Manualios.com

Toshiba B-EV4D SERIES Owner's Manual

Toshiba B-EV4D SERIES Manual Online:

3.4, 530 votes
Toshiba B-EV4D SERIES User Manual
Toshiba B-EV4D SERIES User Guide
Toshiba B-EV4D SERIES Online Manual

Text of Toshiba B-EV4D SERIES User Guide:

  • Toshiba B-EV4D SERIES, 4. TROUBLESHOOTING ENGLISH VERSION EO1-33088 4.1 Troubleshooting Guide E4- 1 4. TROUBLESHOOTING 4.1 Troubleshooting Guide Symptom Cause Solutions The power cord is not connected to the Power Adapter. Disconnect the power cord from the AC outlet, connect the power cord to the Power Adapter, then connect it to the AC outlet. (⇒ Section 2.5) There is a power failure or the power is not being supplied to the AC outlet. Test the AC outlet with a power cord from another electric appliance. If pow

  • Toshiba B-EV4D SERIES, GLOSSARIES ENGLISH VERSION EO1-33088 GLOSSARIES Supply Media Tag A type of media having no adhesive backing but black marks to indicate the print area. Usually tags are made of cardboard or other durable material. Thermal print head A print head using thermal transfer or thermal direct printing method.

  • Toshiba B-EV4D SERIES, APPENDIX 1 SPECIFICATIONS ENGLISH VERSION EO1-33088 A1.3 Media EA1- 5 A1.3.3 Detection Area of the Reflective Sensor The Reflective Sensor is movable within the full range of the media width. The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark. <Black Mark> A1.3.4 Effective Print Area The figure below illustrates the relation between the head effective print width and media width. (for GS14 Type) (

  • Toshiba B-EV4D SERIES, CE Compliance (for EU only) This product complies with the requirements of EMC and Low Voltage Directives including their amendments. VORSICHT: Maschinenlärminformations-Verordnung 3. GPSGV, der höchste Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß EN ISO 7779. Copyright © 2008 by TOSHIBA TEC CORPORATION A ll Rights Reserved 570 Ohito, Izunokuni-shi, Shizuoka-ken, JAPAN Centronics is a registered trademark of Centronics Data Computer Corp. Windows is a trademark of Microsoft Corporation. This equipment has been tested and found to comply

  • Toshiba B-EV4D SERIES, 1. PRODUCT OVERVIEW ENGLISH VERSION EO1-33088 1.4 Accessories E1- 2  When purchasing the power cord Since the power cord set is not enclosed in this unit, please purchase an approved one that meets the following standard from your authorized TOSHIBA TEC representative. (As of August 2008) Country Agency Certification mark Country Agency Certification mark Country Agency Certification mark Australia SAA Germany VDE Sweden SEMKKO Austria OVE Ireland NSAI Switzerland SEV Belgium CEBEC Italy IMQ UK ASTA Canada CSA Japan METI

  • Toshiba B-EV4D SERIES, 1. PRODUCT OVERVIEW ENGLISH VERSION EO1-33088 1.5 Appearance E1- 3 1.5 Appearance 1.5.1 Dimensions 1.5.2 Front View 1.5.3 Rear View The names of the parts or units introduced in this section are used in the following chapters. Dimensions in mm (inches) Power Jack Power Switch Fanfold paper slot Parallel Interface Connector (Centronics) USB Interface Connecto r Serial Interface Connector (RS-232C) 198 (7.8) 258 ( 10.2 ) 173

  • Toshiba B-EV4D SERIES, 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.7 Loading the Media E2- 8 2.7 Loading the Media (Cont.) 2. Slide the Media Holder Lock Switch to the Unlock (▲) side to release the Media Holders. 3. Open the Media Holders. 4. Place a media roll between the Media Holders so that the media is fed with the print side facing up. Fit the projection of the Media Holders into the core. Make sure that the projection of the both Media Holders is engaged with the core firmly. 5. Turn the Media Guide Adjustment Dial in the arrow indicating direction to move the Media Gui

  • Toshiba B-EV4D SERIES, APPENDIX 1 SPECIFICATIONS ENGLISH VERSION EO1-33088 A1.3 Media EA1- 4 A1.3.1 Media Type (Cont.) Unit: mm (inch) Issue mode Item Batch mode Strip mode Cut mode c Width including backing paper 25.4 to 112 (1.0 to 4.41) d Media width 22.4 to 109 (0.88 to 4.29) 203 dpi 10 to 999 (0.39 to 39.3) 25.4 to 152.4 (1.0 to 6) 25.4 to 999 (1.0 to 39.3) Label 300 dpi 10 to 457.2 (0.39 to 18.0) 25.4 to 152.4 (1.0 to 6) 25.4 to 457.2 (1.0 to 18.0) 203 dpi 10 to 999 (0.39 to 39.3) ----- 25.4 to 999 (1.0 to 39.3) e Media pitch Tag 300 dpi 10 to 457.2 (0.39 to 18.0) ----- 25.4 to 457.2 (1.0 to 18.0

  • Toshiba B-EV4D SERIES, 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.2 Procedure before Operation E2- 2 2.2 Procedure before Operation 2.3 Turning the Printer ON/OFF 2.3.1 Turning ON the Printer This section describes the outline of the printer setup. 1. Unpack the accessories and printer from the box. 2. Refer to Safety Precautions in this manual and set up the printer at a proper location. 3. Make sure that the Power Switch is off. (Refer to Section 2.3.) 4. Connect the printer to a host computer with an RS-232C, Centronics interface, Ethernet cable or USB cable. (Refer to Section 2.4.) 5. Connect the Po

  • 1. PRODUCT OVERVIEW ENGLISH VERSION EO1-33088 1.5 Appearance E1- 4 1.5.4 Interior WARNING! Do not touch the print head or around it just after printing. You may get burned as the p rint head becomes very hot during printing.

  • 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.7 Loading the Media E2-13 2.7 Loading the Media (Cont.) When a media roll has an outside diameter exceeding 127 mm (5”) and the inner core diameter of 76.2 mm (3”), the optional External Media Roll Hanger is required. 1. Fit the

  • Toshiba B-EV4D SERIES, 4. TROUBLESHOOTING ENGLISH VERSION EO1-33088 4.3 Removing Jammed Media E4- 3 Flashing speed of the LED Status Flashing interval Flashing slowly 1 sec. Flashing at medium speed 0.5 sec. Flashing fast 0.2 sec. 4.3 Removing Jammed Media This section describes in detail how to remove jammed media from the printer. 1. Turn the power off. 2. Open the Top Cover and remove the media roll. 3. Remove the jammed media from the printer. DO NOT USE any sharp implements or tools as these could damage the printer. 4. Clea

  • 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.4 Connecting the Cables to the Printer E2- 3 2.3.2 Turning OFF the Printer 1. Before turning off the printer power switch verify that the Indicator Lamp is illuminated in green, not flashing. 2. To turn OFF the printer power press the power switch as shown in the diagr

  • Toshiba B-EV4D SERIES, 3. MAINTENANCE ENGLISH VERSION EO1-33088 3.1 Cleaning E3- 2 3.1.2 Platen/Sensors 3.1.3 Cover 3.1.4 Media Housing 1. Wipe the Platen with a soft cloth moistened with absolute ethyl alcohol. 2. Remove dust or paper particles from wipe the Black Mark Sensor, Feed Gap Sensor, and Cover Open Sensor with a dry soft cloth. Wipe the Cover with a dry soft cloth. Wipe off dirt with a soft cloth slightly moistened with mild detergent solution. Wipe the media housing with a dry soft cloth. Wipe off dirt with a soft cloth slightly moistened with mild detergent solution.

  • Toshiba B-EV4D SERIES, 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.1 Precautions E2- 1 2. PRINTER SETUP 2.1 Precautions This section outlines the steps necessary to setup your printer prior to its operation. The section includes precautions, connecting cables, assembling accessories, loading media, and performing a test print. To insure the best operating environment, and to assure the safety of the operator and the equipment, please observe the following precautions. • Operate the printer on a stable, level, operating surface in a location free from excessive humidity, high temperature, dust, vibration

  • 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.7 Loading the Media E2-11 NOTES: 1. When issuing labels without removing them from the backing paper, it is not necessary to pass the media through the Strip Block. 2. When the media is correctly set, the backing paper is supposed to be pinched by the Platen and the Strip Feed Roller as shown below. 3. If the pe

  • Toshiba B-EV4D SERIES, 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities E2-16 2.8.2 Self Print Test and Dump Mode (Cont.) The test print contents should be changed by the following commands and parameters: PROGRAM VERSION: VX.XX XXXX --- Firmware version and checksum TONE ADJUST: +XX ------------------------- Print tone fine adjustment value FEED ADJUST: +XX.Xmm ------------------ Print position fine adjustment value CUT POSITION ADJUST: +XX.Xmm ----- Cut position fine adjustment value BACKFEED ADJUST: +XX.Xmm ---------- Back feed am

  • Toshiba B-EV4D SERIES, 2. PRINTER SETUP ENGLISH VERSION EO1-33088 2.6 Opening/Closing the Top Cover E2- 6 2.6 Opening/Closing the Top Cover When opening or closing the Top Cover, please be sure to follow the instructions below. To open the Top Cover: 1. Press down the Top Cover Release Button to unlock the Top Cover, then fully open the Top Cover. As the Top Cover is held by the damper, it does not close under its own weight. To close the Top Cover: 1. Press down the portions of the Top Cover indicated by th

  • Toshiba B-EV4D SERIES, GLOSSARIES ENGLISH VERSION EO1-33088 GLOSSARIES GLOSSARIES Bar code A code which represents alphanumeric characters by using a series of black and white stripes in different widths. Bar codes are used in various industrial fields: Manufacturing, Hospitals, Libraries, Retail, Transportation, Warehousing, etc. Reading bar codes is a fast and accurate means of capturing data while keyboard entry tends to be slow and inaccurate. Batch mode Issue mode that continuously prints media until the required number has been p

More Instructions:

DOWNLOAD

Related Products and Documents (Barcode Reader):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Marantz SM-11S1 Manual de usuario marantz/sm-11s1-I47.pdf 24 Jan 2024 31
2 Pioneer GM-D8601 Owner's manual pioneer/gm-d8601-8UW.pdf 16 Nov 2022 92
3 Samsung WF501ANW Operation & user’s manual samsung/wf501anw-62K.pdf 20 Jun 2022 132
4 Panasonic NI33GX - ELEC. STEAM IRON-LOW Operating instructions manual panasonic/ni33gx-elec-steam-iron-low-DQ2.pdf 10 Mar 2023 10 0.37 Mb
5 Electrolux EWS 1054 EDU Operation & user’s manual electrolux/ews-1054-edu-L75.pdf 19 Dec 2022 24 7.09 Mb
6 Asus P-P55TVP4 Operation & user’s manual asus/p-p55tvp4-25F.pdf 14 Nov 2023 64 0.72 Mb

Similar Resources:

  • Uniden

    SUNDOWNER UH-011

    (10 pages)
    Uniden UHF, Marin Radios & Scanners Resetting Procedure Updated on 04/11/2016 UHF Radios: Model No: UH011 Turn the unit off, Press and hold “TSQ” & “DUP” buttons together at the same time and turn the power back on. After 15 seconds turn power back off then turn on Model No: UH012SX Turn the unit off, Press and hold “INST” & …
  • GPRINTER

    GP-3120TN

    (85 pages)
    PROGRAM MANUAL Direct thermal barcode printer & Thermal transfer label printer GP-3120TN GP-9035T GP-3120TL GP-9034T GP-3150TIN GP-9026T GP-1524D GP-9025T GP-1625D GP-1125T GP-1225D G …
  • Fcar

    F501 EOBD

    (15 pages)
    Operating Guide for Fcar Code Readers 1 Statement  The publication is designed only for the use of FCAR products, and any organization or individual shall not reproduce and back up this Guide in any form (in electronic, mechanical, photocopying, recording forms or other forms) without the written permission of …
  • SEM

    iWitness

    (30 pages)
    Security Engineered Machinery Co., Inc USER’S MANUAL For SEM iWitness Media Tracking System MAN-029 Rev. 0 Created 04/20/2018 Security Engineered Machinery Co., Inc. NATIONWIDE SERVICE Phone Toll Free: (800) 225-9293 Email: [email protected] Website: WWW.SEMSHRED.COM …
  • Datalogic

    DS6300

    (24 pages)
    DS6300 QUICK REFERENCE GUIDE NOTE This manual illustrates Local Lonworks network applications. For other types of installations, such as ID-NET™, Pass-Through, Multiplexer Layout, etc., refer to the DS6300 Reference Manual available on the CD. For complete scanner configuration using the Genius™ configuration program re …
  • Code

    CR1400

    (20 pages)
    CR1400User Manualwww.codecorp.com YouTube.com/codecorporationCONFIGURATION GUIDEConfiguration barcodes generated based on current firmware versionsWEB GENERATED12-3-2015 …

Comments, Questions and Opinions: