Holme HWM51000H Instruction Manual

Text of Holme HWM51000H User Guide:

• Holme HWM51000H, Care Chart Resistant Material Bleachable in Cold Water Do Not Dry Clean Delicate Fabric Do Not Bleach Dry Flat Wash at 95 Iron at 200 Hang Dry Wash at 60 Iron at 150 Dry On Clothes Hanger Wash at 40 Iron at 100 Tumble Dry (Normal Heat) Wash at 30 Do Not Iron Tumble Dry (Low Heat) Hand Wash Do Not Tumble Dry Dry Clean Only Wool Seal Load guide Bed Sheet (Single) Cotton Approximately 800g Blanket Wool Approx

• Holme HWM51000H, Cleaning and Care Before cleaning Cleaning the detergent drawer Cleaning the machine Cleaning the filter Ensure the machine is unplugged and the water supply has been turned off in order to avoid electric shock and water damage. It is important to clean the detergent distribution drawer regularly. Pull out the draw gently until it is completely removed and clean with water. Replace the draw gently after cleaning. Use a soft damp cloth with soap and water to clean the outside of the machine and its rubber components. Do not use corrosive chemicals or bleach as these may damage the outside of the machine

• Holme HWM51000H, Washing Methods Please note Power Supply Water Connection Preparing your laundry This washing machine is for domestic use only. If the machine is used for commercial purposes the guarantee will be rendered void. Do not use this machine for purposes other than that for which it was designed. Follow the instructions given on the label of each garment and wash only machine washable garments. Connect the washing machine to the power supply (220V to 240V~/50Hz) Turn on the tap and ensure a connection to cold, fresh water. Before use, check

• Holme HWM51000H, Program Selection Use this table as a guide to selecting the most appropriate washing program for your garments. Program Temperature Recommended Laundry Spin speed 1 Cotton Prewash 60°C Very Heavy Soiling 1000 rpm 2 90°C 90°C Heavy Soiling 1000 rpm 3 60°C 60°C Soiled Cotton 1000 rpm 4 40°C 40°C Colour-fast and medium soiling 1000 rpm 5 Quick 40°C Medium Soiling 1000 rpm 6 Synthetic 30°C 30°C Colour-fast heavy soiled synthetics 1000 rpm 7 Cold / Non colour - fast and medium soiled synthetics 1000 rpm 8

• Holme HWM51000H, Connecting the Inlet Hose Drain Hose For Customer Services, Spare Parts & Manufacturer’s Guarantee Information please call 01204 664 084 -9- 1. Connect the inlet hose to the connector on the water inlet valve on the back of the appliance – see fig 2.0 2. Apply the other end of the inlet hose to a tap runs cold, fresh water – see fig 2.1. Note: The hose supplied this this appliance should be used. Do not reuse an old inlet hose. 1. Use the drain hose bracket supplied, to keep the end of the drain hose secured in the outflow pipe – see fig 3.0. Do not extend the length of the drain hose – if a longer hose is required conta

• Holme HWM51000H, Unpacking your machine Remove all the packing materials including the polystyrene base to ensure the machine is level and stable. When opening the packaging you may notice droplets of water have gathered on the plastic bag and porthole. This is normal and is the result of water tests in the factory. Your machine This diagram may be slightly different from the machine that you have purchased. This is due to technical improvements. For Customer Services, Spare Parts & Manufacturer’s Guarantee Information please call 01204 664 084 -5- Control Panel Door Handle Washer Door Detergent D

• Holme HWM51000H, Cleaning the water inlet valve Moving the machine Long periods of disuse To prevent blockage to the water supply from foreign objects, ensure the water inlet valve and inlet valve filter are cleaned regularly. Before moving the machine, ensure that the transportation bolts have been replaced in order to protect the drum from damage. To replace the bolts, take the following steps: 1. Remove the blanking plugs. 2. Remove the back cover. 3. Insert the synthetic stabilisers and the transportation bolts. Tighten with a spanner. 4. Replace the back cover. If the washing machine is left idle f

• Holme HWM51000H, Washing Machine Instruction Manual Please read these instructions carefully and keep them for future reference Model Number: HWM51000H For Customer Services, Spare Parts & Manufacturers Guarantee Information, please call 01204 664 084 Opening times: Monday – Friday 9am – 5pm

• Holme HWM51000H, Control Panel A - Detergent Drawer The drawer contains three compartments: B – Power Button Press this button to switch on the washing machine. Press and hold for 2 seconds to switch the machine off. C - Program Knob By turning the knob either clockwise or anti-clockwise, the required program can be selected. For Customer Services, Spare Parts & Manufacturer’s Guarantee Information please call 01204 664 084 -10- A. Detergent drawer B. Power Button C. Program Knob D. Spin Speed Button E. Intense Button F. Start/Pause Button 1. Main wash detergent 2. Fabric softener 3. Prewash detergent A

• Holme HWM51000H, Selecting Spin Speed Intensity setting Start a washing cycle After washing Energy saving - Always wash a full load. - Do not overload the machine. - Only use a prewash setting for heavily soiled items. - Reduce the amount of detergent used. Refer to the detergent packet for advice on measurements. - Wash on a low temperature. Most modern detergents are designed to function fully with this in mind. Press the ‘speed’ button lightly to select the desire speed. When a speed is set, the adjacent light will be illuminated. For an intensive wash, first select the require

• Holme HWM51000H, Problem solving Problem Causes Solution Err1: The start indicator will not light and the buzzer sound abnormally. - Door is not properly shut - Shut the door properly Err2: The start indicator flashed on for 0.2 seconds and on for 0.2 seconds twice, and is then repeated 4 seconds later. - Drainage error - water not emptied within 4 minutes - Clean the filter and check the drain hose for blockage. If an error still exists, contact the customer service helpline. Err3: The start indicator fla

• Holme HWM51000H, Selecting detergent ............................................................................................... 15 Adding detergent .................................................................................................. 15 Selecting a program .............................................................................................. 15 Selecting Spin Speed ........................................................................................... 15 Intensity setting ...................................................

• Holme HWM51000H, Using the machine Loading the machine Selecting detergent Adding detergent Selecting a program - When first using the machine, it is important to let it run unloaded, using detergent at 60°C for one cycle. This will ensure the inside of the machine is clean. - Open the door of the washer and place garments inside piece by piece. Close the door tightly. - Do not overload the washing machine. - The washing efficiency and the performance is determined by the quality of the detergent used. Biological washing powder can often deliver the best results. - When washing synthetic and woollen go

• Holme HWM51000H, During Use When using your appliance, ensure that you do not: - Touch or use the appliance with wet or damp hands or when barefooted. This can lead to electric shock. - Use flammable detergent or dry cleaning agent. - Use any flammable sprays in close vicinity to the appliance. - Remove or insert the plug in the presence of inflammable gas. - Allow children or inform persons to play with the appliance or packing materials. - Install the appliance outdoors in a damp place, or in an

• Holme HWM51000H, Contents Before using your machine ..................................................................................... 4 Components ........................................................................................................... 4 Accessories ............................................................................................................ 4 Unpacking your machine ........................................................................................ 5 Your machine ....................................................................

• Before using your machine Components Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the most out of your appliance and ensure safe and proper installation, use and maintenance. Keep this manual in a convenient place so that you can refer to it and ensure safe and proper u

• There are 9 programs available. After a program is selected, the corresponding light will be illuminated. D - Spin Speed Button Touch this button lightly to select the desired speed. When a speed is set, the indicator light will be illuminated. E – Intense Button Press this button and the indicator light will illuminate. This will increase the washing time and

• For manufacturer’s guarantee, customer services, spare parts and information please call: 01204 664 084 Opening times: Monday - Friday 9am until 5pm Revision 5 This symbol is known as the 'Crossed-out wheelie bin Symbol'. W hen this symbol is marked on a product/batteries, it means that the product/batteries should not be disposed of with your g

• Holme HWM51000H, Maintenance Problem Causes Solution Appliance fails to operate - Poor connection to power supply - Power failure The door is not properly closed Machine has not been switched off - Check connection to power supply -Check the power supply works -Close the door -Make sure the machine is switched on Washing machine cannot be filled with water - The "Start/Pause" button has not been pressed - The water tap is turned off - Water pressure is less than 0,03MPa - The inlet hose is obstructed - The water supply has failed -The program has not been set - The washer door is open - The inlet hose

• Holme HWM51000H, Safety Instructions Before Use - Do not use any type of mains extension cable. - Do not plug in damaged or torn plugs. - Make sure that the transport bolts are removed. - Use a separate earthed socket for the power supply. - Make sure that the plug is accessible and not obstructed by the washing machine or any other appliance. - After user, unplug the machine by gripping the plug – do not pull the cable in an attempt to unplug the machine. - Make sure the fuses in the power circuit are rated at 15a. - Keep away from heat sources and direct sunlight to prevent plastic and rubber components from aging. - Make sure that the power

Related Products and Documents (Washer):

Comparable Devices:

Similar Resources:

• DAEWOO ELECTRONICS DWDHQ1421D (34 pages) A NOTE TO YOUThank you for buying a DAEWOO appliance.DAEWOO washers are easy to use, save time, and help you manage your home better.This manual contains valuable information about how to operate and maintain your washer properly and safely.Please read it carefully.INSTRUCTION MANUALDWDHQ1421DWashing Machine Instruction Manual␊ Economic wash systemUsing ar …

• Miele W 5741 (68 pages) Operating instructionsfor Washing machineW 5741To avoid the risk of accidentsor damage to the machine,it is essential to read theseinstructions before it is installedand used for the first time.M.-Nr. 07 722 800en - AU, NZ …

• LG F1255FD (93 pages) DWG.No.TRIG.DR COMPLETED도면 DR 완료완료일 : LG 전자 (주)LG Electronics Inc.UNIT SCALENSmmREVIEWEDDESIGNEDRELATED DWG.CHECKED APPROVED이 성 민16.05.16이 다 정16.05.16 16.05.16 16.05.1714.11.03최 재 현김 현 석MODELINGITLETAPPROVED승인자PREPARED시방자DATE년/월/일REF. NO.시방 번호REV. NO.기호REVISION DESCRIPTION변경 …

• GE GE Energy Star WSXH208FWW (3 pages) WSXH208FWW GE® ENERGY STAR® Extra-Large 3.1 Cu. Ft. Capacity Frontload WasherDimensions and Installation Information (in inches) Circuit Requirements: An individual, properly- grounded branch circuit, with a three-prong grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse, is required.Electrical Rating: 120V, 60Hz, 1 …

• LG F1258RD (32 pages) Washing MachineOWNER'S MANUALF1258RDF1258RD9Thank you for buying aLG Fully Automatic Washing machine.Please read your owner's manual carefully, it providesinstructions on safe installation, use and maintenance.Retain it for future reference.Record the model and serial numbers of your washingmachine. …

• Winterhalter PAY PER WASH UC V02 Series (4 pages) - 1 - CONNECTED WASH Connecting the machine to the network This manual applies to the following machines with black display: UC Series (V02) PT Series (V02) CTR Series Have you already registered at www.connected-wash.com/start? Are all requirements met for CONNECTED WASH (see: http://www.connected-wash.com/faq)? Then you can connect the machine …

Comments, Questions and Opinions: