SeaDoo ZS05 Operation & User’s Manual

Text of SeaDoo ZS05 User Guide:

• SeaDoo ZS05, Distributors in the United States and Canada provide a standard Limited Warranty for 6 months from the date of purchase for new products. If you're not located in the United States or Canada, please contact your local distributor for warranty arrangements in your territory. Please visit www.seadooseascooter.com for distributor / Service Centre details. Distributors ONLY warrant Stallion products purchased from an authorized dealer. Ask your local Distributor for the warranty period in you

• Parts DiagramInstruction 1 Latch 2 Nose Cone 3 Inner Nose Cone 4 Vent Plug 5 Trigger 6 Handle 7 Nozzle 8 Propeller 9 Protective Grilles 10 Battery Housing 11 Master Switch 12 Battery Leads 13 Battery 14 Vent Hole 15 Buoyancy Control Chamber 16 Silicone Ring 17 Pump 18 Lubricant 19 Charger 20 Charger Jack 1 2 3 11 10 12 13 19 20 14 15 7 6 8 9 5 4 16 17 18 Fig.

• SeaDoo ZS05, WARNINGS • Read the user's manual carefully. • Never remove the grilles except for maintenance. • Never stick body parts, clothing or other objects in the vicinity of the Propeller. Do not wear loose or flowing clothing or equipment that could be drawn into the Propeller. • Particular care should be exercised when using the SEASCOOTER™ near anybody with long hair. Users with long hair should tie it up or wear a swimming cap when using the SEASCOOTER ™ . • Always inspect

• SeaDoo ZS05, Getting Started When you buy the SEA-DOO ® SEASCOOTER ™ GTI the battery is disconnected and needs to be charged. Follow the safety cautions on pages 9 to 12 and charging instructions on pages 13 to 16. Using the SEASCOOTER ™ for swimming and snorkeling. When swimming or snorkelling the SEA-DOO ® SEASCOOTER ™ GTI should be kept positively buoyant - this is done by simply making sure the Buoyancy Chamber is empty and fitted inside the Nose Cone. To use the SEASCOOTER ™ for swimming or snorkeling follow these instructions. 1. Charge the batt

• SeaDoo ZS05, Using the SEA-DOO ® SEASCOOTER ™ GTI for diving - adjusting the buoyancy. Your SEASCOOTER ™ can be used for diving up to 30m/100ft but will need to be adjusted for neutral buoyancy. The SEASCOOTER ™ must never be adjusted for negative buoyancy to avoid it sinking if accidentally released. To adjust for neutral buoyancy follow these instructions 1. Make sure the SEA-DOO ® SEASCOOTER ™ GTI is in the Off position. 2. Remove the SEASCOOTER ™ from the water, give a half turn to the Latches, remove them (see figure 4) and remove the Buoyancy Con

• SeaDoo ZS05, Battery Use CAUTION • Your SEA-DOO ® SEASCOOTER ™ GTI is supplied with a battery that needs to be treated carefully as it will release potentially explosive gases during its normal cycle of use (off gassing). Please read the entire manual thoroughly and follow all instructions. Failure to do so can result in an explosion occurring. • Always remove the battery from your SEA-DOO ® SEASCOOTER ™ GTI when it is not in use and store separately in a well ventilated area where it is out of the reach of children and away from heat and ignition sources. • Do not install the battery in your SEA-DOO ® SEASCOOTER ™

• SeaDoo ZS05, Battery Use CAUTION • Never charge the battery in sealed container. • Never charge the battery near water. • Never short circuit the battery or battery connectors. • Always ensure the charger is dry before use. • The charger gets quite warm in use - this is normal. • If in doubt of the state of the battery, recharge it until the indicator on the battery charger indicates a full charge. • If the battery is not to be used for an extended period, store it in a well ventilated area away from children, heat and ignition sources and recharge it every th

• SeaDoo ZS05, Battery Use Charging the battery For battery charging follow these instructions. 1. Always ensure that the Master Switch is Off - see figure 2. 2. Always ensure that the SEA-DOO ® SEASCOOTER ™ GTI is out of the water, dry and placed in a dry area. 3. Give a half turn to the Latches and remove them from the Nose Cone as shown in figure 4. 4. Remove the Outer Nose Cone and Buoyancy Control Chamber. 5. Open the Vent by unscrewing the Vent Plug. 6. Remove the Inner Nose Cone. To do this, first feed the silicone ring (provided with this manual) through the latch holes in the Inner Nose Cone and hook over the hooks on the Battery Housing (see figure 6). Then s

• SeaDoo ZS05, 17. Make sure the seals and sealing surfaces are clean and lubricated before replacing the Inner Nose Cone. See fig.8 21. Replace the Buoyancy Control Chamber. 22. Replace the Outer Nose Cone making sure the key is aligned correctly and insert the Latches and lock the Nose Cone by giving them a half turn. See fig.11. 18. Replace the Inner Nose Cone making sure the key is aligned correctly. See fig. 9. 19. Ensure the Vent O Ring is fitted correctly. See fig. 10. 20. Screw in the Vent Plug to seal the

• SeaDoo ZS05, Care And Maintenance To replace a flat battery with a fully charged battery. 1. Follow the steps 1 to 7 on page 12, to open the SEASCOOTER ™ . 2. Unplug the battery at the socket by pressing the locking feature shown in figure 7. 3. Remove the flat battery. 4. Install and connect the charged battery in the correct position - the leads of the battery must be oriented as shown on the sticker on the battery, see figure 12. Battery Care • Please read and understand important Battery Use safety information o

• SeaDoo ZS05, Trouble Shooting • When storing the SEASCOOTER ™ for extended periods of time, open the Vent Plug in the Inner Nose Cone. • DO NOT store battery in SEASCOOTER ™. • ALWAYS store your SEASCOOTER ™ vertically when not in use to prevent deformation of the Propeller Nozzle. Unit does not function If the motor does not start when both triggers are pressed, make sure 1. The battery is properly connected 2. The battery is fully charged (see page 13, charging the battery) 3. The master switch is in the "On" position (see fig 2, page 6) 4. There is no water in the battery compartment (se

• SeaDoo ZS05, Removing rear grille and Propeller to remove obstruction 1. Remove the SEASCOOTER ™ from the water. 2. Make sure the master switch is off. 3. Remove the battery - see page 13, step 1-9. 4. Unscrew the six rear grille screws as shown in figure 15. 5. Whilst holding the Propeller, use an M6 socket to remove the nut from the Propeller shaft (See figure 16). 6. Slide the Propeller off the shaft, taking care not to loose the drive pin or washers. 7. Remove the blockage from the Propeller. 8. Replace the drive pin (if remo

• SeaDoo ZS05, 9. Replace the washer(s) and nut and tighten with the socket whilst holding the Propeller making sure it is securely fastened (See figure 18). 10. Replace the grille. 11. Replace the battery. SEASCOOTER™ cuts out To protect the electronic circuit of your SEASCOOTER ™ from damage a safety mechanism has been built in that cuts the power if a wall or rock or other immovable object is hit. If this occurs simply wait for a short period to allow the SEASCOOTER ™ to reset itself and resume use. Accidental Flooding Be sure to keep the seals sand and grit free to ensure they keep water out and to close the vent plug after accessing the batte

• Technical Specifications 25 For more information on Sea-Doo ® Seascooter ™ Products ( Warranty, Customer Care / Maintenance, Parts & Battery Purchase ) PLEASE VISIT www.seadooseascooter.com SEA-DOO ® and the BRP logo are trademarks of Bombardier Recreational Products Inc. or its affiliates, used under licence to Stallion (asia) Ltd. For more informatio

• This warranty does not cover any product that has been subject to misuse negligence or accident, or that has been operated in any way contrary to the operating instructions as specified in the User Manual. This warranty does not apply to any damage to the product that is the result of improper maintenance or to any product that has been altered or modified so as to change

Related Products and Documents (Scooter):

Comparable Devices:

Similar Resources:

• iSmart.emobility iBoard one X2 (70 pages) Please use the product after having suciently familiarized with the Instruction Manual.Some of the functions may be changed without prior notication to improve the functions of the product.iBoard one X2Instruction Manual Bedienungsanleitung Mode d’emploiEnglish p.2Deutsch p. 24Français p. 47 …

• MULTIQUIP CA4HM (36 pages) OPERATION MANUALP/N 21518THIS MANUAL MUST ACCOMPANYTHE EQUIPMENT AT ALL TIMES.Revision #2 (09/08/04)KOHLER 27 HPKOHLER 28 HP EFI SERIESMODEL CA4HMMODEL CA4HMMODEL CA4HMMODEL CA4HMMODEL CA4HMWALK-BEHIND TROWEL(HONDA GASOLINE ENGINE)To order go to Discount-Equipment.com …

• Wildfier WFH150-T (8 pages) Have a problem - Need parts - Please call Toll Free (866) 658-7300Fax: (740) 283-6541 • Email: [email protected] WFH150-TTouring ScooterOwner’s Manual If you believe that your vehicle has a defect which could cause a crash or could cause injury ordeath, you should immediately inform the National Highway Traffic Safety Administration (NHTSA)in …

• Trikke T8 (6 pages) TECHFAQ’SBodyPoweredModels1)“IboughtthisTrikketogetinshapeandhavefunbutcantheTrikkesustainmyweight?”AllofourTrikkevehiclesarerecommendedtosupportupto250lbsbutwedohavesomecustomersweighing300lbsthatusewith …

• TaoTao Pony 50 (28 pages) TABLE OF CONTENTSI. VARIOUS PART NAMES:---------------------------------------------11.L:----------------------------------------------------------------------------------------7II: OPERATION DESCRIPTIONS OF SYSTEMS:32.R:-------------------------------------------------------------------------------------7A.INSTRUMENT PANEL COMPONENTS:3 H. UNDER SEAT STORAGE …

• Fiat 500 Abarth (170 pages) 500ABARTHThe data contained in this publication is intended merely as a guide. Fiat reserves the right to modify the models and versions described in this booklet at any time for technical and commercial reasons. If you have any further questions please consult your Abarth dealer. Printed in recycled paper without chlorine.OWNER HANDBOOKENGLISHCop 500 ABARTH …

Comments, Questions and Opinions: