Manualios.com

DeWalt DXCMLA1682066 Instruction Manual

DeWalt DXCMLA1682066 Manual Online:

4.9, 2472 votes
DeWalt DXCMLA1682066 User Manual
DeWalt DXCMLA1682066 User Guide
DeWalt DXCMLA1682066 Online Manual

Text of DeWalt DXCMLA1682066 User Guide:

  • DeWalt DXCMLA1682066, 19 English within 1/16” (1.6 mm) to prevent excessive belt wear. Verify the alignment by performing the following Motor Pulley/Flywheel - Alignment. Motor Pulley/Flywheel Alignment NOTE: Once the motor pulley has been moved from its factory set location, the grooves of the flywheel and pulley must be aligned to within 1/16” (1.6 mm) to prevent excessive belt wear. The air compressor flywheel and motor pulley must be in-line (in the same plane) within 1/16” (1.6 mm) to assure belt retention within flywheel belt grooves. To check alignment, perform the following steps: 1. Set the Auto/Off lever

  • DeWalt DXCMLA1682066, 6 English DANGER: RISK OF INJURY OR PROP ER TY DAMAGE WHEN TRANSPORTING OR STORING WHAT CAN HAPPEN HOW TO PREVENT IT • Oilcanleakorspillandcould result in fire or breathing hazard; serious injury or death can result. Oil leaks will damage carpet, paint or other surfaces in vehicles or trailers. • Alwaysplacecompressor on a protective mat when transporting to protect against damage to vehicle from leaks. Remove compressor from vehicle immediately upon arrival at your destination. Always keep compressor level and never lie on its side. WARNING: RISK

  • 10 English reaches cut-out pressure, the check valve closes, allowing air pressure to remain inside the air tank. AIR INTAKE FILTERS The filters (A) are designed to clean air entering the A pump. To ensure the pump continually receives a clean, cool, and dry air supply the filters must always be clean and the filter intakes must be free from obstructions. AIR TANK DRAIN VALVE The dra

  • DeWalt DXCMLA1682066, 8 English WARNING: RISK FROM MOVING PARTS WHAT CAN HAPPEN HOW TO PREVENT IT • Movingpartssuchasthe pulley, flywheel, and belt can cause serious injury if they come into contact with you or your clothing. • Neveroperatethecompressor with guards or covers which are damaged or removed. • Keepyourhair,clothingand gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. • Airventsmaycovermoving parts and should be avoided as well. • Attemptingtooperate compressor with damaged or missing parts or attempting

  • DeWalt DXCMLA1682066, 17 English condensate contains lubricating oil and/or substances which may be regulated and must be disposed of in accordance with local, state, and federal laws and regulations. 1. Set the Auto/Off switch to “Off”. 2. Turn the regulator knob counterclockwise to set the outlet pressure to zero. 3. Remove the air tool or accessory. 4. Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 psi. Release safety valve ring. 5. Drain water from air tank by opening drain valve (counte

  • DeWalt DXCMLA1682066, 21 English Limited Warranty DEWALT Industrial Tools are warranted from date of purchase. 2 Year – Limited warranty on oil-lubricated air compressor pumps. and workmanship during the rst year of ownership, with the exceptions noted below. Parts used in repair of whole goods or accessories are warranted for the balance of the original warranty period. What is not covered Under This Warranty? Failures by the original retail purchaser to install, maintain, and operate said equipment in accordance with standard industry practices. Mod

  • 3 English Hot Surfaces FIG. 2 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay atten- tion to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if not avoide

  • DeWalt DXCMLA1682066, 27 English CODE POSSIBLE CAUSE POSSIBLE SOLUTION 24 Damaged regulator Replace 25 Regulator open Roate the regulator knob counter-clockwise to its built-in stop. 26 Low voltage/motor overload Check that power supply is adequate and that compressor is on a dedicated circuit. If using extension cord, try using without. If compressor is connected to a circut protected by a fuse, use dual element time delay fuses (Buss Fusetron type “T” only). 27 Restricted air passages Inspect and replace transfer tubes or check valve, as required. 28 Low voltage motor Furnish adequate powder. 29 Bad check valve Replace check valve. 30

  • DeWalt DXCMLA1682066, 20 English cally when power is on. When servicing, you may be exposed to voltage sources, compressed air, or moving parts. Before servicing unit unplug or disconnect electrical supply to the air compressor, bleed tank of pressure, and allow the air compres- sor to cool. To Replace or Clean Check Valve 1. Release all air pressure from air tank. See Draining Air Tank in the Maintenance section. 2. Set the Auto/Off lever to “Off”, unplug the unit, and relieve all air pressure from the air tank. 3. Using an adjustable wrench loosen outlet tube nut at air tank and pump. Carefully move outl

  • DeWalt DXCMLA1682066, 4 English • Unattendedoperationofthis product could result in per- sonal injury or property dam- age. To reduce the risk of fire, do no allow the com- pressor to operator unat- tended • Alwaysremaininattendance with the product when it is operating. • Alwaysturnoffandunplug unit when not in use. DANGER: RISK TO BREATHING (ASPHYXIATION) WHAT CAN HAPPEN HOW TO PREVENT IT • Thecompressedairdirectly from your compressor is not safe for breathing. T

  • 9 English WARNING: RISK OF INJURY FROM LIFTING WHAT CAN HAPPEN HOW TO PREVENT IT  • Seriousinjurycanresultfrom attempting to lift too heavy an object.  • Thecompressoristooheavy to be lifted by one person. Obtain assistance from others before lifting. CAUTION: RISK FROM NOISE WHAT CAN HAPPEN HOW TO PREVENT IT  • Under

  • DeWalt DXCMLA1682066, 11 English INSTALLATION Assembly (Fig. 1) Unpack the air compressor. Inspect the unit for damage. If the unit has been damaged in transit, contact the carrier and complete a damage claim. Do this immediately because there are time limitations to damage claims. The carton should contain: • air compressor • operator and parts manuals Check the compressor’s serial label to ensure that you have received the model ordered, and that it has the required pressure rating for its intended use. INSTALLING HOSES WARNING: Risk of unsafe operation. Firmly grasp hose in hand when installing or disconnecting to

  • DeWalt DXCMLA1682066, 18 English W X Y U V U = Full V = Add S = Oil drain plug T = Oil level sight glass R = Oil fill plug Belt Replacement WARNING: This unit starts automatically. ALWAYS shut off and unplug the compressor, and bleed all pressure from the system before servicing the compressor, and when the compressor is not in use. Do not use the unit with the shrouds or belt guard removed. Serious injury could occur from contact with moving parts. Hot surfaces. Risk of burn. Pump head, and surrounding parts are very hot, do not touch (see the Hot Surfaces identied in Fig. 2). Allow compressor to cool prior

  • DeWalt DXCMLA1682066, 25 English Troubleshooting Codes CODE POSSIBLE CAUSE POSSIBLE SOLUTION 1 Fittings are not tight Tighten fittings where air can be heard escaping. Check fittings with soapy water solution. DO NOT OVERTIGHTEN. 2 Defective air tank Air tank must be replaced. Do not repair the leak. WARNING: Risk of bursting. Do not drill into, weld or other- wise modify air tank or it will weaken. The air tank can rupture or explode. 3 Leaking seals Contact a DeWALT factory service center or a D e WALT authorized service center. 4 Defective safety valve Operate safety valve manually by pulling on ring. If valve still

  • DeWalt DXCMLA1682066, 14 English NOTE: After about 30 minutes, If the unit does not operate properly, SHUT DOWN IMMEDIATELY, and contact Product Service. 7. Check all air line fittings and connections/piping for air leaks by applying a soap solution. Correct if necessary. NOTE: Minor leaks can cause the air compressor to overwork, resulting in premature breakdown or inadequate performance. 8. Check for excessive vibration. 9. After 30 minutes, turn the Auto/Off switch to the “Off” position. 10. Close the drain valve. 11. Turn the Auto/Off switch to the “Auto” position. The air receiver will fill to “cut-out” pressure and the motor will stop. The compre

  • DeWalt DXCMLA1682066, 7 English WARNING: RISK OF HOT SURFACES WHAT CAN HAPPEN HOW TO PREVENT IT • Touchingexposedmetalsuch as the compressor head or outlet tubes, can result in serious burns.  • Nevertouchanyexposed metal parts on compressor during or immediately after operation. Compressor will remain hot for several minutes after operation  • Donotreacharound protective shrouds or attempt maintenance until unit has been allowed to cool. WARNING: RISK OF ELECTRICAL SHOCK WHAT CAN HAPPEN HOW TO PREVENT IT • Yourcompressor

  • DeWalt DXCMLA1682066, 2 English Air Compressor A. Pump Air Intake Filter B. Auto(-)/Off(O) Switch C. Air Tank Pressure Gauge D. Regulated Pressure Gauge E. Pressure Regulator F. Air Outlet G. Safety Valve H. Air Tank Drain Valve I. Pump Oil Fill Plug J. Pump Oil Drain Plug K. Check Valve L. Quick Connect Pump Specifications 2 Cylinder Single Stage Oil Lubricated Cast iron crankcase, cylinder, and aluminum head Weight: 30.5 lbs (13.8 kg.) Oil Capacity: 11.35 oz. (336 mL) Specifications MODEL DXCMLA1682066 WEIGHT 159 lbs. (72 kg) HEIGHT 50.12" WIDTH 24.12" AIR TANK CAPACITY 20 gallons (75,7 liters) APPROX. BLOW OFF PRESSURE

  • DeWalt DXCMLA1682066, 24 English Code Air leaks .................................................................................................................................... 1 Air leaks in air tank or at air tank welds ....................................................................................2 Air leaks between head and valve plate ....................................................................................3 Air leaks from safety valve ....................................................................................................

  • DeWalt DXCMLA1682066, 26 English CODE POSSIBLE CAUSE POSSIBLE SOLUTION 13 Carbon build-up in pump Contact a D e WALT factory service center or a D e WALT authorized service center. 14 Belt to tight Check belt tension, see Adjusting Belt Tension under Maintenance. 15 Pulley misalignment See Motor Pulley/Flywheel Alignment under Maintenance. 16 Pump oil is low Add synthetic blend, non-detergent air compressor oil to pump. See Compressor Pump Oil under Maintenance. 17 Detergent type oil being used in pump Drain oil and refill pump w

Related Products and Documents (Air Compressor):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Whirlpool MW8901XS Use & care manual whirlpool/mw8901xs-4P6.pdf 24 Sep 2023 36 2.2 Mb
2 Meinberg GPS167LCD-MP Operating instructions manual meinberg/gps167lcd-mp-155.pdf 04 Nov 2023 48
3 Peavey PV 10 Operation manual peavey/pv-10-K38.pdf 12 Oct 2023 36 4.63 Mb
4 Brother HL-1260 Operation & user’s manual brother/hl-1260-CB4.pdf 20 Sep 2022 271 1.69 Mb
5 Siemens KTL Operating instructions manual siemens/ktl-ZM3.pdf 22 Feb 2023 20 0.22 Mb
6 Peebles Originals PO-386 Assembly notes and construction peebles-originals/po-386-J5S.pdf 19 Jan 2023 9

Similar Resources:

  • Sullair

    LS-10 25HP 24KT

    (90 pages)
    Part Number 02250105---114eSullair CorporationOPERATOR’SMANUAL ANDPARTS LISTKEEP FORFUTUREREFERENCE25, 30 & 40 HPINDUSTRIAL AIRCOMPRESSORL S --- 1 0STANDARD & 24 KT18, 22 & 30 KW …
  • Bush Power

    WM102-7C

    (2 pages)
    Bushpower 100 Links Road StMary’s NSW 2760 Phone: +61 2 98333 444 www.bushpower.com.au 4 Air Hose Pressure Gauge Quick Coupling Tyre Chuck Battery Clamps Accessories BUSHPOWER TWIN CYLINDER 150PSI AIR COMPRESSOR WM102-7C 1 …
  • nardi

    Atlantic 100

    (12 pages)
    Instruction Manual ATLANTIC 100 Page 1 This manual contains operating instructions and maintenance schedules for the high pressure breathing air compressors. Operators must read and understand all information inside the manual. ATTENTION. This machine can be used only after a careful reading of this instruction manual. The machine may only used to produc …
  • GEA

    Bock LR

    (8 pages)
    09900-01.2012-DGbFBock LR LeistungsreglerBock LR Capacity regulationBock LR Régulation de puissance1Sehr geehrter Kunde,der Bock-LR-Leistungsregler ist ein hochwertiges, zuverlässiges und servicefreundliches Qualitätspro-dukt aus der Bock-Zubehörfamilie. Um die Vorteile der efzienten Leistungsregelung in vollem Umfang und über den gesamten Einsatzzei …
  • BendPak

    RS7580H603

    (48 pages)
    INSTALLATION AND OPERATION MANUALSHIPPING DAMAGE CLAIMSWhen this equipment is shipped, title passes to the purchaser upon receipt from the carrier. Consequently, claims for the material damaged in shipment must be made by the purchaser against the transportation company at the time shipment is received.BE SAFEYour new Compressor was designed and built with …
  • Powermate

    PA0601512

    (8 pages)
    200-2400Revision AParts ManualManuel de piècesManual de piezasOilless, Single Stage, Direct Drive, Electric Air CompressorSans l’huile, d’un seule étape, à prise directe, compresseur d’airélectrique Sin aciete, de una sola etapa, de mando directo, compresor de aireeléctricoSpecification Chart________Tableau des spécifications_______Cuadro de espe …

Comments, Questions and Opinions: