Manualios.com

Phonak Roger Clip-On Mic Operation & User’s Manual

  • Roger Clip-On Mic Microphone
  • mapsfvROyAWng
  • Operation & User’s Manual
  • PDF / Adobe Acrobat Reader
  • 56

Phonak Roger Clip-On Mic Manual Online:

3.25, 2515 votes
Phonak Roger Clip-On Mic User Manual
Phonak Roger Clip-On Mic User Guide
Phonak Roger Clip-On Mic Online Manual

Text of Phonak Roger Clip-On Mic User Guide:

  • Phonak Roger Clip-On Mic, or 2. 1. 28 Via micro-USB audio cable Alternatively, you can use the short micro-USB audio cable to connect your multimedia device directly to your Roger Clip-On Mic. 1. Plug the round end of the micro-USB audio cable into the headphone output of your multimedia device. 2. Plug the rectangular end (micro-USB) of the micro-USB cable into the socket of your Roger Clip-On Mic. Roger Clip-On Mic must be switched on to transmit the audio signal to your hearing aids. After you have activated your multimedia device’s audio signal, Roger Clip-On Mic will detect this signal and will automatically mute its own microphone. 4. Using Roger Clip-On Mic

  • Phonak Roger Clip-On Mic, 52 The symbol with the crossed-out garbage bin is to make you aware that this device may not be thrown away as normal household waste. Please dispose of old or unused device, at waste disposal sites intended for electronic waste, or give your device to your hearing care professional for disposal. Proper disposal protects the environment and health. This product has an embedded, non- replaceable battery. Do not attempt to open the product or remove the battery as this may cause injur

  • Phonak Roger Clip-On Mic, 13 You can also connect via a SCART adaptor, which can be bought from an electronics store or from your Phonak dealer. Connect the other end of the audio cable to the SCART adapter. Then plug the SCART adapter into a free SCART output socket on your TV. If your TV does not include an analog audio output, you need a digital to analog converter. Such converters can be found in electronics stores or may be purchased from your Phonak dealer.

  • Phonak Roger Clip-On Mic, max. 20 cm / 8 inches 4. Using Roger Clip-On Mic 26 Hanging it around the neck 1. Open the lanyard by pulling the magnets apart. 2. Hang the Roger Clip-On Mic around the neck of the speaker and close the lanyard. 3. Adjust the length of the lanyard to bring Roger Clip-On Mic closer to the mouth. Secure the wire by pulling the cable into the gap. 4. The distance between Roger Clip-On Mic and the mouth should not be more than 20 cm / 8 inches.

  • Phonak Roger Clip-On Mic, 2 1. Welcome 4 2. Getting to know your Roger Clip-On Mic 6 2.1 In the box 6 2.2 How the Roger Clip-On Mic works 7 2.3 Device descriptions 8 2.4 Indicator lights (LED status) 9 3. Getting started 10 3.1 Setting up the docking station 10 3.2 Charging your Roger Clip-On Mic 15 3.3 Switching on and o 18 3.4 Using Roger receiver 19 3.5 Connecting a receiver 20 4. Using Roger Clip-On Mic 22 4.1 Wearing Roger Clip-On Mic 22 4.2 Using the lanyard 24 4.3 Connecting to multimedia devices 27 Contents

  • 21 4. The indicator light will turn green for two seconds to conrm a successful connection. 5. Repeat steps 2 & 3 to connect a second receiver. Depending on the receiver type, you may connect a maximum of two Roger ear-level receivers OR one Roger MyLink to your Roger Clip-On Mic. Indicator light (connection status) After pressing the Connect button, the following feedback may

  • Phonak Roger Clip-On Mic, 47 8.4 Other important information S Persons with pacemakers or other medical devices should ALWAYS consult their physician or the manufacturer of their device BEFORE using the device. The use of the device with a pacemaker or other medical devices should ALWAYS be in accordance with the safety recommendations of the physician responsible for your pacemaker or the pacemaker manufacturer. S Device collects and stores internal technical data. This data may be read by a hearing care professional in order to check the device, as well as to help you us

  • Phonak Roger Clip-On Mic, 29 5.1 Mute Firmly press the on / o button to mute Roger Clip-On Mic’s microphone or audio input. When muted, the indicator light will turn solid violet. Press the on / o button again to re-activate the microphones or audio input. 5. Special functions

  • Phonak Roger Clip-On Mic, 50 10. Information and explanation of symbols The CE symbol is conrmation by Phonak Communications AG that this Phonak product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This symbol indicates that it is important for the user to read and take into account the relevant information in these user guides. This symbol indicates that it is important for the user to pay attention to the relevant warning notices in these user guides. Important information for handling and product safety.

  • Phonak Roger Clip-On Mic, 14 When the docking station is plugged into the headset socket of your TV, you can adjust the volume via your TV’s remote control. Some TVs will switch o their loudspeakers when you plug the jack into the headset socket – meaning the TV will not be audible for other people. In such a case use the Cinch / RCA or SCART output socket as described above. The Roger Clip-On Mic docking station can also be connected to any other audio device such as an MP3 player, PC or HiFi system using the audio cable. 3. Getting started

  • 45 8.3 Product safety information Protect the device from excessive shock and vibration. Do not expose your device to temperatures and humidity outside of the recommended conditions stated in this User Guide. Never use a microwave or other heating devices to dry the device. Clean the device using a damp cloth. Never use household cleaning products (washin

  • Phonak Roger Clip-On Mic, max. 20 cm / 8 inches Too far away Not pointing towards the mouth 23 Make sure Roger Clip-On Mic points towards the speaker’s mouth. The distance between Roger Clip-On Mic and the speaker’s mouth should not be greater than 20 cm / 8 inches.

  • Phonak Roger Clip-On Mic, 41 Roger Clip-On Mic’s light is blinking red (single ash) J Your Roger Clip-On Mic has been connected to another microphone which is no longer available The Roger Clip-On Mic’s light is blinking red (double ash) J Its battery charge is low Roger Clip-On Mic has stopped working J Software issue J Create a NewNet (press the Connect button fro 7 seconds) to make Roger Clip-On Mic a standalone transmitter again J Charge Roger Clip-On Mic as soon as possible J Reboot Roger Clip-On Mic by simultaneously pressing it’s two buttons Most probable cause(s) Solution(s)

  • 32 Roger technology allows you to use multiple microphones in parallel by connecting additional Roger Clip-On Mics and Roger Pens. 6.1 Connect To connect another microphone to your Roger Clip-On Mic, follow these steps: 1. Turn on both microphones. 2. Decide which Roger Clip-On Mic will be your primary device. Mark this device by placing the star sticker on the back

  • 2. 3. 1. 16 Alternatively, you can also charge your Roger Clip-On Mic without the docking station. This may be useful when traveling. Using the micro-USB cable: 1. Plug the smaller end (micro-USB) of the charging cable into your Roger Clip-On Mic. 2. Plug the larger end (USB) of the charging cable into the power supply. 3. Plug the power supply into an easily accessible power socket. 3

  • Phonak Roger Clip-On Mic, 43 8.2 Hazard warnings Keep this device out of reach of children aged under 3 years. Opening the device might damage it. If problems occur that cannot be resolved by following the guidelines in the Troubleshooting section of this User Guide, consult your hearing care professional. Your device should only be repaired by an authorized service center. Changes or modications to this device that were not explicitly approved by Phonak are not permitted. Please dispose of electrical components in accordance with your local regulations. Do not use your device in areas where electronic equipment is prohib

  • Phonak Roger Clip-On Mic, Clipped on the collar (clip downwards) Clipped on clothing (clip upwards) or or Clipped between buttons (clip sideways) 22 4.1 Wearing Roger Clip-On Mic The easiest way to attach Roger Clip-On Mic to the person speaking is by using its clip. There are dierent ways of clipping Roger Clip-On Mic to the speaker’s clothes: 4. Using Roger Clip-On Mic

  • Phonak Roger Clip-On Mic, 3 5. Special functions 29 5.1 Mute 29 5.2 Disconnecting Roger devices (NewNet) 30 5.3 Verication mode 30 6. Adding additional microphones 32 6.1 Connect 32 6.2 Using additional microphones 36 7. Troubleshooting 39 8. Important information 42 9. Service and warranty 48 10. Information and explanation of symbols 50

  • Phonak Roger Clip-On Mic, 49 9.3 Warranty limitation This warranty does not cover damage from improper handling or care, exposure to chemicals, immersion in water or undue stress. Damage caused by third parties or non-authorized service centers renders the warranty null and void. This warranty does not cover any services performed by a hearing care professional in his / her oce. Serial number: Date of purchase: Authorized hearing care professional (stamp / signature):

  • Phonak Roger Clip-On Mic, 48 9. Service and warranty 9.1 Local warranty Please ask the hearing care professional, where you purchased your device, about the terms of the local warranty. 9.2 International warranty Phonak oers a one year limited international warranty, valid as of the date of purchase. This limited warranty covers manufacturing and material defects. The warranty is valid only if proof of purchase is shown.

Related Products and Documents (Microphone):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Alpine CDM-7871 Owner's manual alpine/cdm-7871-WY3.pdf 26 Aug 2022 22 0.37 Mb
2 APRILIA RS4 125 Service manual aprilia/rs4-125-32I.pdf 15 Oct 2022 155
3 Humminbird Matrix 10 Install manual humminbird/matrix-10-826.pdf 17 Dec 2023 22
4 Miele DA5321D Operating and installation instructions miele/da5321d-P5S.pdf 06 Jul 2023 32
5 Tenex DVR-505 Manual  tenex/dvr-505-1GA.pdf 14 Nov 2023 24
6 Philips BDL4210Q/00 Manual  philips/bdl4210q-00-N29.pdf 22 Mar 2023 2

Similar Resources:

  • Astatic

    611L

    (2 pages)
    DescriptionThe Astatic Model 611L is an omnidirectional, dynamic microphone designedfor hand held applications in quality sound installations. The frequencyresponse, especially tailored for voice communications, provides a crisp,clear, highly intelligible sound. The Model 611L, with modern "tear drop"styling, offers extreme reliability, convenient …
  • McGrey

    UHF-2V2I

    (4 pages)
    Technische Daten / Technical Data Bezeichnung / Matchcode McGrey UHF-2V2I Quad Vocal Funkset Artikelnummer / Article No. 00039498 Empfänger / Receiver Netzspannung / Net voltage 110-240V / 50-60 Hz – 13.5V/DC Funkfrequenz / Frequency K1 863,500 MHz / K2 864,825 MHz K3 824,550 MHz / K4 828,175 MHz Reichweite / Distance ca. 50m Kanäle / Channels 2 …
  • Shure

    KSM313

    (58 pages)
    KSM313©2011 Shure Incorporated27A16163 (Rev. 1)Printed in U.S.A.User GuideLe Guide de l’UtilisateurGuia del UsuarioGuida dell’UtenteBedienungsanleitungРуководство пользователя取扱説明書用户指南사용자 안내서 …
  • Radio Shack

    10-Watt Powerhorn with Handheld Microphone

    (2 pages)
    © 2001 RadioShack Corporation.All Rights Reserved.RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.32-2038A OWNER’S MANUAL — Please read before using this equipment.10-Watt Powerhorn with Handheld MicrophoneYour RadioShack 10-Watt Powerhorn combines a high-efficiency trumpet horn speaker, a powerful compact solid-state amplifi …
  • Nolan

    NSRX3C2MSX

    (9 pages)
    Copyright Nolan Systems [email protected] http://www.nolan-sys.com/ 1 ----------For iPad, iPhone, Android smartphone, Galaxy note..... The Nolan Bluetooth MIC (BTMIC) supports 2 different modes, one is to work with audio receiver and another mode is to work with iPhone/iPad/Android smartphone/Galaxy Note...etc. So, you need to ensure the B …
  • Zaxcom

    TRX900

    (8 pages)
    Zaxcom TRX900/900AA Transmitter Guide Zaxcom Inc. 230 West Parkway, Unit 9, Pompton Plains, NJ 07444 - 973-835-5000 Document Revision 1.02 For Firmware Revision 33 and Higher This guide assumes the firmware version displayed above is installed. The firmware revision code is displayed shortly every time the transmitter is turned on. Important Note for TR …

Comments, Questions and Opinions: