Q CELLS Q.POWER-G5.1 Installation And Operation Manual

Text of Q CELLS Q.POWER-G5.1 User Guide:

• Q CELLS Q.POWER-G5.1, 2 3INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN 2 3 DOCUMENT REVISION 01 This Manual is valid for Africa, Asia, Europe, Latin America, and South America as of July 1st 2017 for Q.POWER-G5, Q.PRIME-G5, Q.PEAK-G5, Q.POWER L-G5, Q.PRIME L-G5, Q.PEAK L-G5 solar modules, and replaces all earlier versions. DISCLAIMER Technical parameters and the design are subject to change. The data sheets and customer information valid at the point in time when the relevant module was manufactured apply to t

• 4 5INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN Validity These instructions are only valid for crystalline solar modules from the company Q CELLS. Q CELLS assumes no liability for damage resulting from failure to observe these instructio

• Q CELLS Q.POWER-G5.1, 6 7INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN Installation Site Please note the following guidelines that apply to the installation site: • The modules have been tested according to IEC 61215 for operation in a temperate climate. • Solar modules are not explosion-proof and are not suitable for use in explosive environments. Ä Do not operate solar modules near highly ammable gas and vapors (e.g. gas tanks, gas stations). Ä Do not install modules in enclosed space. Ä Do not install modules in locations where the

• Q CELLS Q.POWER-G5.1, 8 9INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN 2.3 Mounting options 2 PLANNING Fig. 3: Installation options for crystalline Q CELLS modules. All dimensions are given in mm. Also observe the allowed static loads and clamping range as specied on the following page. The illustrated installation options apply for both horizontal and vertical module orientation. Module Clamp Subconstruction Mounting prole TYPE OF INSTALLATION MODULE TYPE LONG SIDE SHORT SIDE INSTALLATION WITH CLAMPS Q.PRIME

• Q CELLS Q.POWER-G5.1, 10 11INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN 2 PLANNING 2.3 Mounting options Specications MODULE TYPE MOUNTING OPTION CLAMPING AREA 1 [MM] TEST-LOAD ACC. IEC 61215 PUSH/PULL [PA] Q.POWER L-G5.1 Q.PRIME L-G5.1 CL1 (4 point clamping on long side) 208-417 5400/2400 CL1 (4 point clamping on long side) 0-625 2400/2400 CL3 (4 point clamping on short side)

• 12 13INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN WARNING! Fire Risk! Ä Do not install modules indoors. Ä Do not install modules on moving objects. Ä Inspect the packaging for damages. Ä Contact the transport company rega

• Q CELLS Q.POWER-G5.1, 14 15INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN DANGER! Risk of fatal injury due to electric shock! Ä Block off the installation zone. Ä Keep children and unauthorized individuals away from the solar power system. DANGER! Risk of fatal injury due to electric shock! Ä Ensure that modules and tools are not subject to moisture or rain at any time

• Q CELLS Q.POWER-G5.1, 16 17INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN DANGER! Risk of fatal injury due to electric shock! When disconnecting an electric circuit carrying direct current, electric arcs can occur that may result in life-threatening injuries. Ä Do NOT unplug the cable when under load. Ä Do NOT connect any exposed cable ends. Ä Do NOT touch the poles at the same time. A solar module generates electrical current and voltage even at a low intensity of illumination. Sparks and electric arcs

• Q CELLS Q.POWER-G5.1, 18 19INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN Ä Use solar cables for the connection at the junction box outlet. Ä Use the same, inverter-compatible plugs. SOLAR NOTE! Module damage may occur! Ä Ensure that the cabling is not under stress. Ä Ensure that the cables do not run between module and subconstruction (danger of pinch). Ä Do not connect modules with different orientations or angles of inclination in the same string. Ä Ensure for a tight

• Q CELLS Q.POWER-G5.1, 20 21INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.POWER-G5 / L-G5 • Q.PRIME-G5 / L-G5 – EN Protective Grounding Ä The modules must be grounded in accordance with the local statutory regulations. Functional grounding • When using an installation tilt of < 5° a functional grounding at the negative generator conncetion must be implemented. Ä Ensure that the difference of potential bet

• Q CELLS Q.POWER-G5.1, CONTACT HANWHA Q CELLS (QIDONG) CO., LTD. No. 888 Linyang Road, Qidong City, Jiangsu Province, China TEL +86(0)513 8360 – 6222 FAX +86(0)513 8360 – 6376 EMAIL [email protected] WEB www.q-cells.com Subject to change without notice. © Hanwha Q CELLS Installation_Manual_Q.POWER_Q.PRIME_G5.1_L-G5.1_module_series_2017-12_Rev02_EN

Related Products and Documents (Solar panel):

Comparable Devices:

Similar Resources:

• Viessmann Vitosol 300-T (32 pages) Installation instructionsfor contractorsVIESMANNVitosol 300-TType SP3AVacuum tube collector based on the heat pipe principleVITOSOL 300-T5366 351 GB 9/2009Dispose after installation. …

• BenQ PM200M00 (21 pages) BBeennQQ SSoollaarr PPhhoottoovvoollttaaiicc MMoodduulleess IInnssttaallllaattiioonn GGuuiiddee ((IIEECC,, EETTLL)) PM200M00 PM245P00 PM250M01 PM300P00 PM318B00 PM318B01 PM096B00 PM096B01 Version 1.2 Note: The content of this manual is subject to change without notice. © 2013 AU Optronics All Rights Reserved …

• Rheem 12104793 (40 pages) This collector kit must be installed and serviced by a qualified person. Please leave this guide with the householder. Installation Instructions Collector Kits Collectors with Copper Waterways, Conetite Connections for use in Open Circuit Systems using uncoated DR Brass Conetite fittings LCS, TBT200 SOLAR COLLECTORS WARNING: Plumber – Be Aware U …

• Kayoba 009541 (7 pages) SolcellspanelSolcellepanelPanel słonecznySolar panelItem no. 0095415,5 VDC, 7 WOperating instructionsBruksanvisningBruksanvisningInstrukcja obsługi Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions) Viktig! Les bruksanvisningen nøye før bruk. Ta vare på den for fremtidig …

• CSG PVTech CSG270M2-35/1956×992 series (11 pages) INSTALLATION MANUAL Southern Glass Green Energy Industrial Park, Xinji Village, Machong Town, Dongguan, China. Tel: 86-769-88288015 Fax: 86-769-88288160 www.csgpvtech.com CSG270M2-35/1956×992 series …

• SOLARA M-Series (2 pages) EN Solara GmbH  Große Bergstraße 219  22767 Hamburg  [email protected] www.solara.de 9940000010 - BA SOLARA GmbH M-Serie en v1.0 MHE 01/2016 D) Connection to the regulator and the battery Read furthermore the instruction of the charge controller. 1. Install the regulator close to the battery. 2. If necessary, expand the …

Comments, Questions and Opinions: