Xpresskit XK09-DLPKHO Installation Manual

Text of Xpresskit XK09-DLPKHO User Guide:

• Xpresskit XK09-DLPKHO, Underside of XK09 module Vehicle Application Guide... Type 1. Installation ......................................................................................................................................... ........................................................................................................................................................................ Type 2......................................................................................................................................................................... Type 3 - D2D....................................................................................................

• Vehicle Application Guide Page 2 The doors are locked upon remote start on every type, with the exception of type 5, which does not control door locks. Vehicles 2012 2011 2010 2009 2008 2007 2006 2005 2004 2003 2002 2001 DL-Arm Factory Security DL-Disarm Factory Security DL-Door Lock Control DL-Door Unlock DL-Driver Priority Unlock* DL-Hatch Glass Release DL-Sliding Door Control Driver DL-S

• Xpresskit XK09-DLPKHO, Installation Type 1 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 3 ** The trunk will not open when the ignition is turned ON using the key or remote starter. * The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D. Not required in D2D mode. Pin 5, Blue/Orange (orange on the Acura TSX) Pin 2, Red/Blue (red on the Acura TSX) Pin 1, Brown/Yellow 4 2 4 Programming Button XK09 (-) Neutral Safety (DEI Platforms Only) (+) Accessory (+) Ign

• Xpresskit XK09-DLPKHO, 1 4 3 5 7 2 56 Installation Type 2 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 4 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 10: Black: Ground Input 14: White: Data Bypass 13: Violet/Brown: (-) Hood Output 18: Green: Single Wire CAN 6: Red/White: (-) Trunk Input** 5: Blue: (-) Unlock Input 3: Light Green: (-) Lock Input 1: Blue/White: (-) GWR (status) Input 20 Pin 4, Lt. Green Pin 3, Lt. Green Pin 7, Brown Key side 1: Red/Blue: Data Bypass 2: - 3: - 4: - Remote Starter 3: Gray: (-) Hand

• Xpresskit XK09-DLPKHO, Installation Type3-D2D (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 5 Refer to the Vehicle Wiring Reference Chart on page 15. Connect to Driver-Side Kick Panel. See Vehicle Wiring Reference Chart on page 15. 4 42 4 Programming Button XK09 20 Key side 1: Red/Blue: Data Bypass 2: - 3: - 4: - Remote Starter 3: Gray: (-) Handbrake Sense Output 4: - 2: Green: (-) OutputLock 1: Violet/White: (AC) Tach Output (-) Ground (-) Neutral Safety (DEI Platforms Only) (+) Accessory (+)

• Xpresskit XK09-DLPKHO, 1 435 7 2 56 (-) GWR (status) Output Installation Type3-W2W (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 6 Refer to the Vehicle Wiring Reference Chart on page 15. 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 10: Black: Ground Input 14: White: Data Bypass 13: Violet/Brown: (-) Hood Output 18: Green: Single Wire CAN 6: Red/White: (-) Trunk Input* 1: Blue/White: (-) GWR (status) Input 20 Key side 1: Red/Blue: Data Bypass 2: - 3: - 4: - Remote Starter 3: Gray: (-) Handbrake Sense Output 4: - 2: Green: (-) OutputDoor/Trunk 1: Violet/White: (

• Xpresskit XK09-DLPKHO, Pin 4, Blue (Light Green for Honda Pilot) Pin 5, Pink (White for Honda Pilot) Pin 2, Light Green (Pink for Honda Pilot) (-) Hood Input Installation Type 4 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 7 ** Connect the Rearm wire only if the vehicle is equipped with automatic headlights. * The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D. Not required in D2D mode. 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 10: Black: Ground Input 14: White: Data Bypass 12: Yellow/Black:

• Xpresskit XK09-DLPKHO, Installation Type 5 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 8 Not required in D2D mode. 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 8: Pink: (+) Ignition Input 10: Black: Ground Input 15: Yellow: Security Light (ECM side) 14: White: Data Bypass 12: Yellow/Black: Ground 17: Orange: Security Light (KEY side) 1: Blue/White: (-) GWR (status) Input 20 1: Red/Blue: Data Bypass 2: - 3: - 4: - Remote Starter (-) Neutral Safety (DEI Platforms Only) (+) Accessory (+) Start Parking Lights (+) 12 V Input (-) Ground Hood Bra

• Xpresskit XK09-DLPKHO, Installation Type 6 (See the Vehicle Application Guide on page 2 to determine the installation type.) * The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D. Not required in D2D mode. ** Connect the Rearm wire only if the vehicle is equipped with automatic headlights. 4 42 4 Programming Button XK09 (+) Accessory (-) Ground (+) 12 V (+) Ignition 1 (+) Ignition 2 1: Red/Blue: Data Bypass 2: Pink/White: (+) Brake Output (+) Brake Input 3: - 4: - 4: Blue/Red: (-) Push-to-Start Output 3: - 2: Green: (-) Door &

• Xpresskit XK09-DLPKHO, D Under left-side of dash Fuse/RelayBox A B Keyless Access Unit Power Control Unit F E Bypass Data Line Light Green Key slot wire Starter Light Green Acura TL Driver Dash Fuse Box 13-pin Light Green Connector Acura TL Keyless Access Control Unit 32-pin Gray Connector Keyless Switch CAN Low Blue wire CAN High Pink wire Acura TL (Smart Key) Power Control Unit 36-pin Light Blue Connector SS2 Locating Components in the Acura TL (Type 6) Page 10 Rev.: 20120221 Platform: XK09 Firmware: DLPKHO The Mobile Integration Systems © 2012 Directed. All rights reserved.

• (-) Hood Input 3: Red: (+) Ignition 2 4: Blue: (+) Ignition 1 Installation Type 7 (See the Vehicle Application Guide on page 2 to determine the installation type.) 4 42 4 Programming Button XK09 (+) 12 V (-) Ground (+) Accessory (+) Ignition 2 (+) Ignition 1 1: Red/Blue: Data Bypass 2: Pink/White: (+) Brake Output (+) Brake Input 3: - 4: - 4: Blue/Red: (-) Push-to-Start Out

• Xpresskit XK09-DLPKHO, Acura ZDX Combination Light Switch § § Combination Light Switch: Power Control Unit: At steering column. Underneath the left side of the steering column. § Fuse Box: Passenger kick panel. Locating Components in the Acura ZDX (Type 7) Page 12 Power Control Unit Fuse BoxCombination Light Switch A BD F C Rev.: 20120221 Platform: XK09 Firmware: DLPKHO The Mobile Integration Systems © 2012 Directed. All rights reserved.

• Xpresskit XK09-DLPKHO, (-) Hood Input Installation Type 8 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 13 ** Connect the Rearm wire only if the vehicle is equipped with automatic headlights. *** Only supported if the vehicle has the function on the remote starter. It is also important to note that this function will not work when the engine is running. * The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D. Not required in D2D mode. 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 10: Black: Ground Input 14: White: Data Bypass 12: Yellow/Black: Ground 20: Tan/Black: CA

• Xpresskit XK09-DLPKHO, (-) Hood Input Installation Type 9 (See the Vehicle Application Guide on page 2 to determine the installation type.) Page 14 ** Connect the Rearm wire only if the vehicle is equipped with automatic headlights. * The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D. Not required in D2D mode. 4 42 4 Programming Button XK09 9: Red: (+) 12 V Input 10: Black: Ground Input 14: White: Data Bypass 12: Yellow/Black: Ground 20: Tan/Black: CAN High 19: Tan: CAN Low 6: Red/White: (-) Trunk/Hatch Input 5: Blue: (-) Unlock Input

• Vehicle Wiring Reference Chart - Type 3 Vehicle Years Location Lock Wire Unlock Wire Acura CSX 2006-2010 Above driver kick, white 18 pin plug Green, pin 16 Gray, pin 12 MDX 2007-2010 Driver door lock switch, green 5 pin plug (inside door) Pink, pin 4 Red, pin 3 RDX 2009-2010 Above driver kick, blue 23 pin plug Blue, pin 5 Gray, pin 22 RDX 2007-2008 Above driver kick, white 16 pin plug

• Xpresskit XK09-DLPKHO, Module Programming - Install Types 1, 2, 3, 4, 6, 7, 8 and 9 Page 16 Refer to the LED Diagnostics section on page 18 for more information and for troubleshooting purposes. 2 3 Insert the key into the ignition barrel and turn it to ON . Wait for the LED to turn OFF. (for Smart Key vehicles, i press the Push-to-Start button twice without pressing on the brake pedal) nsert the OEM remote into the key port then Turn the key back to the OFF position and remove it from the ignition barrel (for Smart Key vehicles, press the Push-to-Start button once). The module is now programmed and ready to use. 1 The LED turns ON solid. If connected in D2D: Connect the 4-pin D2D

• Page 17 Resetting the Module 1 2 3 Disconnect the module from any power source. Press and HOLD the Integrated Programming Button (IPB). While holding the button, connect the module to the power source. Wait until the red LED flashes once and release the Integrated Programming Button (IPB). & Release Disconnect from Power & Press & Hold Connect to Power Flashes x1 Rev.: 20120

• Xpresskit XK09-DLPKHO, LED Status Description Troubleshooting Module Programming Off Module has no power. Make sure the D2D harness is connected or the 12V is present between the red and black wires. Flashes once quickly Module was reset. Normal operation of the 20-pin harness. Solid Module not programmed. CAN bus cannot be detected. Make sure the connections to the data bus are correct and insert and turn the key to the ON position. Flashes quickly Module is waiting for programming sequence. Make sure the Bypass connections are correct (all three) and turn the

• Xpresskit XK09-DLPKHO, This Interface kit / Data Bus Interface part has been tested on the listed vehicles. Other vehicles will be added to the select vehicle list upon completion of compatibility testing. Visit website for latest vehicle application guide. : Under no circumstances shall the manufacturer or the distributors of the bypass kit / data bus interface part(s) be held liable for any consequential damages sustained in connection with the part(s) installation. The manufacturer and it’s distributors will not, nor will they authorize any representative or any other individual to assume obligation or liability in relation to the

Related Products and Documents (Car Alarm):

Comparable Devices:

Similar Resources:

• Autostart AS-6210 (11 pages) H.4.30.S.1.00 DOC.1.00 CA TL – October 20, 2006 Manufactured in Canada by Autostart AUTOMATIC TRANSMISSION MULTI-CHANNEL REMOTE STARTER AND FULL-FEATURED ALARM SYSTEM _________________________________ User Guide Transmitter Part Number and Module Serial Number .......................................................2 Introduction.................. …

• Megalarm MEGA 450 (8 pages) MEGA 450 REMOTE CONTROL AUTO ALARM SYSTEM INSTALLATION & OPERATION INSTRUCTIONS WIRING DIAGRAM H1: Main 5 Pin White harnessH3: 6 Pin White Mini ConnectorBlack Antenna WireLED IndicatorValet SwitchH7/3 Blue Wire: (-) 200mA UnlockH7/1 Green Wire: (-) 200mA Lock PulseH7 3 PinWhiteH2 4 PinOrangeH5 2 PinBlueH6 2 PinWhiteH4 BlackWireDual ZoneShockSensorH1 …

• Mongoose MX40 II Series (18 pages) THE RECOGNISED NAME IN SECURITY MX40 Series II STANDARDS CERTIFIED SEPTEMBER 2000 TO AS/NZS4601 1999 OPERATING & INSTALLATION INSTRUCTIONS DO NOT LEAVE THIS MANUAL IN YOUR VEHICLE …

• Soundstream Tarantula AL.1 (12 pages) FCC ID NOTICEThis device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.CAUTION: Changes or modifications not expressly approved by the part responsibl …

• Code Alarm ca5153 (30 pages) 12012 Audiovox Electronics Corporation. All rights reserved.PROFESSIONALSERIESAutomatic / Manual TransmissionRemote Start with Keyless EntryInstallation Guidefor models:ca5153ca5153sst …

• Omega Research & Development UltiMate (14 pages) Executive Model ONEUltiMateVehicle Security Alarm SystemwithModel ONE Remote ControlTransmittersOwner’s GuideThis device complies with FCC Rules part 15. Operation is subject tothe following two conditions, (1) This device may not cause harmfulinterference and, (2) This device must accept any interference that maybe received, including interference that ma …

Comments, Questions and Opinions: