Manualios.com

SGS SC50H Owner's Manual

SGS SC50H Manual Online:

3.7, 2635 votes
SGS SC50H User Manual
SGS SC50H User Guide
SGS SC50H Online Manual

Text of SGS SC50H User Guide:

  • SGS SC50H, PAGE 3 PAGE 2 MAIN COMPONENTS 1. Main compressor 2. Pressure switch 3. Outlet Valve 4. Regulating Valve 5. Pressure gauge 6. One-way Valve 7. Drain cock 8. Wheels 9. Discharge pipe 10. Air tank resevoir 11. Safety valve 12. Fan cover SPECIFICATION LIST OF GOODS ITEM LIST OF GOODS QTY 1 Air Compressor 1 2 Air Filter 1 3 Breather Pipe 1 4 Wheel 2 5 Wheel Axis 2 6 Rubber Gasket 1 or 2 7 Instruction Manual 1 ITEM DATA Model SC24H SC50H Power 1.5 kW / 2.5 HP Voltage 230 V Frequency 50 Hz Motor Poles 2 P Rated Speed 2850 rpm Current 7.5 A Delivery 9.6 CFM Discharge Pressure 115 PSI / 0.8 MPa Restart Pressure 70 PSI / 0.5 MPa Tank Capacity 24 L 50 L Dimensions 600x290x645 mm 7

  • SGS SC50H, PAGE 5 PAGE 4 TRAINING: Prior to use, all users must become familiar with the instructions given in this manual. In particular, become familiar with the ON/OFF control for stopping the compressor in the event of an emergency. ALWAYS USE EYE PROTECTION: When operating the air com- pressor, always use eye protection such as goggles, and make sure that other people in the work area are also using eye protection. Eye protectors must provide protection from flying particles both from the front and from the side. PROTECT YOUR HEARING: Hearing protection should be worn when operating this compressor, use ear plugs or ear defenders. NEVER TOUCH MOVING PARTS: Never place your ha

  • SGS SC50H, PAGE 7 PAGE 6 DISCONNECT THE AIR COMPRESSOR: Always disconnect the air com- pressor from the mains power supply and decompress before performing maintenance, changing any parts and when not in use. MAINS POWER CABLE PRECAUTIONS: Never pull on the cable when removing the plug from the mains socket, or lift the compressor by the mains cable. AVOID UNINTENTIONAL STARTING: When connecting the air compres- sor to the mains supply make sure the red button on top of the air com- pressor is in the OFF (down) position. STORE THE AIR COMPRESSOR PROPERLY: When not in use the air com- pressor should be stored in a secure, dry place out of the reach of children. Always lock up the storage area. MA

  • SGS SC50H, PAGE 9 PAGE 8 ASSEMBLY - Use a spanner to attach the wheels to the compressor. - Use the washers and spring washer in the positions shown. Insert the support foot into the position shown. WWW.SGS-ENGINEERING.COM PREPARATION FOR STARTING 1. Check all nuts and bolts. Make sure all loosened parts are tightened before starting. 2. Before running the compres- sor remove the white plug and connect the red bung in it’s place. (2.) 3. Screw the air filter in before starting the compressor. (3.) 4. Set the compressor in a clean, dry a

  • SGS SC50H, PAGE 11 PAGE 10 PREPARATION FOR STARTING 5. Keep the oil level in the red circle of the oil glass sight win- dow. You can purchase compressor oil from our website at: www.sgs-engineering.com 6. Open the drain cock, set the power switch knob to posi- tion “on” and let the compres- sor run for 10 minutes with no load to ensure the moving parts are lubricated before regular service. 1. The compressor is controlled by a pressure switch. It can be stopped automatically as the pressure increases to the maximum and restarted as pressure decreases to the minimum.

  • SGS SC50H, PAGE 13 PAGE 12 OPERATION AND ADJUSTMENT PRESSURE GAUGES There are two pressure gauges on the compressor. 1. The pressure gauge on the RIGHT shows the current pres- sure in the reservoir tank. 2. The pressure gauge on the LEFT shows the ‘user set’ outlet pressure. This can be adjusted using the regulator. 2. The output pressure of compressed air can be adjusted by the regulat- ing valve. Grip the regula- tion valve knob and turn it clockwise to increase the pressure. OPERATION AND ADJUSTMENT 3. When the running compressor needs to be stopped set the pressure switch

  • PAGE 15 PAGE 14 1. Before any maintenance operation stop the air compressor, cut off the power supply and discharge all air in the air tank. 2. Clean crank case and renew lubri- cating oil after the first 10 working hours. Check the oil level through the oil level sightglass (1.) after every 20 working hours and replenish if neces- sary- you can replenish by unbolting the su

  • SGS SC50H, PAGE 17 PAGE 16 REPLACEMENT PARTS DIAGRAM THERMAL RESET SWITCH There may be instances your compressor will overheat. If it cuts out, this is a safety feature to protect you and your compressor. Leave this compressor for a good while until you reset it. If the compressor turns off again on re-set you should not keep running it as it may be damaged and the system may be unsafe. WWW.SGS-ENGINEERING.COM

  • SGS SC50H, PAGE 19 PAGE 18 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE ACTION Motor unable to run, running slow or getting hot 1. Fault in line or insufficient voltage 2. Power wire too thin or long 3. Fault in pressure switch 4. Fault in motor 5. Sticking of main compres- sor 1. Check the line 2. Replace the wire 3. Repair or replace 4. Repair or replace 5. Check and repair Sticking of main com- pressor 1. Moving parts burnt due to insufficient oil 2. Moving parts damaged or stuck by a foreign body Check crankshaft, bearing, connecting rod, piston, pis- ton ring, etc. and replace if necessary Shaking or abnormal noise 1. Connecting p

  • EC Declaration of Conformity This is an important document and should be retained MANUFACTURER’S NAME: TYPE OF EQUIPMENT: PART NUMBER: I, the undersigned, hereby declare that the equipment specied above con- forms to the above European Communities Directive(s) and Standard(s). PLACE: DATE: (Signature) Robert Wyatt Company Secretary Derby, UK 24th JUNE 2015 SGS Engineering (UK

More Instructions:

DOWNLOAD

Related Products and Documents (Air Compressor):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Simrad AP70 Operation manual simrad/ap70-8K4.pdf 20 May 2023 66
2 Toshiba Portege 3500 Specification sheet toshiba/portege-3500-215.pdf 04 Sep 2022 8 0.27 Mb
3 Canon EOS 70D Instruction manual canon/eos-70d-741.pdf 13 Dec 2023 468 20.23 Mb
4 IEI Technology KINO-QM670 Operation & user’s manual iei-technology/kino-qm670-773.pdf 11 Feb 2024 186
5 HP t5325 - Thin Client Getting started manual hp/t5325-thin-client-RYT.pdf 14 Jun 2023 58
6 Samsung SNV-6012M Operation & user’s manual samsung/snv-6012m-676.pdf 22 Feb 2024 129

Similar Resources:

  • Porter-Cable

    CPL55GH8W

    (26 pages)
    Part No. D26998-031-1OillubeCompressorInstruction manualTo learn more about Porter-Cable visit our website at:http://www.porter-cable.comThe Model and Serial No. plate is located on theframe. Record these numbers in the spaces belowand retain for future reference.Model No. Type Serial No. ESPAÑOL: PÁGINA 27FRANÇAISE: PAGE 53IMPORTANTPlease make certain …
  • Trane

    R410a

    (27 pages)
    OWNER’S GUIDEAIR CONDITIONERINTERACTIVETRANE SPLIT ACSPLIT AC WITHREMOTEINTERACTIVEPictures of the actual product may dier as per the product purchased.Applicable Series: IN 1 (Inverter Models) - R410a …
  • Porter-Cable

    CPLC7060V

    (24 pages)
    Part No. D23269-049-2®Single Stage OillubeCompressorInstruction manualTo learn more about Porter-Cable visit our website at:http://www.porter-cable.comThe Model and Serial No. plate is located on theframe. Record these numbers in the spaces belowand retain for future reference.Model No. Type Serial No. ESPAÑOL: PÁGINA 25FRANÇAIS: PAGE 49IMPORTANTPlease …
  • Craftsman

    919.724132

    (44 pages)
    Owner’s ManualPermanently Lubricated Tank MountedAIR COMPRESSOR• Safety Guidelines• Assembly• Operation• Maintenance• Service and Adjustments• Troubleshooting• Repair PartsModel No.919.724132CAUTION: Read the Safety Guidelines and All Instructions Carefully Before Operating.Sold by Sears Canada, Inc. Toronto, Ont. M5B 2B8A14005 Rev. 1 05/ …
  • TMG

    TMG-GAC40

    (28 pages)
    40Gallon Two-Stage Air CompressorModels:TMG-GAC40Please read the product manual completely before assemblyCheck against the parts list to make sure all parts are receivedWear proper safety goggles or other protective gears while in assemblyMissing parts or questions on assembly?Please call: 1-877-761-2819 or email: [email protected] not return the produ …
  • CompAir BroomWade

    Cyclon 330

    (66 pages)
    page 1Cyclon Series User ManualUSER MANUALCYCLON 330-345 AIR COMPRESSORSSerial Numbers from:Cyclon 330 F166/0101 Cyclon 337 F167/0151 Cyclon 345 F168/0101CONTENTSPage1. Safety Procedures 52. General Description 113. Leading Particulars 194. Installation 215. Commissioning 256. Operation 357. Maintenance 478. Fault Finding 57Appendix 1 – Electrical Connect …

Comments, Questions and Opinions: