Whirlpool furnace User Instructions

Text of Whirlpool furnace User Guide:

• Whirlpool furnace, GAS FURNACE USER INSTRUCTIONS GAS FURNACE SAFETY Table of Contents GAS FURNACE SAFETY................................................................1 GAS FURNACE OPERATION ........................................................4 Light Furnace ...............................................................................4 Shut Down....................................................................................5 Adjust Controls.............................................................................5 GAS FURNACE MAINTENANCE...................................................5 Filter Maintenance........................................................................6 TROUBLESHO

• 2 You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Your safety and t

• Whirlpool furnace, 3 SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS ■ The furnace area must be kept clear and free of combustible materials, gasoline, and other flammable vapors and liquids. ■ Insulating materials may be combustible. A furnace installed in an attic or other insulated space must be kept free and clear of insulating materials. Examine the furnace when it is installed and also any time insulation is added. ■ For proper and safe operation, the furnace needs air for combustion and ventilation. Do not block or obstruct air openings on the furnace, air openings to the area in which the furnace is installed, and the

• 4 GAS FURNACE OPERATION Thermostat Control There are many types and styles of thermostats. Your thermostat may look different from the one shown, depending on the type of thermostat and whether cooling was installed with the system. However, almost all thermostats perform the same basic functions. There are 2 switches located on the thermostat. One switch controls

• Whirlpool furnace, 5 Shut Down 1. Set the thermostat control(s) to the lowest setting (see Thermostat Control graphic). 2. Disconnect power. 3. Remove the burner access panel (on some models). 4. Turn off the gas supply at the manual gas control valve. 5. Replace the burner access panel (on some models). Adjust Controls Turn System On or Off ■ Move the thermostat selector switch to HEAT or COOL to turn on the system. ■ Move the thermostat selector switch to OFF to turn off the system. Select Temperature Move th

• Whirlpool furnace, 6 Your gas furnace is designed to give many years of efficient, satisfactory service. There are routine maintenance steps you should take to keep your furnace operating efficiently. This maintenance will assure longer life, lower operating costs, and fewer service calls. In addition to the maintenance procedures listed in this manual, there are also other service and maintenance procedures that require the skills of a qualified person. ■ The flue gas passageways should be cleaned. ■ The gas burners should be cleaned. ■ The condensate flow should be checked. ■ The furnace ventilat

• Whirlpool furnace, 7 Minimum Filter Requirements ■ The Airflow Descriptor is the 2 digits immediately preceding the hyphen (-) in the furnace model number. The model number is located on the rating plate inside the access panel. ■ Areas and dimensions shown for cleanable filters are based on filters rated at 600 ft (182.9 m) per minute face velocity. ■ Typical filter sizes are shown; however, any combination of filters whose area equals or exceeds the minimum area shown is satisfactory. Filter Location The filter on your furnace will be located in one of several places on the unit, depending on which furnace style you own. See the sections following to determine where your filter is located.

• Whirlpool furnace, 8 TROUBLESHOOTING First try the solutions suggested here and possibly avoid the cost of a service call. Unit fails to operate ■ Check the following: Is the main switch that supplies power to the unit in the ON position? Is the manual gas control valve in the OPEN position? Has a fuse blown, or has the circuit breaker tripped? If problem continues, call an electrician. Is the thermostat set properly? See “Adjusting the Controls.” Unit is operating but not providing complete comfort ■ Check the following: Is the thermostat set properly? See “Thermostat Control.” Is the filter c

• Whirlpool furnace, 9 LIMITED WARRANTY Applies in U.S.A. and Canada Only FAILURE TO MAINTAIN YOUR EQUIPMENT WILL VOID THIS WARRANTY COVERED EQUIPMENT The following Whirlpool ® and Whirlpool Gold ® (G) cooling and heating equipment is covered by the Limited Warranty: Condensing Units: W2C3, W2C4, W2GC3, W4GC3, W4GC4, W4GC6, W4GC8 Heat Pumps: W2H3, W2H4, W2GH3, W4GH3, W4GH4, W4GH6, W4GH8 Gas Furnaces: WFAT, WFAR, WFCT, WFCC, WGFA, WGFB, WFAU, WGFD, WGFE Air Handlers: WAHMS, WAHMV Electric Furnaces: WMB Evaporator Coils: WEC1P, WEM1P, WEU1P, WEH1P Package Eq

• Whirlpool furnace, 10 EXCLUDED COMPONENTS The following components are not covered by this warranty: cabinets, cabinet pieces, air filters, driers, refrigerant, refrigerant line sets, belts, wiring, fuses, oil nozzles and unit accessories. REPAIRS All repairs of covered components must be made with authorized service parts by a licensed service dealer or contractor. Labor charges are not covered by this warranty. Such costs may be covered by a separate warranty provided by the installer. CARE OF EQUIPMENT Your new unit must be properly installed, operated and maintained in accordance with the unit installation, operation and

• Whirlpool furnace, 46877B008 © 2008. All rights reserved. ®Registered Trademark/TM Trademark of Whirlpool, U.S.A., Manufactured under license by Tradewinds Distributing Company, LLC., Coconut Grove, Florida 4/08 Printed in U.S.A.

Related Products and Documents (Furnace):

Comparable Devices:

Similar Resources:

• Rheem RGPK (36 pages) 92-23531-88-00INSTALLATION INSTRUCTIONSFOR UPFLOW/HORIZONTAL (RGPK) AND DOWNFLOW(RGLK) TWO STAGE INDUCED DRAFT GAS FURNACES!If the information in these instructions is not followed exactly, afire or explosion may result, causing property damage, personalinjury or death.THESE INSTRUCTIONS AREINTENDED AS AN AID TOQUALIFIED SERVICEPERSONNEL FOR PROPERINSTALLATI …

• York TG8S (6 pages) 363657-YTG-G-0613FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALETECHNICAL GUIDEGAS-FIRED RESIDENTIAL SINGLE STAGE MULTI-POSITION GAS FURNACESSTANDARD & Low NOx MODELSMODELS: TG8S / TGLSNATURAL GAS40 - 130 MBH INPUTDue to continuous product improvement, specifications are subject to change without notice.Visit us on the web at www.york. …

• Central Boiler Titanium Series (52 pages) SAVE THESE INSTRUCTIONS(p/n 9000600 - REV. C) - 28-JUN-2019For parts and accessories, service or repairs, call your authorized Central Boiler dealer or heating contractor. Record the information below for future reference.Model Serial Number Installation DateDealership Name Phone NumberOwner NameSome of the information provided in this guide is for referenc …

• Nortron D SERIES (12 pages) INSTALLATION AND USER MANUALD SERIES ELECTRIC FURNACEMODELS: 21D10, 21D15, 21D18, 21D20, 21D23 AND 21D25IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.NORTRON; Sherbrooke, Quebec www.dettson.ca 1-800-567-27332019-11-29 X40252A …

• Carrier OIL FURNACE 58CMA (12 pages) 58CMAMultipoiseOil FurnaceInstallation, Start-Up, and Operating InstructionsFor Input Capacities of 70,000—154,000; Series 110NOTE: Read the entire instruction manual before starting theinstallation.This symbol → indicates a change since last issue.INDEXPageSAFETY CONSIDERATIONS..................................................1-3Dimensional Drawing..... …

• Carrier KGBFR0401B14 (2 pages) Installation InstructionsPlease read these instructions completely before attemptinginstallation.SAFETY CONSIDERATIONSInstalling and servicing heating equipment can be hazardous due togas and electrical components. Only trained and qualifiedpersonnel should install, repair, or service heating equipment.Untrained personnel can perform basic maintenance functi …

Comments, Questions and Opinions: