Manualios.com

Artec Mini Tracker 505 Operation & User’s Manual

Artec Mini Tracker 505 Manual Online:

4.55, 2881 votes
Artec Mini Tracker 505 User Manual
Artec Mini Tracker 505 User Guide
Artec Mini Tracker 505 Online Manual

Text of Artec Mini Tracker 505 User Guide:

  • Artec Mini Tracker 505, Switch to sleeping mode 13 Sleeping Under Standby mode Stop signal to Slave No linking then into sleeping mode and stop flash Slave flashes half minute to wait for re-linking 2 1 Switch the button to section 0 (OFF)

  • Artec Mini Tracker 505, 9 321 Search Mute searching melody from Master. Listen beep sound from Slave to assist short range searching. Press & hold the LED light button Stop the melody Listen to the beep sound from Slave Beep 2 2

  • Artec Mini Tracker 505, 0 m 100 m Search 8~16 m Alarm Master Slave Slave LR 1 2.4GHz ISM2.4GHz ISM 130 × 2 19×28×7.5 mm 8~16m Alarm Trident Direction Z Z Z Z Sleeping Mode Master 39×48×6.8 mm Frequency Battery LR 44 × 2 Switch 2 buttons Size Slave ON / OFF / MUTE Button 4 No Alarm Working Method Specification Base on open frame condition. 0~80m

  • Artec Mini Tracker 505, Master 1 2 5 The Battery Installment 1 2 3 1 1. Open from the fillister on the bottom of housing or curve side by your nail, like open shell. 2. Put 2pcs batteries into. *** Make sure the installment direction of positive (+) & negative (-) of battery are followed up the drawing showed on the inside of back battery cover. 3. Set back the battery cover. Slave 1. Press the clip on battery cover then push backwardly. 2. Put 2pcs batteries into. *** Make sure the installment direction of positive (+) & negative (-) of battery are followed up the drawing showed on battery cover. 3. Set the battery cover back.

  • 6 Getting Started For the first time use, please set the battery into Master according to above battery installment . Switch to power on Pull out Plastic isolation Place two devices no more than 10 cm apart. Signal indication Signal LED ON for re-linking. Distance indication Beep Re-link successful! Master shows the distance with Slave via LED and melody (beep). Press Search button to stop

  • Mute Mute (Mute At Search mode, Or No Need The Guard Service) 1 2 Switch the button to section 2 (MUTE) 3 Only Display the distance indication LED without searching melody Under Standby mode Switch to Mute mode Press Search button Under mute mode, the Alarm function is disabled. 15

  • Artec Mini Tracker 505, 14 Switch the button to section 1 (ON) Signal LED ON for re-linking Available for distance within 80 meter Re-link successful! Master shows the distance between Slave via LED and melody (beep) Distance indication Signal indication Beep Beep 1 2 Beep Can't get signal from Slave. Signal LED flashes each second & comes with beep. (Slave maybe out of working range 100 meter, or no power.) Re-link / Wake up

  • Artec Mini Tracker 505, Search 1 2 Press Search button 2~3 seconds Start to detect the location of Slave. Near Far 7 Correct holding Wrong holding Error indication - whole direction LED goes off but signal LED lights up 3 seconds then displays new searched distance. 1.) Search from correct direction to wrong direction 2.) Over pass 1.) LED light: more closer, more lights. 2.) Search melody: more closer, more rapid.

  • Artec Mini Tracker 505, 10 Search 3 Stop searching Back to Standby mode Signal LED flashes every second for re-linking Signal indication Press Search button 2~3 seconds Error indication - whole direction LED goes off but signal LED lights up 3 seconds then displays new searched distance. 1.) Search from correct direction to wrong direction 2.) Over pass

  • Artec Mini Tracker 505, Search North South East West 2 Distance LEDs 3 Distance LEDs. The strongest signal direction ! Turn to different directions for signal comparison One Distance LED only 2 Distance LEDs 8 1 2 Go the way of the strongest signal direction to find out Slave.

  • Artec Mini Tracker 505, East North 11 North East 0 ~ 80 m Signal indication Distance LED goes out all lights suddenly and only flash Signal LED with beep sound LED displays new searched distance Go back to original search direction or location 4 21 3 Location: North Go to the wrong direction Original searching (Right direction) [Suggestion] 3 seconds later Searching Example

  • Artec Mini Tracker 505, Low Battery If this kit is under low battery stage, it may cause abnormal display to alarm, beeps or non-working to confuse actual working stage. Please change new battery as soon as possible. 16 1 beep sound every 120 seconds continuously.

  • Artec Mini Tracker 505, 3 Signal indication Master Slave Front Front Back Back Search button Signal indication Distance indication Right direction Mode switch Mute Power on (Standby) Power off (Sleeping) Buzzer Battery cover Left direction Hanging hole for strap Mute distance melody button at search mode Hanging hole for strap Clip Overview

  • Artec Mini Tracker 505, (a) Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, remove the battery, and allow the device to dry completely before replacing it. (b) Do not use or store the device in dusty, dirty areas. Its moving parts and lectronic components can be damaged. (c) Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. (d) Do not store the device in cold areas. When the device returns to its normal t

  • Artec Mini Tracker 505, Recycle: The Battery provided in this product should be recycled to protect the local environment. Please contact with local recycle department for detail. 2 FCC Certifications Federal Communication Commission Interference Statement This equipment has been tested and improved to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radia

  • Artec Mini Tracker 505, Alarm 1 2 Beep Beep Over 8~16 meter. Come with beep! Stop alarm (beep) if both devices comes within 8 meter again. Signal indication When Slave and Master are over 100 meter or lose signal Caution Slave flashes half minute to wait for re-linking No linking then into sleeping modeand stop flash 12

Related Products and Documents (GPS):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Konica Minolta bizhub PRO C6501/C6501P Operation & user’s manual konica-minolta/bizhub-pro-c6501-c6501p-D4X.pdf 05 Jan 2024 32
2 Prestige 1287181 Installation instructions manual audiovox/1287181-9H4.pdf 21 Nov 2022 24 0.69 Mb
3 XO Vision X358 Operation & user’s manual xo-vision/x358-5T5.pdf 16 Nov 2022 14
4 Summit 660-LP Owner's manual summit/660-lp-G92.pdf 12 Jan 2024 104 26.39 Mb
5 Hanna Instruments HI 93728 Instruction manual hanna-instruments/hi-93728-UHK.pdf 21 Mar 2023 2 0.46 Mb
6 Yamaha PORTATONE PSR-SQ16 List book yamaha/portatone-psr-sq16-D5L.pdf 02 Aug 2022 28 2.39 Mb

Similar Resources:

  • Midcontinent

    4300 Series

    (9 pages)
    MANUAL NUMBER 9015834-1 REV. D September 30, 2009 PILOTS GUIDE for the 4300-xxx Series Electric Attitude Indicator Mid-Continent Instruments and Avionics 9400 E. 34th Street N., Wichita, KS 67226 USA Phone 316-630-0101  Fax 316-630-0723 [email protected]
  • Tirol

    GT02

    (20 pages)
    GPS TRACKER USER MANUAL PREFACE Thank you for purchasing GPS tracker. This manual shows how to operate the device smoothly in details, please make sure to read this manual carefully before using the device. Please be noted that any update of the manual is made without prior notice. Each time the update of the manu …
  • Navman

    W300

    (10 pages)
    Setting optionsNAVMANPress and hold to enter setupPress repeatedly to step through the setting options. Press both buttons together ( ) to start or stop editing a setting option.While editing, press or repeatedly to step through selectable states, or increase/decrease values. Press and hold the appropriate button to increase/decrease values quickly.Set …
  • Holux

    GR-239

    (3 pages)
    1Car Cigarette Lighter Powered Bluetooth GPS Receiver z Item No.: GR-239 z Product Name: Car Cigarette Lighter Powered Bluetooth GPS Receiver z Description: The cigarette lighter powered Bluetooth GPS receiver, GR-239, incorporates the latest Bluetooth technology and contains the newest generation SiRFstarIII chipset for high sensitivity, featuring par …
  • Mr Handsfree

    BLUE DONGLE 2

    (68 pages)
    NL-1 INLEIDING……………………………………………………………………………… 2 SYSTEEMVEREISTEN……………………………………………………………….. 2 SOFTWARE INSTALLATIE………………………………………………………….. 2 HARDWARE INSTALLATIE………………………………………� …
  • MeiTrack

    T1

    (13 pages)
    MEITRACK RFID User Guide MEITRACK RFID User Guide Applicable Model: T1/T333/MVT600 …

Comments, Questions and Opinions: