Manualios.com

Ikelite 5510.45 Instruction Manual

Ikelite 5510.45 Manual Online:

3.6, 1921 votes
Ikelite 5510.45 User Manual
Ikelite 5510.45 User Guide
Ikelite 5510.45 Online Manual

Text of Ikelite 5510.45 User Guide:

  • Ikelite 5510.45, Thank you for your purchase of Ikelite equipment. Please read this instruction manual completely before attempting to operate or dive with this product. Please refer to the back page of this manual to register your Ikelite product. 8 in. Dome with Shade 5510.45 I n s t r u c t i o n M a n u a l

  • Ikelite 5510.45, 2 #$-'0(0/4'/43 Important Notice ............................................P. 3 Port Bodies ....................................................P. 4 Install Port Bodies on the 8” Dome ................P. 5 Install Port on a Housing................................P. 6 Remove Port from a Housing............................P. 8 Port Shade Alignment........................................P. 8 Port Lock Information ....................................P. 9 Port Shade Installation/Removal....................P. 10 Port Seal - Inside View ..................................P. 12

  • 3 .1024#/404+%' Port bodies are engraved with a Maximum Depth Rating; “RATED 200 FT (60m).” They are engraved on the flat flange that rests against the front of the camera housing; see illustration. Older standard and extended port bodies that are NOT engraved have a Maximum Depth Rating of 150 ft. (45m). The unmarked standard or extended port bodies can be returne

  • 4 0240&+'3 For information on the full selection of 8 in. dome port bodies, please visit 777+,'-+4'%0.. II IV Dome with Shade 5510.45 Extended Body 5510.24 Standard Body 5510.16 Super Wide Body 5510.11 Camera Housing / Port Opening Dome Shade Base Plate Cut-outs

  • Ikelite 5510.45, 5 /34#--0240&+'30/4*':0.' Install bodies by screwing them into the base plate of the 5510.45 dome port. The seal between the body and the dome base plate is a side to side seal and requires the o-ring to be lightly lubricated for easy installation. Remove the body/base plate o-ring, put a small amount of lubricant on your fingers and pull the o-ring through your fingers to lightly lubricate it. Do not stretch t he o-ring. Check that the o-ring groove in the body where the o-ring fits and the sealing surface on the port base plate are clean. Replace the o-ring onto the body and then screw the body into the base plate of the dome port. S

  • Ikelite 5510.45, 6 /34#--0240/#053+/) There are four port locks on the front of the housing. Each port lock has a release button. Lift the release button and slide each port lock away from the port opening. In the unlocked position, the release button will remain in the “up” unlocked position as shown. When using the 5510.11 superwide port body, the port locks must be in the “down” locked position. Refer to your 5510.1 1 i nstruction manual for this installation. Port Lock Release Button Lift Release Button to Unlock Pull Back to Disengage Port “Up” Unlocked Position “Down” Locked Position IKELITE Port Locks 0240%,

  • Ikelite 5510.45, 7 /34#--0240/#053+/)%0/4 To prepare the port for installation, remove the port o-ring and lightly lubricate it. The port seal is a side-to-side seal and requires the o-ring to be lightly lubricated for easy installation. Put a small amount of lubricant on your fingers and pull the o-ring through your fingers to lightly lubricate it. Do not stretch the o-ring. Check that the lip of the port where t he o-ring fits and the sealing surface on the housing are clean. Place the port, with o-ring, into the housing port opening. Press down on the port firmly and evenly until you feel the port slide into place. Continue

  • Ikelite 5510.45, Cut-out Cut-out 8 '.06'024 (20.#053+/) '8%'147+4*51'27+&'0240&9 To remove the port, lift up on each Port Lock Release Button and slide the port lock away from the port. Lift port from housing. The o-ring may be left in the port hole of the housing when the dome port is removed. Replace the o-ring in the proper position on the port body before reassembling the housing and dome port. To remove a port with a 551

  • Ikelite 5510.45, 04'The Low Profile Port Locks work with all Ikelite port bodies. Once they have been installed, there is no reason to replace them. 0240%,/(02.#4+0/ 7*'/53+/)4*'51'27+&'0240&9 When using the 5510.11 superwide port body, unmodified (2-port lock housings) produced prior to March 2006 require the installation of low-profile port locks (now standard on all DSLR housings). These may b e p urchased through your local Ikelite dealer or directly from Ikelite. Request two 9072.24 port locks when ordering. All Ikelite digital SLR hou

  • Ikelite 5510.45, 10 024*#&'/34#--#4+0/'.06#- - Reference illustrations on page 11. 1. Place the port shade on a flat surface with the cut-out section face down +)1#)' . 2. Loosen the four set screws with the Allen wrench. The set screws do not have to be removed, unscrew them until the face of the set screw does not protrude beyond the inside face of the dome shade. 3. Carefully place the port inside the s hade with the dome face down +)1#)'. The dome port should rest on the two inner ledges of the shade

  • Ikelite 5510.45, Set Screws Insert the Dome Port face down Set Screws Inner Ledge Allen wrench Tighten all four set screws with Allen wrench Place Dome Port shade on a flat surface with cut-outs face down  +)52'  +)52'  024*#&'/34#--#4+0/'.06#-%0/4 11

  • 024'#-/3+&'!+'7 Due to the wide overhang of the port flange, the port seal is most visible when viewed by looking inside the housing before the camera is inserted. After the port is installed check to see that the o-ring is properly sealed as shown in +)52' and not extruded as shown in +)52'. +)52' +)52&a

  • Ikelite 5510.45, 14+0/#-'1-#%'.'/42+/)3 #11-+'340#--1024$0&+'3 O-rings can last for several years if properly maintained, but it is wise to carry spare o-rings when traveling in case one becomes misplaced or damaged. Body/Base Plate O-ring 0132.41 Housing/Port O-ring 0105 13

  • Ikelite 5510.45, For prolonged storage the port should be removed from the housing and the body removed from the dome port. The housing-to-port o-ring and body-to-base plate o-rings should be removed, cleaned, and lightly lubricated. Cover the dome with protective neoprene cover when not in use.   When the port will not be used for prolonged periods we recommend removing the port body from the dome port. If the port body is not removed for prolonged periods it can make removal difficult. Never use spray lubricants as the propellant ingredient can cause cracking in this product, or swelling of the o-rings. #+/4'/#/%' Af

  • Ikelite 5510.45, 15 ,'-+4'+.+4'&"#22#/49 This Ikelite product is warranted against any manufacturing defects for a period of one (1) year from the original date of purchase. Defective products should be returned prepaid to Ikelite. Ikelite will, at its discretion, repair or replace such products, and will return to customer prepaid. All other claims, of any nature are not covered. Except as mentioned above, no other warranty e xpressed or implied, applies to this Ikelite product. This port is warranted by Ikelite to a depth of 200’ (60m). ,'-+4'

  • Ikelite 5510.45, Ikelite is most interested in performing any service to ensure that all products perform as intended. Evidence of purchase date must be provided to obtain warranty service. No prior authorization is required. You may return directly to us or through your dealer. Please include a brief description of the problem, any relevant email correspondence, and/or instructions on what you want us to do. Always inc lude n ame, shipping address, email address, and phone number inside of the package. Send postage paid to: Ikelite Underwater Systems Attention: Service Department 50 West 33 Street Indianapolis, IN 46208 USA No reimbursements for postage paid will be issued

More Instructions:

DOWNLOAD
DOWNLOAD

Related Products and Documents (IP Camera):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 AOpen AX4SG-GN Online manual aopen/ax4sg-gn-OV7.pdf 20 Jan 2024 105 4.25 Mb
2 ASROCK AB350M Operation & user’s manual asrock/ab350m-8R7.pdf 22 Jun 2022 153
3 Campbell Hausfeld WG2020 Operating instructions and parts manual campbell-hausfeld/wg2020-5YU.pdf 21 Jul 2023 36 0.69 Mb
4 Whirlpool  WTW4950XW Energy manual whirlpool/wtw4950xw-97G.pdf 27 Feb 2023 2
5 Taylor 110CE Technical sheet taylor/110ce-R3J.pdf 25 Mar 2024 2 0.63 Mb
6 Audiovox GMRS862CH Owner's manual audiovox/gmrs862ch-2PC.pdf 10 Mar 2024 28 0.2 Mb

Similar Resources:

  • Moxa Technologies

    VPort 26A-1MP Series

    (23 pages)
     2013 Moxa Inc. All rights reserved. P/N: 1802000261010 Moxa IP Camera VPort 26A-1MP Series Quick Installation Guide First Edition, March 2013 …
  • Jabra

    PRO 920

    (2 pages)
    DATASHEETJABRA® IS A REGISTERED TRADEMARK OF GN NETCOM A/SWWW.JABRA.COMGN Netcom is a world leader in innovative headset solutions. GN Netcom develops, manufactures and markets its products under the Jabra brand name.V03_1112Jabra PRO™ 920Simple. profeSSional. affordable.Jabra PRO 920 is a professional entry-level wireless headset designed for use with de …
  • Eaton

    Crouse-hinds series

    (8 pages)
    1/8Equipos y cuadros para atmósferas explosivas Serie: GUBExplosion protected switchgear equipments and racks Serie: GUBNOR000000116001CHBA000075Instrucciones de usoOperating instructionsInstructions d’utilisationCROUSE-HINDSSERIESå åHWH åiGDPDW MD]]DVWRXSHQtYDãt ]HPL'.0RQWDJHYHMOHGQLQJHQNDQRYDQGUH( VSURJ JUHNYLUHUHV …
  • Edimax

    IC-3116W

    (3 pages)
    The Edimax IC-3116W 720p wireless network camera is a versatile monitoring device ideal for monitoring your home, shop or factory during the daytime or at night. With Edimax Plug-n-View technology, no complicated setup is required and you can easily connect the camera to the cloud and monitor remotely from a smartphone, tablet or laptop. Motion-trigg …
  • Interlogix

    TruVision Line

    (112 pages)
    TruVision IP Dome Open-Standards Quick Start Guide EN TruVision IP Dome Open-Standards Quick Start Guide DE TruVision IP Dome Open-Standards-Kurzanleitung ES Guía de inicio rápido de domo open-standard IP TruVision FR Guide de démarrage rapide du dôme IP TruVision IT Guida di avvio rapido dei modelli a standard aperti di telecamera dome IP TruVisi …
  • Cisco

    Nexus 7000 Series

    (438 pages)
    Cisco Systems, Inc.www.cisco.comCisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the Cisco website at www.cisco.com/go/offices.Cisco Nexus 7000 Series NX-OS MPLS Command ReferenceDecember 2016Text Part Number: OL-24994-02 …

Comments, Questions and Opinions: