Citron MTIR-FR02-V1 Operating Manual
|
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 2 Document Rev. Rev. Description Author Date 001 First issue TTHA 2011-02-17 Disclaimer The contents of this manual are for information purposes only. Citron GmbH reserves the right to change the contents of this manual without prior notice. While reasonable efforts have been made in the preparation of this manual to assure its accuracy, errors may occur. Therefore, Citron GmbH assumes no liability resulting from errors or omissions in this manual or from the
MULTI-TOUCH-MONITOR MTIR-FR02-V1 3 Contents Introduction ..................................................................................................................................................................... 4 1 Precautions............................................................................................................
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 4 Introduction The MTIR-FR02-V1 Multi-Touch-Monitor is comprised of a 32 inch Multi-Touch frame made by Citron GmbH, Germany mounted on an LCD-monitor PD-CP32AH made by Canvys, Germany. This operating manual describes the set-up of the Multi-Touch-Frame. For all other aspects reference the original manual of PD-CP32AH LCD screen WARRANTY AND ALL WARRANTY CLAIMS ARE VOID IF INSTRUCTIONS IN THIS MANUAL ARE NOT OBEYED.
Citron MTIR-FR02-V1, MULTI-TOUCH-MONITOR MTIR-FR02-V1 5 1 Precautions Please carefully read these instructions before you start. Failure to follow these instructions may result in damage or personal injury 1.1. General Safety · The unit must be set-up by authorized and qualified personnel only. · Always obey relevant local safety regulations. · Setting up should be performed by two persons. · MTIR-FR02-V1 Multi-Touch-Monitor should only be used with the specified input voltage conditions (see section 7.1) · Use only with suitably earthed mains sockets · Any extension leads used should be of a suitable specification and suitably earth
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 6 2 Package Contents The cardboard box containing your new Multi-Touch-Monitor contains the following parts: Contents Qty Multi-Touch-Monitor MITR-FR02-V1 1 Front bezel 1 Accessories kit: DVI Cable 1 Power lead 1 USB Cable A/B 1 Magnetic Tape 85 cm 2 Magnetic Tape 54 cm 2
Citron MTIR-FR02-V1, MULTI-TOUCH-MONITOR MTIR-FR02-V1 7 3 Installation The following guidance must be observed when mounting the device. Failure to do so may result in breakage or damage to the unit. No warranty claims are accepted for damages caused by not following these instructions · When mounting the multi-touch-monitor care should be taken not to obstruct the cooling air ventilation of the monitor. Ventilation openings must be kept clear. Environmental conditions as given in the Technical Data section of this manual should not be exceeded. · Do not expose the multi-touch-monitor to direct sun light. Otherwise the LCD might overheat. · Do not mount the multi-touch-
BETRIEBSANLEITUNG 8 3.2 Setting Up 1. Switch the main power switch “ON” Main Power Switch S E L E C T M E N U P O W E R Operating-LED Power Key 2. Start your computer 3 The Multi-Touch-Monitor is switched ON/OFF using the power key. Regular operation is indicated by a steady green light. If there is no video input
Citron MTIR-FR02-V1, MULTI-TOUCH-MONITOR MTIR-FR02-V1 9 4 Operating the OSD 4.1 OSD-Operating-Keys (On-Screen-Display-Menue) OSD-Menu Keys are located on the back of the Multi-Touch-Monitor. The keys have the following functionality: S E L E C T M E N U P O W E R Taste Funktion MENU open main-menu Leave sub-menu / main-menu and save settings Sub-menu selection / Decrease values Sub-menu selection / Increase values SELECT Select function POWER Switch device between stand-by and operation (only when OSD inactive) The device is switched off/on using the “POWE
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 10 4.2.2 Image Adjustments Within the main-menu item “Image Adjustments“ you can control image settings like brightness, contrast, etc. Brightness Use ▲▼-keys to adjust brightness Contrast Use ▲▼-keys to adjust contrast Backlight Use ▲▼-keys to adjust backlight brightness Backlight mode Valid only with ambient light sensor 4.2.3 Color Adjustments Within the main-menu item “Colour Adjustments“ you can control colour settings like colour temperature etc Autom. Colour Adjust Automatic Adjustment of colour parameters Switch sRGB Simulates a CRT´s color space
Citron MTIR-FR02-V1, MULTI-TOUCH-MONITOR MTIR-FR02-V1 11 5 Cleaning CAUTION: Disconnect the Multi-Touch-Monitor from power supply before cleaning. Wait until all parts are completely dried before re-connecting power. 5.1 Cleaning of Monitor Parts Clean the monitor surface using a dampened cloth. Take care that no liquid enters the device. Clean the device surfaces with a smooth, non scratching lint-free cloth. Do not use any cleaning agents or paper towels. 5.2 Cleaning of Glass Window To clean the glass window commercially available glass cleaning agents may be used. Clean the device surfaces with a clean, soft, non-scratching, lint-free cloth. CAUTION:
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 12 6 Trouble-shooting Error Reason Corrective Operating LED is off - Main power switch is off - No power supply - Switch on main switch - Check power chord - Check wall plug No image - cabling is missing or faulty - Main power switch is off - Monitor in stand-by mode - Wrong input channel selected - Image is not visible - No video input - Check DVI or VGA cable - Check power chord - Switch on main switch - Switch on using „power“-key - Use OSD to select other input channel - Use OSD to adjust brightness and contrast
MULTI-TOUCH-MONITOR MTIR-FR02-V1 13 video cards is supported by monitor. Touch is not working - Some cabling is missing or loose. - Monitor has switched off automatically - Driver is not installed correctly - Check USB connection at the monitor. - Check USB connection at the PC - Remove USB cable for about 10 seconds and plug it in again - Reinsta
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 14 7 Technical Data 7.1 Electrical Power Supply: 100 – 240V AC, 50 / 60Hz Current Consumption: 4 A max. Monitor Interface: Single Link DVI, analog VGA Touch Interface: USB1.1 (full speed) 7.2 LCD Screen Panel Type: AU Optronics Colour TFT LCD Panel Display Size: 32 “ / 80,1cm Resolution: max. 1920 x 1080, max. 85Hz Colours: 16,2 Mio. (8 Bit) 7.3 Touch Function Number of simultaneous touch points: Up to 32 Size of touch point > 8 mm Resolution: < 2 mm Supported Operating Systems: Microsoft ® Windows XP ® to Microsoft Windo
Citron MTIR-FR02-V1, BETRIEBSANLEITUNG 16 MULTI-TOUCH-MONITOR MTIRFR02- V 1 Citron GmbH A nwaltinger Str. 14 D - 86165 Augsburg Telefon +49 (0)821 / 7 49 45 - 0 Fax +49 (0)821 / 7 49 45 – 99 [email protected] // www. citron.de
Barco Color Coronis 2MP Monitor Supplementary manual
Color Coronis 2MP |
Sony HMZ-T3W Monitor Reference manual
HMZ-T3W |
Samsung 957D Monitor Owner's manual
957D |
Sony PFM-32C1 Monitor Supplement sheet
PFM-32C1 |
Samsung 510MP Monitor Manual del usuario
510MP |
Tote Vision LCD-800 Monitor Specification sheet
LCD-800 |
ViewSonic Q2162WB - Optiquest - 21.6" LCD Monitor Monitor Specification
Q2162WB - Optiquest - 21.6" LCD Monitor |
Roland RSM-90 Monitor Owner's manual
RSM-90 |
# | Manufacturer | Model | Document Type | File | Updated | Pages | Size |
---|---|---|---|---|---|---|---|
1 | Oster | Hinged Lid Electric Skillet | Operation & user’s manual | oster/hinged-lid-electric-skillet-NGR.pdf | 20 Oct 2022 | 12 | |
2 | Toastmaster | TPC3 | Use and care manual | toastmaster/tpc3-2I5.pdf | 02 Jan 2024 | 10 | 0.33 Mb |
3 | Supermicro | SSE-G24-TG4 | Configuration manual | supermicro/sse-g24-tg4-6H2.pdf | 29 Jan 2024 | 31 | |
4 | Simrad | RD68 | Service manual | simrad/rd68-N4H.pdf | 22 Jul 2023 | 66 | 2.27 Mb |
5 | Last Calor | Alba | Installation, use and maintenance manual | last-calor/alba-O57.pdf | 21 Sep 2023 | 109 | |
6 | NETGEAR | WAC120 | Installation manual | netgear/wac120-7V1.pdf | 10 Mar 2024 | 14 |
Prismasonic
Video ScreenCinoscreen F-100 / F-AT100A Picture to RememberAssembly InstructionsINSTALLATION INSTRUCTIONSCarefully remove and unwrap all the contents of box. Referring to the parts list, make sure you have everything needed to proceed with the installation of the screen. If any parts are missing, contact Prismasonic immediately.Inspect the screen to make sur …
Cinoscreen F-100(4 pages) |
Motrona
control – motion – interfacemotrona GmbHZwischen den Wegen 3278239 Rielasingen - GermanyTel. +49 (0)7731-9332-0Fax +49 (0)[email protected]_e.doc / Jan-13 Page 1 / 36DZ 270, 271, 276, 277, 279Universal Monitors for Speed,Standstill, Direction of RotationDZ270: Monitor with 3 programmable output relays and 1 analogue outp …
DZ 270(36 pages) |
Acer
1 WARNING............................................................................................................................2 1. ALGNMENT PROCEDURE.............................................................................................3 A. Conditions............................................................................................... …
AC501(107 pages) |
ViewSonic
Optiquest displays.For exceptional value and superior quality in adesktop display, look to the Optiquest line ofLCD and CRT displays. Integrators appreciateOptiquest’s price/performance advantage forbusiness and home systems. With clear textand rich colors, easy-to-use features and arange of sizes, there’s a display for everyapplication. Backed by a thre …
Optiquest Q170b(1 pages) |
LG
PLASMA MONITOROWNER’S MANUALPlease read this manual carefully and completely before operating your Monitor. Retain this manual for future reference.Record model number and serial number of the Monitor in thespaces provided below. See the label attached on the back cover and relate this infor-mation to your dealer if you require service.Model Number : Seria …
42PM1M - - 42" Plasma Panel(44 pages) |
Elo TouchSystems
1900L 19” LCD Wide-Aspect TouchmonitorElegant design and high-definition performance with “Zero-Bezel” APR touch technologyThe 1900L is one of the first wide-aspect ratio touchmonitors with a virtually 100-percent useable surfacearea.The unique “zero-bezel” design removes the frame,or bezel, of standard monitors to create a seamless glasssurface th …
Elo 1900L(2 pages) |
Bosch Cooktop HCE744250RCooktop PDF Instruction manual HCE744250R, 72 |
Repotec IP Camera RP-VP0643Repotec RP-VP0643 IP Camera Operation & user’s manual RP-VP0643, 81 |
Kramer Receiver TP-200TP-200 Operation & user’s manual - O55LS5 TP-200, 12 |
Ankuoo Switch NEO PROAnkuoo Switch NEO PRO Operation & user’s manual NEO PRO, 6 |
enphase Gateway GatewayManual: enphase Gateway (8UY768, Upd.19.10.2023) Gateway, 2 |
Kaivac Vacuum Cleaner 1200 SeriesKaivac 1200 Series Vacuum Cleaner Operator and parts manual 1200 Series, 31 |
ProForm Home Gym C 840User Guide: ProForm C 840 (6I6P27, Upd.02/10/2023) C 840, 34 |
Chef Pro Grinder CPG501Owner's manual for Chef Pro CPG501 Grinder CPG501, 12 |
Heath Zenith Work Light SL-5210Heath Zenith SL-5210 Work Light Owner's manual SL-5210, 12 |
Beko Refrigerator GNE 134621 XBeko GNE 134621 X User Manual (Manual ), @8614ZY GNE 134621 X, 98 |
SWEEX Other IA120Other PDF Manual IA120, 9 |
Uniden Recording Equipment iGO CAM 850#522SU1: iGO CAM 850 Recording Equipment Owner's manual iGO CAM 850, 20 |