Manualios.com

OK-I OK-NICP-AE Quick Installation Manual

OK-I OK-NICP-AE Manual Online:

4.7, 1574 votes
OK-I OK-NICP-AE User Manual
OK-I OK-NICP-AE User Guide
OK-I OK-NICP-AE Online Manual

Text of OK-I OK-NICP-AE User Guide:

  • OK-I OK-NICP-AE, 0 OK-NICP-AE OK-NICP-AEP OK-NICP-AEG – Wireless OK-NICP-AEGP – Wireless Pan Tilt MPEG4 IP Color Camera Quick Installation Guide This guide describes the basic functions of Network Camera with Pan/Tilt. All detailed information is described in the user’s manual.

  • OK-I OK-NICP-AE, 1 Warning Before Install ◎ Power off the Network Camera as soon as it is found smoking or smelt unusual. Contact your distributor when such cases happen. ◎ Keep the Network Camera away from the water. If the Network Camera is wet, power off immediately. Contact your distributor when such cases happen. ◎ Do not place the Network Camera around the heat sources, such as television or oven. ◎ Refer to your user’s manual for the operating temperature. ◎ Keep the Network Camera away from the direct sunlight. Do not place the Network Camera in high humid environments.

  • OK-I OK-NICP-AE, 2 Do not place the Network Camera on unsteady surfaces. ◎ Do not touch the Network Camera when it’s lightening. ◎ Do not disassemble the Network Camera. ◎ Do not drop the Network Camera. ◎ Do not manually pan and tilt the Network Camera when are power is on. ◎ Do not insert any object into the Network Camera, such as needles.

  • OK-I OK-NICP-AE, 3 1. Check Package contents ◎ Wired or Wireless Network Camera ◎ Power adapter ◎ Software CD ◎ Camera Mount Kit & Pads ◎ Quick Installation Guide ◎ Antenna for wireless model only

  • OK-I OK-NICP-AE, 4 2. Physical description ◎ Front panel ◎ Rear panel Antennas (wireless model only) Lens and manual focus ring Microphone Status LEDs Antenna (wireless model only) N ote the serial number from the label on the unit. This serial number is the same as the MAC address. For example: 0002D000019=00-02-D1-00-00-19 Power Cord socket Ethernet 10/100 RJ45 socket

  • OK-I OK-NICP-AE, 5 3. Mounting the Camera Ceiling Mount 1. Fix the camera to the bracket with the two supplied screws (type A). 2. Fix the bracket and camera to the ceiling using the two screws and hollow wall anchors. 3. If adopting POE kit (optional accessory) , the POE splitter can be attached to the bracket by using the two supplied screws (type B)

  • OK-I OK-NICP-AE, 6 Wall Mount 1. Fix the bracket to the wall using the two screws and hollow wall anchors. 2. Fix the camera to the bracket with the two supplied screws (type A) 3. If adopting POE kit (optional accessory), the POE splitter can be attached to the bracket by using the two supplied screws * type B).

  • 7 4. Install your Network Camera in Ethernet network P O W E R C O L L I S I O N L I N K R E C E I V E P A R T I T I O N 1 2 3 4 5 2. Connect power cord to a power outlet. 1. Use Ethernet cable to make connection from Ethernet port to the hub. z Use Category 5 Cross Cable when the Network Camera is directly connected to PC.

  • OK-I OK-NICP-AE, 8 5. Assign IP address 1. Run the Installer under the Utility directory from software CD. 2. The program will search the cameras on the same LAN. 3. After searching, the main installer window will pop up. Click on serial number that matches the one you just note from 2. Physical description 4. Click “Link to selected device” to connect the Internet Explorer to the Network Camera.

  • OK-I OK-NICP-AE, 10 7. Set up Your Wireless Configuration for the Network Camera (Wireless model only) 1. Check the SSID currently set on your wireless access point (AP). 2. Go to Configuration > Wireless LAN Note: 1. SSID abbreviated from Service Set Identifier is the name to the wireless network. The camera’s factory SSID setting is set to “default “. 2. Select ‘Ad-Hoc” wireless mode if you want the camera to communicate without using an AP or wireless router. For setup wireless mode and further configuration, please ch

  • OK-I OK-NICP-AE, 11 8. Client Settings (Windows 2000/Me/98E) At the initial access to the “Connection type” page in Windows, the web browser will ask for a new plug-in installation, the plug-in being the Network Camera. This plug-in has been registered for certification and can be used to change the parameters at the client’s site. The user may click on to install the plug-in. If the web browser does not allow the user to complete the installation, check the Internet security to lower the security level or contact your IT or networking superv

  • 15 5. Key-In camera’s IP address and press “OK” on Information Bar. 6. Click the blue bar under the Camera’s IP address in the browser, then choose “Install ActiveX Control” 7. Recover security settings. Download unsigned ActiveX Controls set “Disable” and press “OK” and “Apply”

Related Products and Documents (IP Camera):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Craftsman 917.378861 Owner's manual craftsman/917-378861-8R7.pdf 18 Oct 2022 44
2 Frigidaire 318200912 Owner's manual frigidaire/318200912-Y79.pdf 31 Oct 2022 12 0.74 Mb
3 Meinberg LANTIME M600/GPS Characteristics meinberg/lantime-m600-gps-WKM.pdf 02 Oct 2022 6
4 Mackie 16-8 BUS Hook-up manual mackie/16-8-bus-2QZ.pdf 30 Jun 2022 5
5 Frigidaire FGFB75DQA Use & care manual frigidaire/fgfb75dqa-728.pdf 11 Oct 2022 24
6 Sony KD-32DX150U Quick start manual sony/kd-32dx150u-572.pdf 22 Jul 2022 2 2.29 Mb

Similar Resources:

  • Honeywell

    H2W2PRV3

    (94 pages)
    Honeywell | Performance Series Performance Series IP Cameras Software Configuration Guide Recommended Find the latest version of this and other Performance Series IP camera documents on the Honeywell Video website. Go to: http://www.honeywellvideo.com/products/cameras/ip/index.html to find your camera and view/download the latest d …
  • Avtech

    AVC647

    (2 pages)
    12Thank you for choosing this high quality camera, before attempting to connect or operate this product, please read these instructions completely the instruction carefully. COLOR CCTV CAMERA OPERATING MANUAL SPECIFICATION Pick up Element 1/3” Color CCD image sensor Number of Pixel 768(H)x494(V) <NTSC> / 752(H)x582( …
  • OK-I

    OK-NICP-AE

    (16 pages)
    0 OK-NICP-AE OK-NICP-AEP OK-NICP-AEG – Wireless OK-NICP-AEGP – Wireless Pan Tilt MPEG4 IP Color Camera Quick Installation Guide This guide describes the basic functions of Network Camera with Pan/Tilt. All detailed information is described in the user’s manual. …
  • Samsung

    WV SCP-2270H

    (1 pages)
    FIRST EDITION 09-201196SCP-2270H/22701/4" 27x PTZ Dome Camera600TVLD&N ICR24VAC27xTechnical SpecificationsControllers (optional)SPC-6000 SPC-1010Key Features• High resolution of 600TV lines (Color), 700TV lines (B/W)• Min. illumination [email protected] (Color), 0.02Lux (B/W)• Powerful 27x zoom (3.5 ~ 129.5mm), digital 16x• WDR, VPS, True Day / Ni …
  • Vitek

    Transcendent VTC-TNB8RFA3-2

    (78 pages)
    FEATURES • 1/1.8” (Motorized Models) / (1/2.8” Fixed Models) 8.0 Megapixel [4K] CMOS Image Sensor • Up to 30fps (Motorized) / 20fps (Fixed) @ 8 MegaPixel (3840 x 2160) • Available with 2.8mm Fixed Lens, or 2.8~12mm Motorized Varifocal Lens • Matrix IRs with up to 165’ IR Range (model dependent) *up to 230’ on VTC-TNB8RMA3 • True Wide Dy …
  • Okina

    Eco Series

    (2 pages)
    ESDX-3420-VD_rev11212008 Operational Manual 3-AXIS Mini Vandal Dome Color Camera z 1/3” Sony Super HAD CCD z 420 TV Lines z 3.6mm Board Lens z 0.3 Lux @ F2.0 z 3-AXIS design for any angle z 12V DC 1. Never point the camera toward the sun Do not expose the lens directly to the sun or to strong light as this may damage the pick-up …

Comments, Questions and Opinions: