Esport Phoenix Assembly Instructions Manual

Text of Esport Phoenix User Guide:

• Esport Phoenix, 2 Phoenix Instruction Manual VITAL SAFETY INFO CAUTION! The Phoenix is not a toy. It can cause injury to persons/animals and/or property if not used correctly. It is unsuitable for persons under the age of 14. You should take care and observe the principles of safety when fl ying this model. In the UK, we recommend you observe the British Model Flying Association (BMFA) safety code at all times, which can be found at the following address: http://www.bfma.org In Australia, please contact your hobby supplier or the Model Aircraft Association of Australia (MAAA). YOU ASSUME ALL RISK. Before beginning construction, please read this document thoroughly and familiarize yo

• Esport Phoenix, 3Phoenix Instruction Manual KIT CONTENTS CONTENTS LIST 2.4 GHz Transmitter and Receiver (Only included in RTF complete set) Fuselage Main Wing w/Carbon Fibre Spar Horizontal Tail Fin and Rudder Outrunner Brushless Motor 1050Kv (pre-installed) 20A ESC (pre-installed) 3-Cell 11.1V 1500mAh Li-poly Battery Li-poly Balance Charger for 2-3 Cells (Only included in RTF complete set) 4-9 gram Servos (pre-installed) 4-Bladed Propeller Mains power supply (Only included in RTF complete set) Wrench / Hex Key ADD

• Esport Phoenix, 4 Phoenix Instruction Manual LITHIUM POLYMER BATTERY SAFETY BEFORE CHARGING LI-PO’S ■ Before charging your battery check for any damage e.g. check if the battery has expanded or swollen in size or if the battery cells have been punctured. If any of the above is true: DO NOT CHARGE THE BATTERY! CHARGING LI-PO’S ■ Only use a charger designed to charge Lithium polymer batteries. Never use a nicad or other charger as this is very dangerous. ■ Never attempt to charge at a rate faster than that recommended in the instructions. Check that the bat

• Esport Phoenix, 5Phoenix Instruction Manual CHARGING THE FLIGHT BATTERY Mains power supply (only included in RTF complete set) 12V Charger (Only included in RTF complete set) LiPo Battery The charger is designed to automatically charge the LiPo battery in about an hour from a discharged state. The 12V DC automatic charger is powered by the mains power supply illustrated above. Alternatively, you can use a 12V sealed modelling battery to power the DC automatic charger. 1. Connect the charger to the power source. The power LED will light Red and the charge LED will light Green. 2. Plug the white 3-pin connector

• Esport Phoenix, 6 Phoenix Instruction Manual ASSEMBLING THE PHOENIX 1. Locate the carbon fi bre spar and left hand wing panel. 2. Gently push the carbon fi bre spar into the left hand main wing panel until it is fully inserted. 3. Insert the other end of the carbon fi bre spar into the wing opening of the fuselage. 4. Leave enough room to connect the servo plug for the left hand aileron servo into the socket on the left hand side of the fuselage. 5. Check the black wire of the plug lines up with the black wire of the socket. 6. Now push the wing all the way into the fuselage.

• 7Phoenix Instruction Manual 7. Locate the right hand wing panel and slide it on the right hand end of the carbon fi bre spar. 8. Leave enough room to connect the servo plug for the right hand aileron servo into the socket on the right hand side of the fuselage. Check the black wire of the plug lines up with the black wire of the socket. 9. Now push

• Esport Phoenix, 8 Phoenix Instruction Manual 12. Use 5 minute epoxy glue (available separately), and press the horizontal tail into position and hold for at least 5 minutes to ensure a good bond. Note: We recommend that you use 5 minute epoxy to glue the horizontal tail and vertical fi n as this will provide a more permanent fi xing. 13. Dry fi t the vertical fi n to confi rm a good fi t. Note: Check the verticle fi n will be epoxied at 90 degrees to the horizontal tail. 14. Epoxy the vertical fi n to the fuselage and horizontal tail. Hold in place for at least 5 minutes to ensure a good bond. Note: Re-check while the epoxy is setting that the verti

• Esport Phoenix, 9Phoenix Instruction Manual 16. Insert the rudder pushrod wire into the easy connector. Tip: Bend the end of the pushrod wire with pliers as shown to reduce the strain on the horn. Note: Do not tighten the grub screw with the wrench/hex key just yet. You may need to adjust this later to ensure a neutral setting for the elevator once the transmitter and plane are turned on. 17. The fl ight battery slides in place in the hollow compartment in the nose of the fuselage. Push the battery all the way forward so it is held securely by the sides of the fuselage. Tip: Velcro (purchased separately) may also be used to secure the b

• Esport Phoenix, 10 Phoenix Instruction Manual ASSEMBLING THE PROPELLER 20. For safety, always ensure the fl ight battery is disconnected before attaching the propeller. 21. Locate the four blade propeller. 22. Install the propeller on the motor shaft. Note: Locate the grub screws over the fl at spot on the motor shaft. The fl at spots help secure the propeller and prevent it falling off in fl ight. 23. Tighten the grub screws on either side of the spinner with your wrench/hex key.

• 11Phoenix Instruction Manual The Escale transmitter is only inlcuded in the RTF complete set. If you are using your own transmitter please follow the instructions for that transmitter. 24. Locate 2.4GHz. Transmitter. 25. Install 8-AA batteries (sold separately) into the battery compartment located in back of Transmitter case. 26. Turn on the transmitter by pushing the ON/

• Esport Phoenix, 12 Phoenix Instruction Manual TRANSMITTER LAYOUT MODE II TRANSMITTER LAYOUT 28. Left Stick is Throttle (up and down) and Rudder (side to side) 29. Right Stick is Elevator (up and down) and Ailerons (side to side). 30. Retract (Ch.5) switch is on Right front. (Not used on Phoenix). 31. Servo reversing switches across lower front of case. 32. Fine trim adjustments for 4 main channels. Please see the EScale Transmitter Manual for more detailed instructions on Transmitter functions Throttle High Throttle Low Rudder Right Rudder Left Elevator Down Elevator Up Aileron Right Aileron Left Retract switch Ch

• Esport Phoenix, 13Phoenix Instruction Manual CONTROL CHECKS 43. Elevator is controlled by the elevator stick. Check that the direction and distance of movement is correct. 44. Stick toward the bottom of the transmitter the elevator should move up. When moved toward the top of the transmitter the elevator should move down. 45. Adjust the position of the pushrod to get approx. 1/2” (13mm) in each direction. Note: Tighten the grub screw with the wrench/hex key. It is important to secure the pushrod in the easy connector so that it will not come loose in fl ight 46. Rudder is controlled by the rudder stick. Check that the direction and distance

• 14 Phoenix Instruction Manual PREFLIGHT CHECKS If you are new to fl ying R/C aircraft, or even an experienced modeller, we recommend you have a fellow R/C modeller help you with the fi rst fl ight. Some items you will need to complete on your fi rst prefl ight are: 1. Aircraft assembled correctly and ready for fl ight. 2. All control throws are set per

• Esport Phoenix, 15Phoenix Instruction Manual FLYING Ask another person to launch the Phoenix into the wind horizontally with the nose slightly up, but no more than 15 degrees. Smoothly advance the throttle. After a few feet apply a small amount of up elevator and the model will begin to climb. Continue to climb out at a shallow angle until you reach an altitude of 75 to 100 feet and level off. Adjust the fl ight surface trims until the model fl ies wings level without a tendency to climb or dive. When making a landing approach a small amount of throttle should be maintained. When the throttle is completely off the large 4-bladed prop creates a great dea

• Esport Phoenix, With Brushless Motor and 4-Bladed Prop Australasian agents: Model Engines, Melbourne, Australia www.modelengines.com.au European agents: J Perkins Distribution, Lenham, England www.jperkinsdistribution.co.uk 07.09

More Instructions:

Esport Phoenix Assembly instructions manual 16-03-2023 16

DOWNLOAD

Related Products and Documents (Toy):

Comparable Devices:

Similar Resources:

• VTech Toot-Toot Drivers Motorised Train (3 pages) MOTORToot-Toot Drivers Motorised TrainUser’s ManualWARNING: All packing materials, such as tape, plastic sheets, packaging locks and tags are not part of this toy, and should be discarded for your child’s safety.NOTE: Please keep user’s manual as it contains important information.WARNING: For your child’s safety, only use the motorised train on To …

• TWM 1/3 PAULISTINA P-56 (16 pages) * Specifications are subject to change without notice. *Requires: 80 c.c. gasoline engine, 4-channel radio w/ 6 high torque servos.INSTRUCTION MANUALWarning! This model is not a toy.It is designed for maximum performance. Please seek advice if one is not familiar with this kindof engine powered precision model. Operating this model witho …

• Seagull Models JUNKERS CL1 G-BUYU (34 pages) 1ASSEMBLY MANUALJUNKERS CL1 G-BUYUCode: SEA275Specications:Wingspan---------------68.9 in (175 cm).Wing area---------------776.6 sq.in ( 50.1 sq.dm).Weight-------------------8.8 lbs (4.0 kg).Length-------------------48.3 in (122.6 cm).Engine-------------------10cc - 15cc.Radio--------------------4 channels with 5 servos.“ Graphics and specications ma …

• RUSTA CAPELLA (12 pages) SEENG NO FIDEManual/Bruksanvisning/Gebrauchsanweisung/KäyttöohjeStar on standStjärna på fot / Stjerne på fot / Stern auf Stender / JalustatähtiCAPELLAItem no. 771413270101 …

• Quadro mdb A0270 (8 pages) Benötigte Produkte:Products needed:Copyright ©1979–2021 QUADRO DER GROSSBAUKASTEN. All rights reserved. This model is an exclusive part of the QUADRO Model Database.ACHTUNG: Vor dem Gebrauch die Sicherheitshinweise sorgfältig durchlesen!CAUTION: Please read the safety instructions carefully before you start assembling!AufbauanleitungConstruction ManualD …

• Tabletop Scenics ORC SMACK BAR (7 pages) ORC SMACK BAR CONSTRUCTION GUIDEPAGE 1 / 7KROMLECH SUPER GLUE KROMLECH HEAVY DUTY KNIFEKROMLECH SUPER GLUE ACTIVATORKROMLECH PVA GLUE KROMLECH CUTTING MAT!1 2+DRY TEST GLUE DON’T GLUEPAY ATTENTIONCUT/TRIM WITH CAREEXTRA PARTCONSTUCTION ORDEREXPLANATION OF SYMBOLSRECOMMENDED ACCESSORIESNOTE: These instructions are available online at: http://www.tabletops …

Comments, Questions and Opinions: