Gentex 7000 Series Installation Instructions Manual

Text of Gentex 7000 Series User Guide:

• Gentex 7000 Series, Installation Instructions - Owner's/User’s Information Manual -READ CAREFULLY AND SAVE 7000 SERIES PHOTOELECTRIC TYPE SINGLE STATION/MULTI-STATION SMOKE ALARMS/AC POWERED, 120VAC, 60Hz OR 220VAC, 50/60Hz INTRODUCTION 7000 SERIES The 7103 & 7203 Series smoke alarm is a photoelectric type alarm for use as an evacuation device in residential and commercial residential applications, while the 7100 & 7200 are for use as an alert and relocate device. Each smoke alarm has a solid state piezo signal to warn and alert the household to the pres

• Gentex 7000 Series, c. Develop a family escape plan and practice it with your entire family, especially small children.  Draw and post a floor plan of your home and find two ways to exit from each room. There should be one way to get out of each bed- room without opening the door.  Teach children what the smoke alarm signal means, and that they must be prepared to leave the residence by themselves if necessary. Show them how to check to see if doors are hot before opening them, how to stay close to the floor and crawl if necessary, and how to use the alternate exit if the door is hot and should not be opened.  Decide on a meeting place a safe distanc

• Gentex 7000 Series, Figure 5: RECOMMENDED SMOKE ALARM MOUNTING LOCATIONS. IMPORTANT CONSIDERATION NFPA 72, 2010 Edition, Chapter 29, Section 29.8.1.4(5)(b) states: “Smoke alarms installed in one- and two-family dwellings shall not remain in service longer than 10 years from the date of manufacture.” Smoke alarms should be replaced for the following reasons:  Dust, dirt, and other environmental contaminants can affect your smoke alarm over a prolonged period.  Fast changing industry consensus standards and codes on all devices make it advisable to periodically upgrade your smoke alarm to maximize life safety.  Assurance that

• Gentex 7000 Series, Figure 6: RECOMMENDED SMOKE ALARM LOCATION IN ROOMS WITH SLOPED, GABLED, OR PEAKED CEILINGS. The placement of the smoke alarm is critical if maximum speed of fire detection is desired. Thus, a logical location for a smoke alarm is the center of the ceiling. At this location, the device is closest to all areas of the room. WHERE SMOKE ALARMS SHOULD BE INSTALLED IN MOBILE HOMES In mobile homes built after about 1978 that were designed and insulated to be energy-efficient, smoke alarms should be installed as described in the section above. In older mobile homes that have little or no insulation compared to today's standards, uninsulated metal out- side walls an

• Gentex 7000 Series, WIRING TWO OR MORE SMOKE ALARMS Tandem Installation NOTICE: All smoke alarms in a tandem installation must be controlled by the same fuse or circuit breaker. Otherwise tandem units will not operate. LIMITATIONS: A maximum of 12 smoke alarms ("7100/ 7103" or "7200/7203") may be connected together. Do not exceed 125 feet between each smoke alarm. Do not exceed 1125 feet between first and last smoke alarm. NOTICE: A maximum of six (6) smoke alarms of either model 7100/7103 or 7200/7203 with the relay options (F) may be tandem interconnected. Wire used for interconnecting sh

• GENTEX CORPORATION 10985 CHICAGO DRIVE, ZEELAND, MI 49464 PHONE: 1-800-436-8391 www.gentex.com 550-0071-ZAB 6-1-89 Important Notice: These materials have been prepared by Gentex Corporation ("Gentex") for informational purposes only, are necessarily summary, and are not purported to serve as legal advice and should not be used as such. Gentex makes no representations and war

Related Products and Documents (Smoke Alarm):

Comparable Devices:

Similar Resources:

• Johnson Controls IR6003/7 (6 pages) IR Oil Mist/Smoke DetectorFeatures• AutomaticSelfCalibration• Range=2-30metres• WeatherprooftoIP65• CertifiedIntrinsicallySafeEExibIIBT5• RobustDesign• HeavyDutyMountingBracketavailable• Independentbeamblockedoutput• Cleaningstatusoutput• Dual …

• First Alert SA302 (6 pages) USER’S MANUALSMOKE ALARMWITH REMOTE CONTROL FEATURESModel SA302M08-0071-004 D 05/07 Printed in MexicoIMPORTANT! PLEASE READ CAREFULLY AND SAVE.This user’s manual contains important information about your Smoke Alarm’s operation. If you are installing this Smoke Alarm for use byothers, you must leave this manual—or a copy of it—with the end user …

• Fire-Lite MS-2410BC (64 pages) MS-2410BC ConventionalFire Alarm Control Panel Programming, Installation, Maintenance and Operating Instruction Manual24 Viceroy RoadUnit #6 & 7Concord, Ontario L4K2L9 Phone (905) 660-7210 FAX: (905) 660-7204 P/N 50801:B ECN 98-380BDocument #50801 8/17/98 Rev.© 1998 Fire� …

• EiProfessional Ei168 (20 pages) Model: Ei168User Manualfor use withSmoke & Heat AlarmsContains vital information on the products operation and installation. Readand retain carefully. If you are just installing this product the manualMUST be given to the householder.BASE …

• Kidde 1296 (2 pages) UTHA / UTGT CompliantSmoke Alarm• Model 1296DescriptionThe Kidde 1296E is a 120VAC direct wire-in smoke alarmoffering a level of protection that you have come toexpect in a Kidde product. The Kidde 1296E is designed toalert you and your family from the dangers of smoke andfire. This smoke alarm utilizes an ionization sensor. (Formaximum protection Kidde r …

• NTI ENVIROMUX Series (9 pages) MAN215 Rev Date 1/19/2016 Temperature/Humidity Sensor Installation Manual ENVIROMUX® Series ENVIROMUX-STHS-LCD Temperature/Humidity sensors ENVIROMUX-STHS-N4085IND Temperature/Humidity sensor ENVIROMUX-STHSB Temperature/Humidity Sensor ENVIROMUX-STS …

Comments, Questions and Opinions: