Zipato Z-Wave PH-PSG01 Quick Installation Manual

Text of Zipato Z-Wave PH-PSG01 User Guide:

• Zipato Z-Wave PH-PSG01, make your home smart www.zipato.com make your home smart www.zipato.com 02 OVERVIEW PACKAGE CONTENT 1PC Smoke sensor 1PC Screws pack 1PC Quick Installation Guide FEATURES Smoke detection New Z-Wave 500 series chip brings better RF range indoors and up to 100 Kbps transmission speeds Higher output power to enhance the communication range (+5dBm output power as compared to -2.5dBm 300 series) Built-in sound alarm Over-the-air firmware update Low battery auto report Low power consumption Low power indication Easy installation and rellocation Removable ceiling bracket Slim, elegant design SPECIFIC

• Zipato Z-Wave PH-PSG01, make your home smart www.zipato.com make your home smart www.zipato.com 02 POWER UP PROCEDURE This device supports the Z-Wave firmware update via OTA. Put the controller into the firmware update mode, and then press the button once to start the update. Please don’t remove the battery, otherwise it will cause the firmware fail, and the device will cease to function. After update is complete, it is recommended that the user powers up the device. Caution: After removing battery, please wait about 30 seconds, and then re-install the battery. SECU

• make your home smart www.zipato.com make your home smart www.zipato.com 02 THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Operation is subject to the following two conditions: 1 | this device may not cause harmful interference, and 2 | this device must accept any interference received, including interference that may cause undesired operation. NOTE: Changes or modifications not expressly a

Related Products and Documents (Smoke Alarm):

Comparable Devices:

Similar Resources:

• System Sensor 2W-B (4 pages) D100-96-00 1 I56-1800-07R3825 Ohio Avenue, St. Charles, Illinois 601741-800-SENSOR2, FAX: 630-377-6495www.systemsensor.comINSTALLATION AND MAINTENANCE INSTRUCTIONSPhotoelect …

• LST ECO1002 (1 pages) © LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 [email protected] • WWW.LST.AT • ALL RIGHTS RESERVEDECO1002_DBL_LST_EN_0804.PDF • PAGE 1ABuilding Safety. Building Security.Optical-Thermal DetectorECO1002DescriptionThe Optical-Thermal Detector ECO1002 uses both the scattered light …

• Panasonic 2217 (2 pages) Panasonic Electric Works Fire & Security Technology Europe AB Citadellsvägen 23, SE-211 18 Malmö, Sweden Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99 [email protected] • www.panasonic-fire-security.com Fire alarm systems External indicator (LED) 2217 • Symbol instead of text • One indicator for all detector types Symbol on the lid …

• Honeywell C7061A (12 pages) PRODUCT DATA 65-0223-07 SIL3CapableC7061A,F Dynamic Self-CheckUltraviolet Flame DetectorAPPLICATIONThe C7061A,F are dynamic self-checking flame detectors for sensing the ultraviolet radiation generated by the combustion of gas, oil, or other fuels.FEATURES• Oscillating shutter interrupts ultraviolet radiation reaching the UV sensor 12 times per minute t …

• Siemens DM1103-L (2 pages) Building TechnologiesFire Safety & Security Products Handfeuermelder für Gaslöschanlage DM1103-L Stopp-Taster für Gaslöschanlage DM1103-S Montage Manual call point for gas extinguishing system DM1103-L Stop button for gas extinguishing system DM1103-S Installation Fig. 1 Fig. 2 Fig. 3 Verwendungszweck Der Handfeuermelder dient der Handausl …

• Siterwell GS528A-MG (2 pages) OPERATIONPRODUCT SPECIFICATIONS:SMOKE ALARM USER MANUALPHOTOELECTRIC SMOKE ALARM GS528A-MGTesting: Test weekly by pushing the test button on the cover and holding it down for a minimum of 5 seconds. this will sound the alarm if the electronic circuitry, horn, and battery are working properly.DO NOT use an open flame to test your alarm, you could damage the a …

Comments, Questions and Opinions: