Manualios.com

KStar UDC9101S One Operation & User’s Manual

KStar UDC9101S One Manual Online:

3.85, 1344 votes
KStar UDC9101S One User Manual
KStar UDC9101S One User Guide
KStar UDC9101S One Online Manual

Text of KStar UDC9101S One User Guide:

  • KStar UDC9101S One, 9 2-4 UPSstartupandturnoff  Startupoperation (1)TurnontheUPSinlinemode NOTE Verify that the total equipment ratings do not exceed the UPS capacitytopreventanoverloadalarm. a) Oncemainspowerispluggedin,theUPSwillchargethebattery,atthemoment, theLCDshowsthattheoutputvoltageis220,whichmeanstheUPSautomatically tarttheinverter.Ifitisexpectedtochangetobypass model,youcanPress

  • KStar UDC9101S One, 13 3. Operations 3-1 Buttonoperation    3-2 LCDdisplay   Partone:Rackdisplay    Thereare9interfacesavailableintheLCDdisplay.   Button Function ON /ENTER Button  TurnontheUPS:PressandholdONbuttonfor atleast2secondstoturnontheUPS.  Confirmcurrentsettings:WhentheUPSenters thesettingmode,mustpressthisbuttonto  confirmthesettingsvaluewhatyouwant,nest pressup/downbuttontochangesettings  information  Out�

  • KStar UDC9101S One, 4  When installing the equipment, it should ensure that the sum oftheleakage currentoftheUPSandtheconnecteddevicesdoesnotexceed3.5mA.  1-4 Operation  DonotdisconnectthemainscableontheUPSsystemorthebuilding wiring outlet(shockproofsocketoutlet)duringoperationssincethiswouldcancelthe protectiveearthingoftheUPSsystemandofallconnectedloads.   The UPS system features its own, internal�

  • 22 Relaycard MinidrycontactcardisusedfoprovidingtheinterfaceforUPSperipheralmonitoring.The contactsignalscanreflectUPSrunningstatus.Thecardisconnectedtoperipheralmonitoring devicesviaterminalboardtofacilitatetheeffectivemonitoringofthereal-tim

  • KStar UDC9101S One, 3 1. ImportantSafetyWarning Importantsafetyinstructions–Savetheseinstructions Pleasecomplywithallwarnings andoperatinginstructions inthismanual strictly. Save this manual properly and read carefully the following instructions before installing the unit. Do not operate this unit before reading through all safety informationandoperatinginstructionscarefully Thereexistsdangerousvoltageandhigh�

  • KStar UDC9101S One, 24 Numbers 2 3 2 3 4 6 4 6 6 8 6 8 Backup time Long run unit depends on the capacity of external batteries Typical recharge time(standard modle) 4 hours recover to 90% capacity (Typical) Charging voltage 27.4 VDC ±1% 41.0 VDC ±1% 27.4 VDC ±1% 41.0 VDC ±1% 54.7 VDC ±1% 82.1 VDC ±1% 54.7 VDC ±1% 82.1 VDC ±1% 82.1 VDC ±1% 109.4 VDC ±1% 82.1 VDC ±1% 109. 4 VDC ±1% Charge current 1A or 2A 12A max, can be setting by LCD 1A or 2A 12A max, can be setting by LCD 1A or 2A 12A max, can be setting by LCD SYSTEM FEATURES Overload @35 ℃ Line Mode Battery Mode Ambient Temp.<35 ℃ 105%~110%: UPS transfer to

  • KStar UDC9101S One, 8  For socket-type outputs, simply connect devices to the outlets.  For terminal-type input or outputs, please follow below steps for the wiring configuration: a) Remove the small cover of the terminal block b) Suggest using AWG14 or 2.1mm 2 power cords for 3KVA (200/208/220/230/240VAC models). c) Upon completion of the wiring configuration, please check whether the wires are securely affixed. d) Put the small cover back to the rear panel. Step 3 Communication connection Communication port: To allow for unattended UPS shutdown/start-up and st

  • KStar UDC9101S One, 11 Function Keys FunctionKey Description ESC/OFF ToexitsettingmodeOrturnofftheups UP TogotopreviousselectionOrturnontheups Down Togotonextselection ENTER/ON Toconfirmtheselectioninsettingmodeorentersettingmode LCD Display Icons Icon  Function description   InputSourceInformation    IndicatestheACinput.  Indicate input voltage, input frequency, PV voltage, battery voltageandTemp  Configura

  • KStar UDC9101S One, 19 4. Troubleshooting IftheUPSsystemdoesnotoperatecorrectly,pleasesolvetheproblembyusingthe tablebelowandtheTroubleShootingChart.  Symptom Possiblecause Remedy Noindicationandalarmeven thoughthemainsisnormal.  TheACinputpoweris notconnectedwell.  Checkifinputpowercord firmlyconnectedtothe mains.  TheACinputis connectedtotheUPS output.  PlugACinputpowercord toACinputcorrectly.  Alarmcode

  • KStar UDC9101S One, 7 2KVA(S)-6batt /3KVA(S): 1. ACinput 2. Network/Fax/ModemSurgeProtection(option) 3. Inputcircuitbreaker 4. EPO(option) 5. USBcommunicationport(option) 6. RS-232communicationport 7. SNMPintelligentslot(option) 8. Outputreceptacles 9. BatteryTerminal 10. OutputTerminal  2-3 SetuptheUPS Step 1: UPS input connection Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.  For 200/208/220/230/240VAC models: The po

  • 18 5 UtilityMode 6 BatteryMode 7 BatterySelf-diagnostics 8 Inverterisstartingup 9 ECOMode 10 EPOMode 11 MaintenanceBypassMode 12 FaultMode  3-5 AlarmorFaultreferencecode  Eventlog  UPSAlarmWarning Buzzer LED 1 RectifierFault Beepcontinuously FaultL

  • KStar UDC9101S One, 17 06 Bypassvoltageupperlimitsetting  PressEnterbutton  tochange thesetting(Thebypassvoltage upperlimitrangeis230-264Vac). PressUPbutton▲toselectthe previoussetting. PressDOWNbutton▼toselect thenextsetting. 07 Bypassvoltagelowerlimitsetting  PressEnterbuttontochangethe setting(Thebypassvoltagelower limitrangeis170-220Vac). PressUPbutton  toselectthe previou

  • KStar UDC9101S One, 10 LCD control panel introduction (1)LED(fromright  toleft:“alarm”,“bypass”,“battery”,“inverter”); (2)On-LineUPSLCDdisplay;(3)Functionkeys   LED Indicator Indicator Description  Red  OnTheUPShasanactivealarmorfault.   Yellow TheUPSisinBypassmode. OnTheUPSisoperatingnormallyonbypass duringHighEfficiencyoperation.  Yellow  OnTheUPSisinBatterymode.   Green  OnTheUPSisoperatingnormally

  • KStar UDC9101S One, 1   Allrightsreserved. Theinformationinthisdocumentissubjecttochangewithoutnotice.                      Publishstatement ThankyouforpurchasingthisseriesUPS. ThisseriesUPSisanintelligent,singlephaseinsinglephaseout,highfrequency onlineUPSdesignedbyourR&Dteamwhoiswithyearsofdesigningexperienceson UPS.Withexcellentelectricalperformance,perfectintelligentmonitoringand networkfunc

  • KStar UDC9101S One, 15 06 UPSmodel. 07 FirmwareVersion 08 AlarmCode(Warming Message) Allalarmcodesare presentwhenabnormal behavior(s)occur(s)  3-3 UPSsetting TheUPShassettingfunctions.ThisusersettingscanbedoneunderanykindofUPS workingmode.Thesettingwilltakeeffectundercertaincondition.Belowtable describeshowtosettheUPS. Thesettingfunctioniscontrolledby4buttons(Up,Down,ON/Enter,OFF/ESC):  Up▲+OFF/Down

  • 2 TableofContents 1. ImportantSafetyWarning .................................................................................................................. 3 1-1 Transportation ............................................................................................................................ 3 1-2 Preparation ........

  • KStar UDC9101S One, 14 Item InterfaceDescription ContentDisplayed 01 Inputvoltage&Output voltage 02 Batteryvoltage&Battery capacity 03 Inputfrequency& Outputfrequency 04 Load 05 Environment Temperature

  • KStar UDC9101S One, 16 Item Settings Contentdisplay 01 Modesetting  PressEnterbuttontochangethe setting(ECOorNORorCF). PressUP▲button  toselectthe previoussetting. PressDOWN▼button  toselect thenextsetting. 02 Outputvoltagesetting  PressEnterbuttontochangethe setting(200,208,220,230,240). PressUP▲button  toselectthe previoussetting. PressDOWN▼button  toselect thenextsetti

Related Products and Documents (UPS):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Philips DVDR3570H Quick start manual philips/dvdr3570h-PTU.pdf 17 Oct 2022 2
2 Oregon Scientific THGN132ES Manual  oregon-scientific/thgn132es-4NB.pdf 14 Apr 2023 2
3 Altec Lansing FX5051 Operation & user’s manual altec-lansing/fx5051-U1C.pdf 08 Dec 2022 27 0.74 Mb
4 Dymo LabelManager 360D Manual d'utilisation dymo/labelmanager-360d-O42.pdf 26 Feb 2024 30 5.06 Mb
5 Philips HSB2313/93 Operation & user’s manual philips/hsb2313-93-Z6U.pdf 16 Feb 2023 25 2.2 Mb
6 NEFF B45E54N0GB User manual manual neff/b45e54n0gb-XD5.pdf 27 Jul 2023 72

Similar Resources:

  • Rockwell Automation

    Allen-Bradley Bulletin 1609

    (24 pages)
    41063-214-01 (1) 990-2230 11/20041609 Industrial Uninterruptible Power Supply1609 Unterbrechungsfreie Stromversorgung für gewerbliche NutzungOnduleur industriel 1609Sistema de alimentación ininterrumpida industrial 1609Gruppo di continuità industriale 1609No-Break Industrial 1609(1609-U500...)Installation and OperationInstallation und BetriebInstallation …
  • Adams

    650VA

    (4 pages)
    1LLIINNEE--IINNTTEERRAACCTTIIVVEELLCCDDUUPPSS650VA to 2000VAUninterruptible Power SystemUSER MANUAL2 IMPORTANT SAFETY INSTRUCTIONSWARNING : (SAVE THESE INSTRUCTIONS) This manualcontains important safety instructions. Please follow up allinstructions carefully during installation. Read this manualthoroughly before attempting to unpack, install or operate. …
  • Xtreme

    NXRTi 1000VA

    (37 pages)
    NXRTi Online UPS1000VA, 2000VA, 3000VA ModelsUser & Installaon Manualwww.xpcc.com | © 2015 Xtreme Power Conversion Corporaon. All rights reserved. (Rev 6/23/15) …
  • Tripp Lite

    700

    (5 pages)
    Tripp Lite1111 West 35th StreetChicago, IL 60609 USATelephone: +(773) 869 1234E-mail: [email protected] #: INTERNETOFFICE700Internet Office 700VA Tower Standby 120V UPS with USB port Highlights700VA tower 120V standby UPSMaintains AC output during power failures3 UPS battery supported outlets, 3 surge-only outletsUSB port, TEL/DSL/ethernet protec …
  • Rittal

    7857.433

    (32 pages)
    Assembly and Operation Instructions UPS System Power Modular Concept PMC 12 4,5 and 6kVA 7857.433 7857.434 …
  • Tripp Lite

    SMART1500RMXL2UA

    (6 pages)
    Tripp Lite1111 West 35th StreetChicago, IL 60609 USATelephone: +(773) 869 1234E-mail: [email protected] #: SMART1500RMXL2UASmartPro 1.5kVA 1350W Line Interactive Sine Wave UPS, Extended-run & SNMPWEBCARD options, 2URack/Tower, LCD, USB, RS232,EPO, 120V Highlights1.5kVA / 1500VA / 1350W line interactive 2U rack/tower UPS, Sine Wave120V output, …

Comments, Questions and Opinions: