Clinton Electronics CE-T100HD Install Manual

Text of Clinton Electronics CE-T100HD User Guide:

• Clinton Electronics CE-T100HD, With the supplied 2mm Allen Wrench, loosen the two set screws located near the base, on the outer camera housing. Remove mounting plate from the camera housing. 1. DISASSEMBLE CAMERA Attach the mounting plate to the desired surface with the three provided 3x13mm Phillips head screws. Drill a 3/4” hole in the opening of the mounting plate if running the cable through the mounting surface. 2. ATTACH MOUNTING PLATE Camera settings can be adjusted by using the Built-in Joystick located on the cable. Connect your test monitor to either the analog or HD-SDI BNC connection located on the CE-T

• Clinton Electronics CE-T100HD, Feed any cable slack into the mounting surface. Place the camera housing onto the mounting plate and partially tighten the set screws on the outer camera housing. Do not fully tighten yet. The camera housing needs to be loose to make camera position adjustments in the next step. 5. MOUNT CAMERA The camera view can be adjusted by turning the camera housing to the desired location. Lens angle can be adjusted by tilting to the desired location. Barrel rotation can be adjusted by rotating the camera body to the desired position. 6. CAMERA ADJUSTMENTS Afte

Related Products and Documents (Security Camera):

Comparable Devices:

Similar Resources:

• 4xem 4X-PZ7131 (2 pages) Pan/Tilt/Zoom PoE PTZ IP Network Camerasku 4X-PZ7131The 4XEM 4X-PZ7131 is equipped with a pan/tilt 2.6x optical zoom lens, with built-in Auto Focus and Auto Iris. This is a cost-eective pan/tilt/zoom network camera suitable for any indoor surveillance applications and can be used with an indoor ush mount dome enclosure, the IPCAMENCLOD. Need an …

• Logitech Alert 700n (2 pages) Before you begin the installation, read all instructions.Legal WarningCertain uses of security camera products and audio devices, such as employee monitoring, surreptitious viewing and recording of images and/or audio, or the use, publication or distribution of image and/or audio recordings, are prohibited or restricted by country, state and local laws. Be s …

• Eaton Crouse-hinds series (28 pages) Explosionsgeschützte Steckvorrichtung 125 A, 4- und 5-polig, GHG 515Explosion-protected plugs and sockets 125 A, 4-pole and 5-pole, GHG 515Fiche et prise de 125 A, à 4 pôles et 5 pôles, pour atmosphères explosives, GHG 515 GHG 510 7004 P0001 D/GB/F (g)CROUSE-HINDSSERIESBetriebsanleitungOperating instructionsMode d’emploi …

• Vicon V960D-W Series (5 pages) Quick User Guide V960D-W Series Network Camera Warning before installation -Power off the Network camera if it is found to be smoking or smells unusual. -Keep the Network camera away from water. If the Network camera gets wet, power off immediately. -Do not place the Network camera near heat sources, such as a television or oven. -Refer to your i …

• Sony SNC-ER580 (2 pages) • Optical Day/Night function to switch to Day or Night mode depending on the light level. • DEPA™ Intelligent Video Analytics system can be set up with a DEPA-enabled recorder.• Powered by HPoE for simple installation. • SD memory card slot for an on-board recording capability.*1*2• Recording Software (RealShot™ Manager Lite) is bun …

• COMPRO IP55 (2 pages) To begin setup, insert the installation CD into your CD-ROM drive, and the iWizard will start automatically. ( If it doesn’t, browse the contents of the CD and run the ‘iWizard.exe’). Then, select the language and the device you wish to set up.The first step shows how to connect all the cables. Hit [Next] twice to proceed with the 2nd step in which the …

Comments, Questions and Opinions: