AOR AR-STV Operating Manual

Text of AOR AR-STV User Guide:

• AOR AR-STV, TABLE OF CONTENTS 1 Introduction -------------------------------------------------------------------------------------- 2 1-1 Maintaining the unit --------------------------------------------------------------------------- 2 1-2 Power requirements -------------------------------------------------------------------------- 2 1-3 Supplied accessories ------------------------------------------------------------------------ 3 1-4 Features ------------------------------------------------------------------------------

• AOR AR-STV, 1 Introduction Thank you for purchasing the AR-STV Wireless Camera Detector. The AR-STV is a wireless camera receiver with a 2.5 inch color LCD display, still picture recorder and sensor that captures analog video signals in real-time. It is mainly designed for use in surveillance applications. Its built-in clock allows images to be time-stamped and a (non-supplied) SD memory card can be used to store images. © This manual is protected by copyright AOR, LTD. 2013. No information contained in this manual may be copied or transferred by any means without the prior wr

• AOR AR-STV, 1-3 Supplied accessories The following accessories are provided in the shipping box.  Instruction manual (this booklet)  Flexible rubber antenna  Belt clip  Soft case  Four AA size Ni-MH battery cells  DC power supply / battery charger 1-4 Features  Built-in 2.5 inch color LCD display  Built-in clock for time stamp  Store images on a (non-supplied) SD (or SDHC) memory card  Detect NTSC, PAL, CCIR, EIA or scrambled reverse polarity video signals  Receives and displays video signals on L-band (1.2 GHz) or S-band (2.4 GHz) 

• AOR AR-STV, Left View Right View Right Side of the AR-STV 1 Power ON/OFF switch 2 CONT (USB connector) 3 VIDEO (Video Output connector) Slide the power switch upward to switch on the AR-STV. To switch off the AR-STV, slide the switch downward. Using a USB A ←→ USB Mini (B) cable (not supplied), connect between the CONT (Control) connector and a PC to download images whi ch have been previously This 3.5 mm mono connector provides the composite video output. An external video monitor may be connected. 4

• AOR AR-STV, 4 DC 6V (External power input connector) 5 SD (SD, SDHC memory card slot) 6 ALM OUT (Alarm output connector) Pin assignment of the connector: Tip --- Beep output and alarm output Ring --Relay output (this pin will make a short circuit to the ground for 2 seconds after a video signal is detected) (Relay specifications: 50 V DC, 150 mA max.) Sleeve--- Ground To charge the internal Ni-MH cells, connect the supplied DC power supply into this connector. Note that the center pin of the jack is positive. Insert a (

• AOR AR-STV, Left Side of the AR-STV 7 MODE (Mode selector) switch 8 REC (Record) switch 9 FREQ UP DOWN (Frequency selector switch) 2-2 Rear panel Press this switch to select the operation mode. Press this switch to store image onto memory. Press this switch upward/downward to change the receive frequency or change search direction. With the supplied belt clip attached. Battery compartment 6

• 3 Connections Connect the supplied flexible rubber antenna to the SMA antenna connector on the top of the AR- STV. If required, an external antenna may be connected with a SMA connector for the coaxial cable. Insert the supplied 4 AA size Ni-MH cells into the battery compartment in the AR-STV. If the batteries are not yet charged, connect

• AOR AR-STV, (1) 1G 2G 3G (Hz) The horizontal axis displays the receive frequency. The AR-STV can receive between 900 MHz and 2800 MHz. (1G indicates 1 GHz in frequency, 2 G for 2 GHz, and 3 G for 3 GHz accordingly.) (2) V (Video level) N (Noise level) Video Level The V (Video) line on the vertical axis displays the video quality threshold level. Note that video level is NOT related to the signal strength. Setting the video threshold level higher will display the video signal only with the better quality. Setting the video threshold level lower wi

• Icon legend: Signal level Battery level SD card inside Search mode Search bank Receive freq. 5-2-1-1 Frequency adjustment To change the receive frequency, press the FREQ. switch upward or downward. 5-2-1-2 Recording image To record the received image, press and hold the REC sw

• AOR AR-STV, 1. On the Search Mode screen, press and hold the MODE switch for 3 seconds 2. The following search bank setting screen will appear. Search: Search bank number 0 ~ 9. To change the search bank, press the MODE key. Start: Select the start frequency. (Frequency range: 900 ~ 2800MHz). On above example, 09 is highlighted in reverse color and 900 MHz has been set as the start frequency. To change the first 2 digits, press the FREQ. Switch inward. The highlighted area will change into g

• AOR AR-STV, Step: Select the search frequency step. (Entry range: 2 ~ 10 MHz) To change the parameter, perform the same procedures as the start frequency entry. Noise Level: Select the noise threshold level. (Entry range: -30 ~ -80 db min 5 dB increments) Suggested level: 75 (for normal search) 0 (for weak signal) Run: Select the search bank enable or disable. To change the parameter, perform the same procedures as the start frequency entry Video Level: Select the video threshold level. (Entry range: 0 ~ 95 %) Suggested leve

• AOR AR-STV, Icon legend: Signal level Battery level SD card inside Search mode Search bank Receive freq. 5-2-2-1 Scroll memory channel To scroll the memory channel, press the FREQ. switch upward or downward. 5-2-2-2 Slide show To start a slide show of the recorded frequencies, press and hold the FREQ. switch for 3 seconds. 5-2-2-3 Change memory contents To change the recorded frequency of the memory channel, perform the following steps: 1. Press and hold the MODE switch for 3 seconds. 2. The frequency on t

• AOR AR-STV, To return to the search mode, press the MODE switch and REC switch simultaneously three times. (The operation mode will toggle between the Search mode, Memory mode, SD card mode, and setting mode.) 5-2-3 Setting mode There are two (2) setting pages: Setting 1 and Setting 2. 5-2-3-1 Setting 1 screen Press the MODE switch and REC switch simultaneously several times (depending on the current operation mode). (Press the blue button to proceed directly to the settings 2 screen if needed.) Date and Time: Set current date and time for time stamp. View Time: Du

• 5-2-3-2 Setting 2 screen Press the MODE switch and REC switch simultaneously several times (depending on the current operation mode) until the SETTINGS 1 screen appears, then press the blue button to get to the SETTINGS 2 screen LCD/AVOUT: Video signal output selection. (Parameter LCD/ AV OUT) LCD: Displays on the LCD AV OUT: Output from the VIDEO jack. (Note: AV

• AOR AR-STV, OFF: Detected image will NOT be saved on the SD memory card automatically. NTSC/PAL: Video detector mode (Parameter: NTSC/ PAL) Select the video receive mode. Power Save: Battery power save function (Parameter: ON/ OFF) ON: To save battery consumption during search, the power to the LCD will be turned off. If there is no activity for more than 30 seconds, the power to the LCD will also be turned off. OFF: This function will be disabled. Relay: Activate

• AOR AR-STV, 6 Specifications Frequency Coverage: 900 ~ 2,800 MHz continuous Receive Mode: FM Video Receiving system: Single conversion super heterodyne IF (Intermediate frequency): 479.5 MHz Memory channels: 10 Search banks: 10 Search speed: Approx. 6 seconds for entire range (@10MHz steps) Frequency step: 2 MHz ~ 10 MHz (in 1MHz incremental) Sensitivity: -79 dBm (@1.2 GHz) -83 dBm (@2.4 GHz) Antenna impedance: 50Ω Antenna connector: SMA Antenna: Dual band flexib

• 7 LIMITED WARRANTY (for U.S.A only) AOR USA, Inc. (AOR) warrants its products as described below. AOR will repair or exchange equipment as a result of defects in parts or workmanship for a period of one year from the date of original retail purchase from an authorized AOR dealer. Exclusions: The following items are not covered by the AOR limited warranty

• AOR AR-STV, Manufacturer: AOR, LTD. 2-6-4, Misuji, Taito-Ku, Tokyo, 111-0055, Japan URL: www.aorja.com US distributor: AOR USA, INC. 20655 S. Western Ave. Suite 112 Torrance, CA 90501 Phone: 310-787-8615

More Instructions:

AOR AR-STV Instruction manual 28-03-2024 16

DOWNLOAD

Related Products and Documents (Security System):

Comparable Devices:

Similar Resources:

• Satel SPL-5010 (4 pages) SPL-5010 OPTICAL-ACOUSTIC OUTDOOR SIREN spl5010_en 10/16 The SPL-5010 siren provides information about alarm situations by means of optical and acoustic signaling. 1. Features  Acoustic signaling by means of piezoelectric transducer.  Optical signaling by means of LEDs.  Weatherproofed electronic circuit.  Tamper protection in 2 ways – …

• VTech VC7151 (97 pages) BCVC7151 VC7151-101 VC7151-109 VC7152-201 VC7152-301 Wireless Monitoring System with Cordless TelephoneGo to www.vtechphones.com to register your product for enhanced warranty support and latest VTech product news.User’s manual …

• Viking C-1000B (8 pages) The K-1205 Entry Phone is a two-way, handsfree telephone with 12 but-tons for calling individual residences in an apartment building. It also hasa built-in color CCTV video camera. The rugged stainless steel faceplatehas a printed directory housed in a waterproof, scratch-resistant lens.Each button is beside the tenants name in the directory so there are noc …

• Pima hunter-pro (30 pages) HUNTER-PRO Intruder Alarm System User Manual P/N 4410066 Rev. D (Jan-2004) PIMA Electronic Systems Ltd. 5 Hatzoref Street, Holon 58856, Israel ℡ +972-3-5587722  +972-3-5500442  [email protected]  http://www.pima-alarms.com …

• STI Exit Stopper STI-6400 Series (2 pages) Exit Stopper®Quick InstallSTI-6400 SeriesRely on STI®SET UP1. Key in OFF position3. Remove cover from base, push on lock to separate5. Unwrap battery and connect6. Terminal block (remote power and relay options) – refer to full install online for wiring connections7. Test – place magnet next to reed, turn key switch on, separate magnet from ree …

• Fike Twinflex V3 (56 pages) 26-0338 Issue 10 Twinflex - V3 Fire Detection & Alarm System Control Panel Engineering and Commissioning Manual (TO BE RETAINED BY THE COMMISSIONING ENGINEER) …

Comments, Questions and Opinions: