Manualios.com

ASAHI Pentax K2 23602 Service Manual

ASAHI Pentax K2 23602 Manual Online:

4.05, 1252 votes
ASAHI Pentax K2 23602 User Manual
ASAHI Pentax K2 23602 User Guide
ASAHI Pentax K2 23602 Online Manual

Text of ASAHI Pentax K2 23602 User Guide:

  • ASAHI Pentax K2 23602, 23602 /131 B. Disassembly There are some parts which have to be taken off with careful treatment. 1. Top cover (A300) removal Wind lever should be set at closed position before taking off top cover. 2. Photo sensor circuit board assembly (T300) removal K2 camera is controlled with very small electric current (ex. 200pA or 300pA), therefore all electric parts should be treated carefully, especially, photo sensor circuit board; it is so sensitive that it should not be touched with bare hands. AT PREADVANCE ANGLE Fig. 2 AT CLOSED POSITION Fig. 1 Fig. 3

  • ASAHI Pentax K2 23602, 23602 /132 3. P.C. board attern assembly (T100) removal P.C. board pattern assembly (T100) can be taken out with or without removing Front Board. Pull it out hooking the large black I.C. with spring hanger. Don't touch the other I.C.s or electric parts. 4. Front board removal Front board can be removed without taking off Self-Timer lever or covering, as shown in photograph. 5. Shutter mechanism (E000) removal Shutter mechanism (E000) is so delicate and sensitive that it should not be touched with bare hands except the parts as shown in the photograph. It may cause malfunctions if handled roughly. Use finge

  • ASAHI Pentax K2 23602, 23602 /133 C. Assembly and adjustments Some parts should be assembled and adjusted. with careful treatment as shown in the following. 1. Winding stopper assembly (0-C6) 2. Winding spring (0-C23) Face the retainer screw of spring in the direction of Tripod socket, and wind the spring a little and stretch it in the direction of tripod seat. The proper tension is obtained when it is stretched around Tripod socket 3. Perforation Adjustment There are several kinds of 2nd gear (C205) which are selected to achieve the proper position of socket teeth. After removing 2nd gear, set sprocket (C9) in the correct position using the tool (23600 N-A1, C9-A) Fig. 8 Fi

  • 23602 /134 Wind up top 2nd mech. plate assembly (C200) with driver and loosen wind shaft without moving main gear. Then give back-tension to sprocket gear (C16) Choose the proper coupling 2nd gear (C205) and install it in the above-mentioned way. 4. Memory block assembly (T400) After cocking mirror housing, 02mm clearance is necessary between delrin and the longer contact piece of memoiy bl

  • ASAHI Pentax K2 23602, 23602 /135 6. Blue needle adjustment (a) Set shutter dial to “AUTO”. Install Idle gear holder assembly (0-A12) gearing 2/3 portion with the gear of (ga1vanometer (q 1) Idle gear holder assembly (0-A12) should never touch shaft recept~cle assembly (0-D5), and the clearance is approximately 0.2-0.3mm. (b) Pull meter coupling plate assembly (0-A8) toward shaft receptacle assembly (0-D5). Install rack (A11), attaching its concave part to the rivet of meter coupiing plate assembly (0- A8). Three kinds of rack (A11) of different widths are

  • ASAHI Pentax K2 23602, 23602 /136 Procedure (a) No clearance is allowed between release plate (A503) and the lever of shutter mechanism (E000). and also the lever should not be pushed by release plate. (b) After shutter cocking, adjust clearance to 0.3mm between Mirror Actuator lever hook plate assembly (0-B48) and its hitting part. (Adjusting screw 1) (c) Shutter stroke adjustment Depressing shutter button gradually, shutter starts working at 2.3mm ±0.2 deep from original position. (Adjusting screw 2) (d) Self timer stroke 0.1 mm deeper than shutter stroke (Adjusting screw 3) 8. Funchon check of SWp “ON” When release button is gra

  • ASAHI Pentax K2 23602, 23602 /137 9. Shutter speed adjustment: Testers:Light value correction unit. TSST-3A. T adjuster (or battery), ESST-1A, digital counter, diaphragm setting ring (KA-00-lA), 23600K-A400-A. Procedure: (a) Auto speed adjustable resistor R7 (1X, ASA100, 2.8V) EV12 — 1/60 sec EV16 — 1/1000 EV16(2X) — 1/500 EV8 — 1/4 EV4 — 1 (b) Meter level — R10 EVI6 — 1/1000sec (c) Meter sensitivity — R9 EV8 — 1/4 (d) Manual shutter speed — Rl2 EVI2 — 1/60 (check all shutter speeds to see Rotary SW contact effects) (e) Battery Checker 2.1V OFF 2.4V ON (No adjustment is allowed because no tester is supplied). Fig. 16 Fig. 17

  • ASAHI Pentax K2 23602, 23602 /138 10. Galvanometer installation Tester: Meter tester (MA-00-01) Needle must be absolutely horizontal between 15 and 8. Check the movable range of the needle in the upper and lower part. 11. Shutter release adjustment As shown in Fig. 19, when mirror .housing is released, dimension between Shutter Actuator plate (B61) and minor housing foot. should be kept at 9.4 ±10mm. The longer Shutter actuotor plate (B61) will break Shutter mechanism (E000), and the shorter one will never make it (E000) function. Fig. 18 Fig. 19

  • ASAHI Pentax K2 23602, 23602 /139 D. Lubricants G21 — Mainly used G31 — 0-B25, 0-B48, 0-B68, 0-B22 L — On rewind shaft (D6) E. Special tools 23600K-C135-A 23600K-A316-A 23600K-A340-A 23600K-A19-A 23600K-C8-A 23600K-B40A 23600K-D4-A 23600K-C134-A1 23600K-C134-A2 Fig. 20

Related Products and Documents (Digital Camera):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 IBM 16/4 Token Ring PCI Special NIC Quickspecs ibm/16-4-token-ring-pci-special-nic-693.pdf 22 Dec 2022 3
2 Zebra Workabout Pro 3 Operation & user’s manual zebra/workabout-pro-3-X76.pdf 04 Jul 2023 382
3 Baumatic BDW13 Instruction manual baumatic/bdw13-T1S.pdf 08 Dec 2023 40 3.35 Mb
4 Philips 221P3LPEB/00 Service manual philips/221p3lpeb-00-Z11.pdf 22 Sep 2022 93
5 Bertram 670 Owner's manual bertram/670-767.pdf 12 Oct 2023 140
6 Oracle Delphi Mk VI Owner's manual oracle/delphi-mk-vi-67R.pdf 10 Sep 2023 22

Similar Resources:

  • Oregon Scientific

    DS6688

    (19 pages)
    DS6688 Manual-Eng,Ita,Fre (086-003403-012)ENITFRDEESPORNLSWEENITFRDEESPORNLSWEDS6688BSX1 Manual-Eng (086-003403-080)© 2004 Oregon Scientific. All rights reserved.086-003403-012Model: DS6688User ManualManuale d’usoManuel d’utilisation …
  • SenTech

    GigE

    (6 pages)
    1/6 Sentech GigE Vision Camera Technical Notes GigE01: Load the Factory Default Rev.1.00 Sentech GigE Vision Camera Technical Note: The procedure to load the factory setting Sensor Technology Co., Ltd …
  • Sony

    Cyber-shot DSC-TX10

    (61 pages)
    S ON'Y: 4-26_-636-22(1)DigitalStillOamera,,nstruct,onManual GBiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiCa,mara fotografia digital / Manual de instrucciones ESCgb_r-shotAVCHD H-"lml" …
  • Kodak

    ESP Office 2100 Series

    (36 pages)
    User Guide • Guide d'utilisationGuía del usuario • Guia do UsuárioOce 2100 SeriesAll-in-One Printers • Imprimantes tout-en-unImpresoras multifunción • Impressoras MultifuncionaisEastman Kodak CompanyRochester, NY 14650 U.S.A.© Eastman Kodak Company, 2010. MC/MR/TM: Kodak, ESP, EasyShare.Printed in China.1K7637 …
  • Canon

    2807B005

    (2 pages)
    EOS 50D Digital SLR Camera canon.com.au Subject to change without notice High Performance and Quality The ultimate mid-range DSLR for the developing enthusiast photographer. A 15.1 megapixel Canon-developed CMOS sensor and DiG!C 4 Image Processor combine to deliver superb image quality with low noise and natural colour reproduction. Key new feature …
  • Nikon

    D60

    (2 pages)
    En_01This guide provides first-time users with information on taking photographs with the D60, on copying photographs to a computer, and printing photographs. Complete information on using your Nikon digital camera can be found in the User’s Manual and Help menu of each supplied software application.Digital CameraQuick Start GuideDigitutor“Digitutor,” …

Comments, Questions and Opinions: