ACK! E-04 ELT Programming Manual

Text of ACK! E-04 ELT User Guide:

• ACK! E-04 ELT, MODEL E-04 121.5/406 MHz ELT PROGRAMING MANUAL REVISION 1.2 December 4th 2017 WARNING: Once an ELT is programmed from the default Serial Number format, it can not be programmed back to Serial Number for- mat except by the factory.

• Table of Contents Page Content 1 Minimum System Requirements / E-04.PK contents 2 Programming Overview 3 Software & Printer Installation 4 Programming (using the dongle) 5 Programming (using the software) 6 Programming (using the various protocols.) 7 Programming (locating the IACO 24 Bit address.) 8 Annex A (Country code listing) 9 Troubleshooting

• ACK! E-04 ELT, Minimum System Requirements -2 GHz Processor -512 MB Ram -640x480 Display -10 Megabytes Available Hard Drive Space -USB Port Supported Operating Systems -Windows 10, 8, 7 -Windows XP Service pack 3 or higher E-04.PK Programming Package includes: -Programming Operation / Installation Manual -Programming Dongle (part # E-04.PRG Version 3.0) -USB Extension Cable -3/32” Hex Driver -Software CD (version 3.0) Additional Equipment (required to be purchased separately) -Brother QL-700 Label Printer -Brother Yellow Film Tape (Part # DK-2606) Required Equipment P/N E-04.PK Brother Printer and Labels To be Purchased Separately

• Model E-04 Programming Overview The ACK programming process itself is quite simple and may be accomplished in a matter of minutes however programming the Model E-04 121.5/406 MHz ELT requires a basic understanding of the COSPAS/SARSAT coding protocols and the requirements of various countries throughout the world and their specific requirements. COSPAS/SARSAT provides for a n

• ACK! E-04 ELT, Install Brother QL-700 Printer 1.) Install the Brother QL-700 printer follow the manufacturers installation instructions. 2.) Load the DK-2606 label tape in the printer. 3.) Open the “Start” menu, select control panel. 4.) Open “Printers and Faxes” in control panel. 5.) Right click on Brother QL-700, then click on “properties”. 6.) On properties screen click on “Printing Preferences” 7.) Set Parameters as shown below. SOFTWARE INSTALLATION Windows 7, 8, 10 1.) Do not plug in the prog

• ACK! E-04 ELT, Programming ELT’s Once you have the software and driver installed you are ready to program ELT’s. To program an ELT follow these steps: 1.) Disconnect Antenna, Remote Control, and GPS cables. 2.) Remove the ELT transmitter head from the battery pack by removing the four screws attaching the transmitter head to the battery pack using the hex driver supplied. 3.) Place ELT in “Off” position. 4.) For Windows 7, 8, 10 type VAR in the search box to locate the VAR program. You can run it from there or make a shortcut to desk top. For XP 1.) Open the “start” menu on Windows Desktop. 2.

• ACK! E-04 ELT, On the screen click on the “Beacon Type” down icon and the three type of programming appear. Select the type programming you wish to use by placing the cursor over the type of programming and click to select. You may chose: Standard Location Serial Number Country Code Protocol Standard Location with Operator, Designator & Serial Number Standard Location 24-Bit Address To determine what protocol to use for a particular country we have compiled a list of coun

• ACK! E-04 ELT, Standard Location with Operator, Designator & Serial Number 1.) When selecting this option use the dropdown menu to select the country you wish to program it for. 2.) Enter the operator designator alpha-numeric code using the up and down buttons. 3.) Enter the serial number of the ELT. 4.) Click the “Program” button and monitor the progress bars. 5.) After completing programming the “Verify” button highlights yellow, select “Verify” and monitor the progress bars. 6.) If the “Verify” button hi

• ACK! E-04 ELT, 5.) After completing programming the “Verify” button highlights yellow, select “Verify” and monitor the progress bars. 6.) If the “Verify” button highlights green it was successfully programmed, and review programmed data in the fields below to make sure it is correct. 7.) make sure to select the Brother QL-700 printer from the drop down list. 8.) Click on the “Print HEX Label” button a box will appear that will allow you to enter up to six lines of text we recommend that you record what aircraft identification number it is programmed for, the facility doing the programming or any other information you would like to inclu

• ACK! E-04 ELT, ANNEX A A list of contacts for each country can be accessed on the COSPAS/SARSAT web site www.cospas.org on the web site go to “Contacts” and select “National Contacts for Beacon Matters (Coding, Registration and Type Approval)” 8

More Instructions:

ACK! E-04 ELT User's installation and operation manual 28-03-2023 20

DOWNLOAD

Related Products and Documents (GPS):

Comparable Devices:

Similar Resources:

• TCW Technologies IPS-24v-5a (6 pages) 1 Intelligent Power Stabilizer & Up-converter Model: IPS-24v-5a The Intelligent Power Stabilizer, IPS, is an electronic power converter for critical electrical equipment found in general aviation aircraft. The IPS system provides aircraft bus voltage surge and sag protection for the connected electrical equipment. The IP …

• Kenwood KNA-G620T (24 pages) GPS NAVIGATION SYSTEMKNA-G620T GPS NAVIGATION INSTRUCTION MANUAL© B64-4718-08190-01160-90_0A.indb 1190-01160-90_0A.indb 1 1/4/2010 9:16:08 AM1/4/2010 9:16:08 AM …

• Becker Z 302 (2 pages) BECKER TRAFFIC ASSIST PRO Z 302 TRUCK NAVIGATIONTruck navigation available in:> A > B > CH > D > DK > E > F > FIN> GB > I > L > N > NL > PL > SIncluded on NAVTEQ Database:> A > AL > AND > B > BG > BIH > BY > CH > CZ > D > DK > E > EST > F > FIN > …

• Lowrance iWAY 600C (2 pages) Printed in USA 011007 Pub. 988-0160-361 1WARNING! Vehicle drivers should never attempt to configure, adjust or enter information into a GPS unit while driving. Safety Mode prevents drivers from operating the GPS while the vehicle is in motion. The unit will navigate and play music while moving b …

• Tramigo T21 (13 pages) T21 Installation Guide © 2006 Tramigo Ltd. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of Tramigo. Tramigo T21 Installation Guide V1.2 …

• Winter 7 FMS 2 (2 pages) 7 FMS 47 FMS 5* siehe "Sonderausstattung und Festlegung der Sachnummer" *see "Special equipment and definition of part number"Bezeichnung des GerätesInstrument descriptionStaudruck-Fahrtmesser7 FMS 2Pitot airspeed indicator7 FMS 2Staudruck-Fahrtmesser7 FMS 5Pitot airspeed indicator7 FMS 5Staudruck-Fahrtmesser7 FMS 4Pitot airsp …

Comments, Questions and Opinions: