Manualios.com

Convia Type 3 Operating Instructions Manual

Convia Type 3 Manual Online:

4.05, 2658 votes
Convia Type 3 User Manual
Convia Type 3 User Guide
Convia Type 3 Online Manual

Text of Convia Type 3 User Guide:

  • Convia Type 3, Wireless Smoke Detector (Type 3) Operating Instructions Version 1.0 For Marmitek alarm installations of the types: Homeguard MS8000, Security System MS9470, Security System MS9770, Protector28 Security System Base Station SC2700, SC2800

  • Convia Type 3, Page 2 of 12 Please read these instructions fully and completely before initial commissioning; they contain information for the correct installation of this innovative radio smoke alarm. © 2003 Convia GmbH, Germany All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. This handbook may co

  • Page 3 of 12 Table of contents: Chapter: Page: 1. General and function......................................................................4 2. Intended use ................................................................................4 3. Safety- and maintenance- references................................................5 4. Installation pla

  • Convia Type 3, Page 4 of 12 1. General and function The optical smoke alarm is available as an optional extra for the Marmitek security systems of the types: Homeguard MS8000, security system MS9470, security system MS9770, Marmitek security system base station SC2700 and SC2800. It can detect incipient low temperature fires and open fires with smoke development and should be in installed every room. The smoke detector operates according to the dispersed light principle. For this a light transmitter and receiver are arranged in a measuring chamber in such a way that the transmitter light does not fall directly on the re

  • Convia Type 3, Page 5 of 12 3. Safety- and maintenance- references • Never open the equipment. It contains no parts to be waited. In the event of an error please give the smoke detector to your dealer. • Operate the equipment only in interiors and avoid the influence of dust, strong draft of air and direct sun light. • Clean the equipment with a dry linen cloth, which can be easily dampened. • Never use any kind of cleaning agents. • The system may not be kept / operated within the access range by children. It is not a toy! 4. Installation places Smoke detectors should be installed in accordance with the NFPA Standard 74 (National

  • Convia Type 3, Page 8 of 12 The smoke detector should be installed in the centre of the room, on the ceiling, or for a sloping roof at the highest point, as smoke rises and gathers in this area. This guarantees the earliest possible alarm warning. Smoke alarms should be installed in all rooms, but not directly above the cooking area in the kitchen or the bath, where dust concentrates. Ensure that the smoke detector is not installed directly on or in the vicinity of large metal objects as they can affect the radio range. 5. Installation Please follow these steps to install the Convia smoke detector: • At the place where yo

  • Convia Type 3, Page 9 of 12 • Using the two screws and plastic wall plugs (all supplied), attach the bracket to the wall. • Line up the slot of the backet and the detector. Push the detector onto the mounting bracked and turn it clockwise to fix it into place. Pull outward on the detector to make sure it is securely attached to the mounting bracket. • Do not insert the battery at this stage (9V). Please follow the steps of the next chapter before you insert the battery. • How to install the battery: • The smoke detector

  • Convia Type 3, Page 10 of 12 6. Registering the smoke detector with the base stations of the types „MS9470“, „MS9770“, „SC2700“, „SC2800“ Carry out the following steps: (Every time you press a key you hear a short confirmation beep) 1. Open the lid on the right side of the base station. 2. Set the mode switch to the INSTALL position. All indicators of occupied zones come on. 3. Place the battery (9V) in the correct polarity in the battery holder of the smoke detector. The smoke alarm sends a radio signal to the base station: The LED

  • Convia Type 3, Page 11 of 12 7. Registering the smoke detector with the base station of the type „Homeguard MS8000“ Carry out the following steps: (Every time you press a key you hear a short confirmation beep) 1. Open the lid of the Homeguard. 2. Key in your PIN-code (factory default: 0000). If the code is correct you will hear a longer confirmation beep. The green LED should start to flash. (Otherwise you did not key in the correct PIN-code.) 3. Press the 1 key to set the Homeguard to learning-mode. 4. Place the battery (9V) in the correct polarity in the battery holder

  • Convia Type 3, Page 12 of 12 8. Final assembly The lower section of the smoke detector is attached to the bracket already mounted on the ceiling and turned clockwise to the stop. 9. Convia smoke detector - technical data Frequency: 433,92 MHz Modulation: AM Range: 30 to 50 meters (free field) Alarm: 85 dB Power supply: 9V-Blockbattery, Alkaline-Type Operating temperature: 10 to 45 degrees (Celsius) Air moisture: < 95% rel. air moisture © 2003 Convia GmbH

Related Products and Documents (Smoke Alarm):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Wincor Nixdorf BEETLE iDOT Operating manual wincor-nixdorf/beetle-idot-1OX.pdf 07 Jul 2022 28
2 ClearSounds A1600BT Setup manual clearsounds/a1600bt-5CE.pdf 13 Sep 2023 2 1.48 Mb
3 PCE Instruments PCE-PFM 2 Operation & user’s manual pce-instruments/pce-pfm-2-85N.pdf 29 Apr 2023 16
4 VeriFone MX850 Brochure verifone/mx850-237.pdf 18 Oct 2023 2 0.48 Mb
5 Fanimation FP1620 Owner's manual fanimation/fp1620-J3H.pdf 08 Dec 2022 14 1.39 Mb
6 ProForm PRO 4500 Operation & user’s manual proform/pro-4500-HG1.pdf 18 Oct 2022 40

Similar Resources:

  • Wheelock

    MEDC XB15UL

    (4 pages)
    Technical Manual for theStrobe – XB15ULPlease note that every care has been taken to ensure the accuracy of our technical manual. We do not, however, accept responsibility for damage, loss or expense resulting from any error or omission. We reserve the rightto make alterations in line with technical advances and i …
  • NTI

    ENVIROMUX Series

    (2 pages)
    E-NLS Noise Level Sensor Installation Instruction The E-NLS noise level sensor that can be used to detect sounds and report occurrences through the user interface of an E-2D,-5D or -16D Enterprise Environment Monitoring System (SYSTEM). Connect the sensor to an available RJ45 Sensor port on a SYSTEM and configure the SYSTEM to report and send alerts …
  • no-flame

    83284

    (17 pages)
     …
  • Ei Electronics

    Ei 225E

    (6 pages)
    Open unit by sliding cover up as shown in figure 1. Thenremove the terminal block cover screw.What to do when the Alarm sounds:(1) Open the doors and windows to ventilate.(2) Turn off the appliance where possible and stop usingthe appliance.(The alarm can be silenced immediately bypushing the test/hush button if the level is below 150ppm CO).(3) Evacuate the …
  • Kidde

    PI 9000

    (2 pages)
    9 Volt Battery Operated Photo Electric/ Ionization Smoke Alarm with“HUSH” Control to temporarily silence nuisance alarms, and alarmmemory.Thank you for purchasing this smoke alarm. It is an important part ofyour family’s home safety plan. You can trust KIDDE Safety to providethe highest quality safety products. We know you expect nothing lesswhen th …
  • LST

    FWI016-1

    (1 pages)
    © LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 [email protected] • WWW.LST.AT • ALL RIGHTS RESERVEDFWI016-1_DBL_LST_EN_0804.PDF • PAGE 1ABuilding Safety. Building Security.Fire Brigade InterfaceFWI016-1DescriptionThe Fire Brigade Interface FWI016 allows for the con-nection of two …

Comments, Questions and Opinions: