on the Cable Modem. Check the connection between the power adapter and the cable modem. Power off the Cable Modem and wait for 5 seconds and power on the modem again. If the problem still exists, you may have a hardware problem. The Ethernet 1/2/3/4 LED on my cable modem is not lit. • Try restarting the computer so that is could re-establish a connection with t
Ambit U10C012, User’s Guide 40 Gateway Information This page shows gateway information. Gateway Information • Refresh Click “Refresh” to get current gateway information. • Connected Computers Click “Connected Computers” to show computers attached to the cable modem.
User’s Guide 15 Installing the Software Drivers in Windows Me Operating System To install the cable modem software drivers using the Windows Me operating system: 1. Power on your PC. After your computer boots, Windows detects the cable modem. The Found New Hardware screen appears, followed by the Found New Hardware Wizard screen. 2. I
Ambit U10C012, User’s Guide 22 Installing the Software Drivers in Windows XP Operating System 1. Power on your PC. After your computer boots, Windows detects the cable modem. The Found New Hardware screen appears, followed by the Found New Hardware Wizard screen. 2. Choose the software automatically (Recommended). Click Next to continue. You will see the following screen.
User’s Guide 6 Be sure to follow the instructions provided for the port that you want to use. Using the USB port allows you to install the cable modem more quickly and easily than using the Ethernet port, because you do not have to install and configure a network interface card (NIC). USB, however, only enable
User’s Guide 2 Contents 1. BEFORE YOU BEGIN ...........................................................................................................4 Understand the Cable Modem’s Features ....................................................................................................... 4 Contact Your Local Cable Operator
Grandstream Networks GXW40XX Modem Quick installation manual
GXW40XX |
Oman Mobile E180 Modem Operation & user’s manual
E180 |
Aztech HL110EW Modem Easy start manual
HL110EW |
Ambit U10C007 Modem Operation & user’s manual
U10C007 |
Ambit U10C011 Modem Operation & user’s manual
U10C011 |
Ambit U10C018 Modem Operation & user’s manual
U10C018 |
Aztech DSL Turbo 900 Package Modem Operation & user’s manual
DSL Turbo 900 Package |
Ambit U10C017 Modem Operation & user’s manual
U10C017 |
# | Manufacturer | Model | Document Type | File | Updated | Pages | Size |
---|---|---|---|---|---|---|---|
1 | Lexmark | 19C0050 - C 752Ln Color Laser Printer | Service manual | lexmark/19c0050-c-752ln-color-laser-printer-7MO.pdf | 07 Oct 2023 | 10 | |
2 | Dometic | RM 7601 L | Operating and installation instructions | dometic/rm-7601-l-36M.pdf | 29 Nov 2022 | 30 | 0.4 Mb |
3 | NESTLE | NESCAFÉ Solution 8/60 | Operation manual | nestle/nescafe-solution-860-LWH.pdf | 07 Jan 2024 | 16 | |
4 | LG | 29FX6ALX | Service manual | lg/29fx6alx-DOH.pdf | 29 Nov 2022 | 29 | |
5 | Homak | BL08018070 | Owner's and operator's manual | homak/bl08018070-W4S.pdf | 07 Feb 2023 | 12 | |
6 | Kodak | EASYSHARE TOUCH M5370 | Extended user manual | kodak/easyshare-touch-m5370-2LX.pdf | 07 Jun 2023 | 81 |
Digi
Digi XBee3 Cellular LTE-M Cellular Module Patch and Maintenance Release via EasyFlash Firmware Update90002353_C1Digi XBee3 Cellular LTE-M Cellular Module Patch andMaintenance Release via EasyFlash FirmwareUpdateThis document describes how to update the cellular modem firmware of the XBee3 Cellular LTE-Mmodule using EasyFlash and the XBIB-CU-TH development bo …
XBee3(6 pages) |
NETGEAR
)NSTALLATION'UIDEMobile Broadband Modem MBM621RequirementsBefore installation, make sure that these requirements are met:• You must have an account for wireless broadband service, and you must be located in an area with wireless broadband coverage. Check with your Internet Service Provider (ISP) if you are not sure.• You need an activated SIM car …
MBM621 - 3G HSDPA Ethernet Modem(2 pages) |
Baer
UniMod 01/I Modem Operation Manual E121801419062 Baer Energie- & Messtechnik GmbH Siemensstr. 3 D-90766 Fürth Germany Phone: +49 (0)911 970590 Fax: +49 (0)911 9705950 Internet: www.baer-gmbh.com
…
UniMod 01/I(16 pages) |
Pacific Crest
510DeGuigneDrive•Sunnyvale,CA94085•+1.408.481.8070•+1.408.481.8984(Fax)www.PacificCrest.comFebruary2010P/N:M0082103ADLVantageGettingStartedGuide SetupintheOffice1. PlugtheADLVantagepowersupplycableintothetransformerandthenintothewall. …
ADL Vantage(2 pages) |
3 Com U.S. Robotics
part number 1.024.2088-01READMEFIRST!3Com U.S. RoboticsISDN Pro TAInstallation Guidefor Windows®and Macintosh®5Install the driver software.4Connect the power supply to the TA.Plug the power supply block into your wall socket. Then plug the power supply cablewith the single round end into the back of your TA. NOTE: Use only the power supplysupplied with yo …
ISDN Pro TA(1 pages) |
ZyXEL Communications
www.zyxel.comwww.zyxel.comP-660HN FxZ Series802.11n Wireless ADSL2+ 4-port GatewayCopyright © 2010 ZyXEL Communications CorporationFirmware Version 3.7Edition 2, 10/2010Default Login DetailsIP Address http://192.168.1.1Admin Password1234User Passworduser
…
P-660HN FxZ(421 pages) |
Impex Fitness Equipment MARCY SM-4008Instructions manual for Impex MARCY SM-4008 Fitness Equipment MARCY SM-4008, 38 |
Makita Grinder GE0600User Guide: Makita GE0600 (P851MR, Upd.Tue 10.2023) GE0600, 12 |
Frigidaire Dryer FER311FFrigidaire Dryer FER311F Operating instructions FER311F, 4 |
Akura Stereo System APTCDC9903ARGuide: Akura APTCDC9903AR (7EHKH5, Upd.18th Dec 2023) APTCDC9903AR, 11 |
AmpliVox Lectern System Expediter W330Lectern System PDF Specifications Expediter W330, 2 |
Barco Monitor Nio 5MPBarco Monitor Nio 5MP Installation and user manual Nio 5MP, 99 |
Viqua Water Filtration Systems S2Q-OZViqua S2Q-OZ Water Filtration Systems Owner's manual S2Q-OZ, 18 |
Nxg Speakers PRO 5520CLR#818X1T PRO 5520CLR: Nxg Speakers Owner Documentation PRO 5520CLR, 2 |
Datamax Barcode Reader I-ClassDatamax I-Class Barcode Reader Operation & user’s manual I-Class, 14 |
Ummagawd Drones AcrobratAcrobrat (Drones ePDF Manual, #6J4AIV) Acrobrat, 4 |
Morso Indoor Fireplace 5660 Standard InsertManual: Morso 5660 Standard Insert (H46Y68, Upd.Tuesday 28-11-2023) 5660 Standard Insert, 24 |
Weber Burner GENESIS 1000 LXWeber Burner GENESIS 1000 LX Owner's manual GENESIS 1000 LX, 36 |