Bell U547 Turbo Stick Getting Started Manual

Text of Bell U547 Turbo Stick User Guide:

• Bell U547 Turbo Stick, 4. You may need to enter your name and password, and restart your computer, during the installation process. 5. Once the installation is complete, double-click the Mobile Connect icon to start the program. 6. If your Turbo Stick was removed during installation, re-insert. Do not forcibly insert the device as this may damage both the device and the USB port. Mobile Connect will initialize, scan for your Turbo Stick, and be ready to connect. You may configure the settings using the Tools Menu, or click “Connect” to connect to the Internet. When Mobile Connect runs, it will check i

• Bell U547 Turbo Stick, 25 MODIFICATIONS: Any changes or modication not expressly approved by Novatel Wireless, Inc. could void the user’s authority to operate this equipment. The FCC has granted an Equipment Authorization for this wireless modem with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. FCC Equipment Authorization ID: NBZNRM-MC547 In order to comply with FCC RF exposure requirements, the device must be installed so that a minimum separation distance of 0.5 cm (0.2”) is maintained between the antenna and all

• Bell U547 Turbo Stick, Troubleshooting Below is a list of indicator lights which outline the status of your Turbo Stick. LED COLOUR SERVICE LED STATE DESCRIPTION Blue Flashing Solid Ready to connect Dual-Carrier HSPA+ Network found Connected to a network using Dual-Carrier HSPA+ Green Solid HSPA+, 3G or 2G Connected to a network using HSPA+, 3G or 2G Yellow Flashing Searching for service Searching for service Blue/Red Alternating Error Device error, contact support Red Short solid Long solid Flashing Initializing Error Error Normal start-up, changes to yellow quickly Device error, remove and reinsert SIM card error, refer to page 21 for Troubleshooting No Light Off No power or incorrectly inserted

• Bell U547 Turbo Stick, Third-Party Trademarks Product trademarks and registered trademarks are the property of their respective owners. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, Bell reserves the right to make changes to the products described in this document without notice. Bell does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein. In addition, the program and information contained herein are licensed only pursuant to a li

• Bell U547 Turbo Stick, Your new Turbo Stick must be handled with care to ensure reliable operation. The following handling guidelines are recommended: • Do not apply adhesive labels to your Turbo Stick; this may cause your Turbo Stick to overheat and may alter the performance of the antenna. • Do not force the SIM card into the SIM card slot. • The USB connector should plug easily into your computer’s Type A USB port. Forcing your Turbo Stick into a port may damage the connector. • Protect your Turbo Stick from liquids, dust and excessive heat. • Store your Turbo Stick in a dry and clean environme

• Bell U547 Turbo Stick, LED – The LED provides connections status. Refer to “Troubleshooting” on page 21 for a detailed list of the colours and their defined states. SIM card slot – Refer to “Inserting your Bell SIM card” on page 5. Hinged USB Connector – Folds back to protect the USB connector while your Turbo Stick is not in use. microSD card slot – The microSD card slot is located under the back cover (Card sold separately, maximum 32GB). Hardware overview 16 Hinged USB Connector LED microSD card slot SIM card slot

• Bell U547 Turbo Stick, 22 Troubleshooting (continued) Below is a list of common error messages and possible solutions regarding the use of your Turbo Stick. SYMPTOMS SOLUTION Intermittent connectivity and/or low throughput. Service may not be available in your location. Relocate the computer to a different area. Coverage maps are available at bell.ca/coverage. Bell does not show in the status display and/or the LED indicator on your Turbo Stick flashes yellow. Service may not be available in your location. Relocate the computer to a different area. Coverage maps are available at bell.ca/cover

• Bell U547 Turbo Stick, * These examples are approximations only. Estimates are based on the following data-per-activity assumptions: 40KB/small attachment; 500KB/large attachment; 100KB/web viewed; 1MB/digital photo; 2MB/min. of streaming video; 4MB/song. Actual data usage can vary and it is your responsibility to track and monitor your own data usage. How much data do I need? The chart below shows the approximate data usage for typical data transaction. * 15 LIGHT USER (up to 500MB) MEDIUM USER (up to 1GB) HEAVY USER (up to 3GB) VERY

• Bell U547 Turbo Stick, 4 MACINTOSH Operating system Macintosh OS 10.4 (Tiger), 10.5 (Leopard), and 10.6 (Snow Leopard) with 300 MHz Intel CPU Card slot 1 USB port, version 2.0 (recommended) or 1.1 RAM Memory 256MB Disk space 100MB System Requirements (continued)

• Bell U547 Turbo Stick, Before installing your Turbo Stick, please ensure you have the following: • A Bell wireless account with a Mobile Internet plan. (If you don’t have an account or a Mobile Internet plan, speak with a Bell account representative to get set up.) • An active Bell SIM card. • Your Mobile Directory Number (MDN), or phone number __________________________________ . Getting started 2

• Your Turbo Stick requires an activated Bell SIM card to function. If the SIM card was not inserted at the time of purchase, please insert it now, as described below. 1. Remove the cover from the front of the device by inserting a fingernail under the top narrow end of the cover and pulling toward you. 2. Slide the SIM card holder toward the USB connector to rel

• Bell U547 Turbo Stick, Follow the InstallShield ® Wizard, it will guide you through the process of installing the Mobile Connect application. Use the “Next” and “Back” buttons to navigate through the installation steps. To continue the installation, you must read and accept the terms of the License Agreement. The installation process may take several minutes to complete with no progress shown on the progress bar – please be patient. Select “Finish” to complete the installation. Once the installation is co

• Bell U547 Turbo Stick, 18 Now that the Mobile Connect software is installed on your computer, your Turbo Stick can be inserted or removed at any time. As an external device, your Turbo Stick is vulnerable to damage during transport. It is recommended that you remove and securely store your Turbo Stick when transporting your computer. To insert your Turbo Stick: 1. Flip open the USB connector and insert your Turbo Stick into the USB port. Do not forcibly insert your Turbo Stick; this may damage both your Turbo Stick and the USB port. 2. Your computer may beep. 3. Start Mobile Connect from the desktop or from the AutoPlay prompt. 4. Your

• Installing Mobile Connect for Macintosh Insert your Turbo Stick into an available USB port on your computer. Do not forcibly insert the device as this may damage both the device and the port. Your Turbo Stick automatically powers on when inserted. Your Turbo Stick will appear as a CD-ROM drive on your desktop. 1. Double-click the CD-ROM icon, then find and drag the “Mobile Connect.dmg”

• Bell U547 Turbo Stick, Installing Mobile Connect for Windows Insert your Turbo Stick into an available USB port on your computer. Do not forcibly insert your Turbo Stick as this may damage both the device and the port. Your Turbo Stick powers on when inserted, and your computer may beep. Note: Your computer may display a security warning stating that Mobile Connect is not a trusted application. You may safely dismiss this warning and continue with the installation. Installation should automatically begin. However, you may be prompted to install Mobile Connect. Select Install/Run Mobile Connect. If the auto install fails to start, remove your Turbo Stick and use an alternate

• Bell U547 Turbo Stick, 24 Regulatory Information This device has been tested to and conforms to the essential regulatory requirements of the European Union R&TTE directive 1999/5/EC and has attained CE Marking. Federal Communications Commission Notice (FCC United States) This equipment has been tested to, and found to be within the acceptable limits for a Class B digital device, pursuant to part 15 of the FCC Rules and Industry Canada ICES-003. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates radio frequency energy and is designed for use

• Bell U547 Turbo Stick, Thank you for purchasing a Turbo Stick from Bell. This Turbo Stick will enable you to connect to the Internet. This guide provides an overview of your new Turbo Stick and details on how to configure your computer for use with this Turbo Stick. Getting started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 System requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Inserting your Bell SIM card . . . . . . .

• Bell U547 Turbo Stick, Mobile Connect from Bell is a software application that allows you to set up and manage your wireless connections over the Bell network. Mobile Connect for Windows and Macintosh is pre-loaded onto your Turbo Stick and can be installed directly from it to your computer – no CD required. Before inserting your Turbo Stick into the computer: 1. If you are already using Mobile Connect or have it installed on the computer, you should uninstall the current version and restart before inserting your new Turbo Stick. 2. Ensure that computer security software (antivirus and firewall programs) are set to allow software installation. 3. Ensure that you have Admin

• Bell U547 Turbo Stick, 12 Using your Turbo Stick From the Mobile Connect main program window, you can establish a network connection and view the connection status. A. Connect/Disconnect button Connect or disconnect from the network. B. Signal strength indicator Graphically illustrated network signal status. C. Status display Indicates the availability of the network and status of current network connection. D. Usage counters An overview of the data you have transmitted and received during an active data session. E. Minimize and close buttons Minimize Mobile Connect to the System tray

• Bell U547 Turbo Stick, To remove your Turbo Stick: 1. Disconnect from the network and Exit or Quit Mobile Connect from the Tools menu. 2. Carefully remove your Turbo Stick from the USB port. 3. The computer may beep. Using your Turbo Stick on another computer: Your Turbo Stick can be used on multiple computers. Simply install the Mobile Connect software on each new computer you wish to use. Please note that data network usage is tied to your Turbo Stick itself and that usage between computers is cumulative and will be billed togethe

• 3 WINDOWS Operating system Microsoft ® Windows XP (SP 2 – 3, 32-bit only), Windows Vista™ (SP 1 – 2, 32/64-bit) and Windows 7 (32/64-bit) with 500MHz CPU Card slot 1 USB port, version 2.0 (recommended) or 1.1 COM ports 4 free COM ports I/O Resources 1 IRQ, 4096 bytes of I/O space RAM Memory 256MB (XP), 1GB (Vista), or 1GB (7) Disk space 100MB To install and

• Bell U547 Turbo Stick, 20 Some SIM cards will be provisioned with a Personal Identification Number (PIN) which locks user access to your Turbo Stick. When using a blocked SIM card, you may be asked to enter the PIN number. Service providers frequently limit the number of incorrect PIN entry attempts. If you fail to enter a correct PIN within the number of permitted attempts, the SIM card may become blocked. You will see a warning message on your last attempt. In the event that the card becomes blocked, you have the ability to re-enable the PIN mechanism by entering a Personal Unblocking Key (PUK). You will be prompted to enter a new PIN in combination with the PUK code to unblock and

Related Products and Documents (Modem):

Comparable Devices:

Similar Resources:

• Multitech MT9234ZPX-UPCI (61 pages) MultiModem® ZPX V.92 Internal Modem Models: MT9234ZPX-UPCI MT9234ZPX-UPCI-NV MT9234ZPX-PCIe MT9234ZPX-PCIe-NV User Guide …

• Allied Telesis VisionNet (4 pages) Allied Telesis Capital Corp. | www.atcc-gns.com VisionNet Modem Quick Install Guide Basic Installation Customers using a single jack for phone and internet: 1. Connect the DSL splitter to the wall phone outlet. 2. Connect phone cable from the phone port of the splitter and then to your phone. Connect a phone cable to the DSL port of the splitter and …

• Dynamix UM-S Series (2 pages) LAN Interface  4-ports switching hub (4-port router)  10/100 Base-T auto-sensing and auto-negotiation  Auto-MDIX (4-port router) Hardware Interface  WAN: RJ-11  LAN: RJ-45 x 4 (4-port router)  LAN: RJ-45 x 1 (1-port router)  Console: RS232 female  RST: Reset button for factory default Indicators  General: PWR  WAN: …

• NetComm Wireless NF17ACV (4 pages) Remote Administration Setup Guide NF17ACV FAQs NF17ACV FAQs 1 of 4 © NetComm Wireless 2017 Remote Administration Overview Remote administration allows you to access the NF17ACV web User Interface from a remote computer connected to the internet. This can also be used to enable your ISP (Internet Service Provider) to check your settings if you experience …

• AT&T High Speed Internet Service (8 pages) Need more help?Visit http://support.att.com or call Customer Service at 1.877.722.3755.AT&T High Speed Internet ServiceSelf-Installation Guide for Modem EquipmentHave you checked your Service Activation date and time? You can connect to the Internet only after the activation date and time indicated on your confirmation letter. Do you have a security syst …

• Huawei E169 (15 pages) ii Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade na …

Comments, Questions and Opinions: