Darim PVE400M Operation & User’s Manual

Text of Darim PVE400M User Guide:

• Darim PVE400M, PVE400M USER’S GUIDE Figure 10. Security warning dialog If the plug-in has been correctly installed, video can be also viewed directly in the Windows Media Player, without the need to open IE. In this case, select Open URL command from the File menu in the Windows Media player. URL will be “rtsp2://192.168.1.250” (IP address of PVE400M) If Windows XP Firewall is enabled, you may need to unblock the Windows Media Player Application The third option is using Darim’s Video Spider software, it can be purchased separately. The Video Spider software will you allow to monitor and record data from multip

• Darim PVE400M, PVE400M USER’S GUIDE Figure 8. Video and Audio configuration page PVE400M can operate in PA L or NTSC mode. The Video Standard field represents the current selection of the video standard. Using the Capture Resolution drop-down list you can choose a required resolution. Currently four different resolutions are supported. The Video Frame Rate drop-down list allows selecting the target frame rate (in frames per second). It depends on the link quality and the actual frame rate can vary, but it will not exceed the specified value in this field. The Video Encoder Target Rate parameter field serves for spec

• Darim PVE400M, PVE400M USER’S GUIDE 4. Advanced configuration 4.1 Firewall To provide the additional layer of security, the PVE400M unit supports IP and MAC address filtering on the Wireless interface in order to prevent unauthorized subscribers from accessing the device. The Trusted IP Filter or the White List dialog box (see Figure 13) represents the devices which are allowed to access the PVE400M unit, either for configuring or requesting a video stream. By default, the list is empty. Any device can be connected to the PV

• Darim PVE400M, PVE400M USER’S GUIDE 7.3 CE Mark Certification The CE mark is the official marking required by the European Community for all Electric and Electronic equipment that will be sold, or put into service for the first time, anywhere in the European community. It proves to the buyer or user that this product fulfils all essential safety and environmental requirements as they are defined in the European Directives. PVE400M is covered under the product certification Europe: Radio Spectrum : EN 300 328 V1.7.1 (2006-10) EMC: EN 301 489-17 V1.2.1 (2002-08) Safety: EN 60950-1 2001 +A11: 2004 Health: EN50360: 2001 (Specific Absorption

• PVE400M USER’S GUIDE Copyright © 2007 Darim Vision Co, All Rights Reserved - 30 - 8.4 List of accessories Ordering Part name Description PVE-AV Audio-in/Video-in/DC-out inline cable with Fischer 5 pin connector PVE-AUX 5 feet CAT5E cable with Ethernet RJ45 to Fischer 10pin connector PVE-NCC Nylon Carrying Case with strap an belt loop

• Darim PVE400M, PVE400M USER’S GUIDE PVE-AUX cable wiring table AUX pin # Wire color RJ45 pin # Purpose 1 green 6 Ethernet 2 white/orange 1 Ethernet 5 white/brown 7 reserved 6 white/green 3 Ethernet 7 orange 2 Ethernet 8 white/blue 5 RS232 common 9 brown 8 RS232 Rx 10 blue 4 RS232 Tx Note: Ethernet wired as straight through (T568B). DC power jack Center pin - +10-16V 2A Max Standard 5mm with center pin 2.1 mm DC power connector Mating plug – Kobiconn P/N 1710-2111 www.mouser.com Copyright © 2007 Darim Vision Co, All Rights Reserved - 29 -

• Darim PVE400M, PVE400M USER’S GUIDE Figure 6. Ethernet configuration page 3.2.2 Wireless connection configuration The WIRELESS configuration tab is related to WMC6300/7300 setup. The IP mode field allows you to select either DHCP Client, Static IP Assignment or Disabled mode. For Statically Provisioned mode, use DHCP Client selection. The MAC Address field is a read-only parameter and serves for verification purpose. The same information can be found on the sticker on the bottom of PVE400M. Copyright © 2007 Darim Vision Co, All Rights Reserved - 14 -

• Darim PVE400M, PVE400M USER’S GUIDE 2.1 Installing antenna Attach the supplied antenna to RP-SMA jack. Figure 3. Attaching the supplied antenna Warning: The only supplied antenna with 2.0dBi gain is certified to use with PVE400M when the device is used as wearable. Copyright © 2007 Darim Vision Co, All Rights Reserved - 7 -

• Darim PVE400M, PVE400M USER’S GUIDE 7. Regulatory Information 7.1 FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Federal Communication Commission (FCC) statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable prot

• Darim PVE400M, PVE400M USER’S GUIDE 1. GENERAL INFORMATION 1.1 Introduction Developed for the most challenging environments, the Darim PVE400M Portable Video Encoder/Streamer is a robust, single channel video encoder for capturing, encoding and streaming high quality MPEG4 video and audio through a wireless interface. This compact and portable unit supports field-operational features such as Fischer Auto-Locking/Quick-release Interfaces, Aluminum crush-proof encasement, Waterproof Head-camera and Field-replaceable Lithium-ion battery, sp

• Darim PVE400M, PVE400M USER’S GUIDE Notice The information in this document is subject to change without prior notice in order to improve reliability, design, or function and does not represent a commitment on the part of this company. Copyright © 2007 Darim Vision Co. All Rights Reserved. No part of this reference manual may be reproduced or transmitted in any form or by any means without the prior written permission of this company. Throughout this manual, we make reference to product names that are trademarks o

• PVE400M USER’S GUIDE 8.3 Connectors pin out AUX connector Pin # Designation 1 Ethernet Rx Data- 2 Ethernet Tx Data+ 3 +12V input 4 reserved 5 Common ground 6 Ethernet Rx Data+ 7 Ethernet Tx Data- 8 RS232 ground 9 RS232 Rx 10 RS232 Tx Mating male connector Fischer S1031 A010-140+ A/V connector Pin # Designation 1 Video in 2 Audio input 3 Audio gr

• Darim PVE400M, PVE400M USER’S GUIDE Features: • Real-time hardware MPEG4 Video and G.711 Audio Compression • Personal Wireless Router for locally attached Ethernet Devices • Support of Motorola’s Mobility Enhanced Access (MEA®) in 2.4GHz or 4.9GHz • Wireless communication with control center • Integrated “Bullet head-camera” or Generic video camera cable options • Individual WEB interface capability • Crushproof, watertight case and connectors • DC 12V output for camera power feed

• PVE400M USER’S GUIDE 3.5 Monitoring the battery status The BATTERY tab provides the useful information about the battery status. The negative current value is shown for discharging (normal operation) and positive during battery charging. The normal value is 1~2A, depending on the transmitter power and streaming video status. When streaming video is not act

• Darim PVE400M, PVE400M USER’S GUIDE 2. INSTALLATION STEPS This chapter describes the installation procedure of the PVE400M accessories. Figure 2. PVE400M interface Copyright © 2007 Darim Vision Co, All Rights Reserved - 6 -

• Darim PVE400M, PVE400M USER’S GUIDE Figure 7. Wireless configuration page For the Static IP Assignment mode, enter the proper information for IP address, Subnet Mask and Default Gateway (if required). If any changes have been made on this page, click the [Apply] button; otherwise simply select the other tab. 3.3 Video and audio configuration The CONFIG page contains all Video/Audio related parameters. Copyright © 2007 Darim Vision Co, All Rights Reserved - 15 -

• Darim PVE400M, PVE400M USER’S GUIDE 4.2 IP router As the PVE400M unit has two network interfaces, it can act as a wireless router. By default IP forwarding is enabled. All you need is to configure IP settings of the external devices, so that they will be in the same IP segment as PVE400M Ethernet, and PVE400M will be as the default gateway for them. Example: Ext device #1 PVE400M Ethernet side PVE400M Wireless side IP 192.168.1.2 IP 192.168.1.250 IP 172.31.1.200 MASK

• Darim PVE400M, PVE400M USER’S GUIDE limited by the throughput of the wireless network, which is about 1Mbps in case of using WMC6300/7300 cards. This bandwidth will be shared by all users in the network. Video streaming uses RTSP/RTCP/RTP protocols, bit rate and frame rate will be automatically adjusted depending on the link quality, but will not exceed the selected values in the Video Frame Rate and Video Encoder Target Rate selection fields. If any changes have been made on this page, click the [Apply] button, otherwise simply select other tab. The [Restart

• Darim PVE400M, PVE400M USER’S GUIDE 3.6 Upgrading firmware The PVE400M firmware can be upgraded using the UPGRADE tab. Figure 12. Firmware upgrade page The update image can be accessed using FTP protocol. Type URL for the firmware image and press the [Upgrade] button. In case of successful connection, the upgrade process will take 5-10 minutes. Do not interrupt the power supply within this period. Once the update process is finished, PVE400M will automatically reboot. Check the LED status, as soon as the device is booted up, and reconnect

• PVE400M USER’S GUIDE 5. Customer Service Information If the product fails to perform either during the warranty period or after, contact Darim’s designated regional representative for troubleshooting and potential RMA information. The nearest Darim’s Regional Representative can be found at www.darimcctv.com/pve/rep . Or send an e-mail to [email protected] . The Regional Re

• Darim PVE400M, PVE400M USER’S GUIDE 2.7 Using wired network connection PVE400M has a standard 10/100Base-T Ethernet adapter accessible via AUX connector. Since AUX connector is also used for RS232 interface and external power, a special cable is required to use Ethernet function. PVE-AUX is 5 feet (1.5m) CAT5E grade cable with RJ45 plug (T568B) on one side and Automatic Latching, Self Aligned 10 pin connector on the other side. Gently plug and rotate AUX side of the connector until it mates, and push to lock.

• Darim PVE400M, PVE400M USER’S GUIDE 6. Product Warranty Information Limited Warranty Our company warrants this product against defects in materials and workmanship for a period of one year from the date of purchase. During the warranty period, products determined by us to be defective in form or function will be repaired or replaced at our option, at no charge. This warranty does not apply if subjected to any of the following: abuse, improper use – negligence, accident, fire, modification, failure of the end-

• Darim PVE400M, PVE400M USER’S GUIDE 3.2 Network configuration 3.2.1 Wired connection configuration The NETWORK configuration tab allows to specify all related settings if the device is used with AUX Ethernet cable. The Internal Ethernet adapter supports 10 and 100 Mbps speed and Half and Full Duplex mode. When the Ethernet speed parameter is selected as Auto, it will be automatically set accordingly to the connection. The Ethernet IP mode drop-down list allows you to select the IP configurations parameters:  DHCP Server - PV

Related Products and Documents (TV Tuner):

Comparable Devices:

Similar Resources:

• Pioneer Super Tuner III D AVH-P6550DVD (8 pages) CAUTION:• PIONEER does not recommend that youinstall or service your display yourself.Installing or servicing the product mayexpose you to risk of electric shock orother hazards. Refer all installation andservicing of your display to authorizedPioneer service personnel.• Secure all wiring with cable clamps orelectrical tape. Do not allow any barewiring t …

• Sabrent TV-USBHD (18 pages) Sabrent TV-USBHD HYBRID USB HDTV TV TUNER WITH FM RADIO & REMOTE CONTROL (ATSC DIGITAL/CLEAR QAM/NTSC ANALOG) Driver Installation: 1. Connect your TV-USBHD dongle into an open USB 2.0 port on your computer. 2. Insert the software disc into your computer’s disc drive. When prompted, click on Run AUTORUN.EXE: 3. Click on Install Driver: 4. When …

• Hikari SKY PerfecTV (4 pages) Connect the HD TunerConnect the HD TunerConnect the HD TunerConnect the HD TunerConnect the HD TunerConnect the HD TunerConnect the HD Tuner3Connect the HD tuner and television terminal4Connect the HD tuner and televisionCoaxial cable (commercially available)Telephone cord (accessor y)Telephone or facsimile machineIf this screen is displayed, setup is comple …

• Terra MHI512R (2 pages) connect to network iconQuickstart Guide MHI512R• Aer the 1st login, select the country and the language of WEB control interface.• If you want to control your Set-Top box: o insert IR blaster aachment to streamer IR socket and direct its head to STB front panelo read user manual secons 5.3 and 5.4 how to congure virtual remote controller, ad …

• ADS Technologies PTV-338-EF (1 pages) Instant Digital TV USB Hardware Installation GuideNorth American OfficeADS Tech Inc, USA12627 Hidden Creek WayCerritos, CA 90703, USAWebSite: www.adstech.comEmail: [email protected]: +1.562.926.4338Southern Europe | MEA Office ADS Tech SARL France51/55 Rue Hoche94200 - Ivry Sur Seine, FranceWebSite: www.adstech.frEmail: [email protected] …

• ZyXEL Communications WAP6405 (3 pages) Hardware InstallationInstallation der Hardware | Instalación del hardwareInstallation du matériel | Installazione hardwareMaskinvaruinstallation | Hardware Installatie硬體安裝1/3Copyright © 2016 Zyxel Communications Corp. All Rights ReservedQuick Start GuideWAP64055G AC1750 Gigabit Wireless BridgeEU Importer: Zyxel Communication A/S, Generatorve …

Comments, Questions and Opinions: