Hitachi CM827ET Operation & User’s Manual

Text of Hitachi CM827ET User Guide:

• Hitachi CM827ET, 1 - 11 ENGLISH OPERATION (Continued) Table 1-1. Adjustment Table Item Adjustment button Function BRIGHTNESS decreases the picture’s brightness. increases the picture’s brightness. CONTRAST makes the picture’s contrast darker (not including the background). makes the picture’s contrast brighter (not including the background). MAIN MENU change to the previous mode. H. SIZE  ZOOM  OSD EXIT  DEGAUSS  DMS  COLOUR MENU?  COLOUR SELECT  OSD MENU?  RECALL MENU?  SCREEN MENU?  ROTATION  PIN. BALANCE  PARALLELOGRAM �

• Hitachi CM827ET, 1 - 4 ENGLISH CAUTIONS (Continued) CAUTION (for 200 - 240V operation only) This equipment relies on the protective devices in the building installation for short-circuit and power surge protection. Refer to the following table for the suitable number and location of the protective devices which should be present in the building’s installation. Informative examples of protective devices in single - phase equipment or sub-assemblies Protection against Minimum number of fuses or circuit - breaker poles Location Case A:

• Hitachi CM827ET, 1 - 17 ENGLISH TROUBLESHOOTING The following Table 1-4 is provided to assist you with common installation issues. Table 1-4. Troubleshooting Symptom Solution No power Verify that the power cord is installed correctly. Press the power switch. No picture Increase Contrast and Brightness. Check Input Select status. No picture and the power indicator lights orange Check the Signal Cable Connection. Check the Power Connection to the computer. Check Input Select status. “POWER SAVE” message appears Check the Signal Cable Connection. Check the Power Connecti

• 1 - 12 ENGLISH OPERATION (Continued) Table 1-1. Adjustment Table (Continued) Item Adjustment button Function (MAIN MENU) TRAPEZOID shrinks the top side of the picture, and expands the bottom side of the picture. expands the top side of the picture, and shrinks the bottom side of the picture. PINCUSHION curves the left and right

• Hitachi CM827ET, 1 - 13 ENGLISH OPERATION (Continued) Table 1-1. Adjustment Table (Continued) Item Adjustment button Function (MAIN MENU) OSD EXIT (no function) clears the OSD. (YES) ZOOM shrinks the picture horizontally and vertically. expands the picture horizontally and vertically. SCREEN MENU changes to the previous mode. H. MOIRE  HEMISPHERE  V. LIN. BALANCE  V. LINEARITY  H. CONV.  V. CONV.  BOTTOM CORNER  TOP CORNER  V. FOCUS

• Hitachi CM827ET, Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development SE-114 94 Stockholm, Sweden Fax: +46 8 782 92 07 Email (Internet): [email protected] Current information regarding TCO'99 approved and labelled products may also be obtained via the Internet, using the address: http://www.tco-info.com/ Environmental requirements Flame retardants Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay the spread of fire. U

• Hitachi CM827ET, 1 - 14 ENGLISH OPERATION (Continued) Table 1-1. Adjustment Table (Continued) Item Adjustment button Function (SCREEN MENU) H. FOCUS makes the horizontal dynamic focus weaker. makes the horizontal dynamic focus stronger. V. FOCUS makes the vertical dynamic focus weaker. makes the vertical dynamic focus stronger. TOP CORNER curves the left and right top corners of the picture inwards. curves the left and right top corners of the picture outwards. BOTTOM CORNER curves the left and right bottom corners of the p

• Hitachi, Ltd. Tokyo, Japan International Sales Division THE HITACHI ATAGO BUILDING, No. 15 –12 Nishi Shinbashi, 2 – Chome, Minato – Ku, Tokyo 105-8430, Japan. Tel: 03 35022111 HITACHI EUROPE LTD, Whitebrook Park Lower Cookham Road Maidenhead Berkshire SL6 8YA UNITED KINGDOM Tel: 01628 643000 Fax: 01628 643400 Email: consumer-service@hitachi-eu

• Hitachi CM827ET, 1 - 15 ENGLISH OPERATION (Continued) Table 1-1. Adjustment Table (Continued) Item Adjustment button Function OSD MENU changes to the previous mode. OSD H. POS.  LANGUAGE SELECT  OSD V. POS.  OSD H. POS. changes to the next mode. OSD H. POS.  OSD V. POS.  LANGUAGE SELECT  OSD H. POS. OSD H. POS. moves the OSD to the left. moves the OSD to the right. OSD V. POS. moves the OSD down. moves the OSD up. LAN

• Hitachi CM827ET, 1 - 3 ENGLISH CAUTIONS Discontinue Use if Abnormal Operation Occurs ! Abnormal operations such as smoke, burning smell, excessive sound, etc. could cause fire or electrical shock. If you observe any abnormal operation, you should turn off the monitor and disconnect the power plug from the power outlet. You should check for smoke or fire and contact your dealer. Do not expose the monitor to physical impact ! Do not allow foreign objects (water, metal, etc.) inside ! Never remove the cover of the monitor! This colour moni

• Hitachi CM827ET, 1 - 19 ENGLISH SPECIFICATIONS (Continued) Standard Settings Microprocessor-based user preset functions can store 32 sets of geometry settings. The following industrial standard settings have been pre- programmed by the factory. Table 1-5. Standard Settings No. Video Mode Name (with Resolution and Vertical Frequency) Horizontal Frequency CM827 CM828 1 VGA 640 × 400 - 70 Hz 31.47 kHz √ √ 2 VESA 800 × 600 - 85 Hz 53.67 kHz √ √ 3 VESA 1024 × 768 - 85 Hz 68.68 kHz √ √ 4 VESA 1152 × 864 - 75 Hz 67.50 kHz √ 5 Mac 1152 × 870 - 75 Hz 68.68 kHz √ √ 6 VESA 1

• Hitachi CM827ET, 1 - 5 ENGLISH CAUTIONS (Continued) FCC Statement Warning WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference wi

• Hitachi CM827ET, 1 - 18 ENGLISH SPECIFICATIONS CRT 21 inch type picture tube, 0.21mm horizontal dot pitch, 0.20 mm horizontal mask pitch, Invar shadow mask, Black matrix, Short persistence phosphors, Dark tint, Anti-Reflection coat. Input Signal Video 0.70 Vp-p, Analogue Sync. Separate H/V, TTL level Composite H/V, TTL level Synchronization CM827 CM828 Horizontal 31 - 107 kHz 31 - 115 kHz Vertical 50 - 160 Hz 50 - 160 Hz Resolution Horizontal up to 1856 dots up to 2048 dots Vertical up to 1392 lines up to 1536 lines Viewable Image Size 20.

• Hitachi CM827ET, 1 - 10 ENGLISH Brightness/Contrast Adjustment (1) Press one of the adjustment buttons when the OSD (On Screen Display) is not shown. The OSD function “EasyMenu” will then show the brightness and contrast settings. (2) To adjust these settings, use the adjustment buttons / for brightness, and / for contrast. Other Functions (1) Press the menu button when the OSD is not shown. The OSD function “EasyMenu” will then show the main menu. The EasyMenu has 4 submenus (Screen Menu, Recall Menu, OSD Menu and Colour Menu). You can call these up through the mai

• Hitachi CM827ET, 1 - 8 ENGLISH INSTALLATION (Continued) Connecting the monitor Front View Rear View 1. Installation Install the monitor in a suitable environment. Do not place the monitor on an unstable base. Do not expose the monitor to rain, moisture, dust, corrosive gases, vibrations, etc. so as to prevent electrical shock or fire hazard. Avoid placing the monitor in direct sunlight or near heating appliances. 2. Signal Cable Connection (1) Use video signal cable which is included in the carton box. (Cable part number: DC190018510 ) (2) Insert the

• 1 - 1 ENGLISH Colour Monitor (DJ82) CM827ET CM828ET USER MANUAL Congratulations on your selection of a HITACHI Colour Monitor. Read the instructions inside carefully, and keep this user manual for future reference. NOTE: • The information in this manual is subject to change without notice. • The manufacturer assumes no responsibility for any errors t

• Hitachi CM827ET, TCO’99 STATEMENT Congratulations! You have just purchased a TCO'99 approved and labelled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. This product meets the requirements for the TCO'99 scheme which provides for an international environmental and quality labelling of personal computers. The labelling

• Hitachi CM827ET, 1 - 9 ENGLISH OPERATION Power ON/OFF Press the power switch to switch the power ON or OFF. When the power is ON, the power indicator will light up. NOTE: • First turn on the monitor, then the computer. • After turning OFF the power switch, wait at least 5 seconds before restarting the monitor. If this 5 second delay is not observed, the monitor may operate incorrectly. Input Select This monitor has two input terminals, INPUT1 and INPUT2. This will let you connect two computers simultaneously. When two computers are active, you can switch the input signal by uses the Input Select Button. Every time this b

• Hitachi CM827ET, 1 - 20 ENGLISH SPECIFICATIONS (Continued) Pin Assignment Signal Input Connector of the Monitor Table 1-6. Pin Assignment Pin No. Input 1 Input 2 1 Red Video Red Video 2 Green Video Green Video 3 Blue Video Blue Video 4 No pin No pin 5 No connection No connection 6 Red Ground Red Ground 7 Green Ground Green Ground 8 Blue Ground Blue Ground 9 No connection No connection 10 Ground Ground 11 No connection No connection 12 Bi-directional Data [SDA] No connection 13 H-Sync. (or H/V) H-Sync. (or H/V) 14 V-Sync. [VCLK] V-Sync. 15 Data Clock [SCL] No connection

• Hitachi CM827ET, 1 - 16 ENGLISH POWER SAVING SYSTEM This monitor complies with VESA and ENERGY STAR ® power saving requirements. The power saving system works only when used with VESA DPMS compliant PC’s and/or graphic controllers. Table 1-2. Power Saving System VESA DPMS Power Saving States Power Saving Mode Video H. Sync. V. Sync. Power Power Indicator LED ON Active Yes Yes 115 W (typical) Lights Green Stand-by Blanked No Yes Less than 10 W Suspend Blanked Yes No Lights Orange Active OFF

Related Products and Documents (Monitor):

Comparable Devices:

Similar Resources:

• Samsung LH43PMFXTBC/EN (89 pages) The colour and the appearance may differ depending on the product, and the specications are subject to change without prior notice to improve the performance. Recommended hours of use per day for the PM32F-BC models is less than 16 hours. If the product is used for longer than 16 hours a day, the warranty may be void. This product is a digital touch signa …

• POSIFLEX LM-3010F/HS (20 pages) Part 1 FCC NOTICE This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions manual, may cause interference to radio communications. It has been tested and found to comply with limits for a Class A digital device pursuant to subpart J of Part 15 of FCC Rules, which are desi …

• BenQ SE2241 (88 pages) 1 Applicable Country & Regions: Europe Product Service Manual – Level 2 Service Manual for BenQ: Monitor-TV/SE2241 <9H.V0375.JAE> Version: 00a Date:2009/04/20 Notice: For RO to input specific “Legal Requirement” in specific NS regarding to responsibility and liability statements. Please check BenQ’s eSupport web site, http://esupport.ben …

• American Dynamics 46 and 50-inch (2 pages) FEATURESRendering bright images in stunning detail,American Dynamics plasma monitors are theperfect choice for video security and publicdisplay. At less than four inches deep, theyinstall easily on any wall and require minimalspace. These large screens yield bigger images fromquads, multiplexers and digital video recorders(DVRs), making it easier to closel …

• Carel PGD1000F00 (2 pages) cod. +050001050 rel. 1.3 - 15.12.2011 PGD1000F*0/PGD1000W* 0 / PGD1010YW0 pCO display grafico / pCO Graphic DisplayVi ringraziamo per la scelta fatta, sicuri che sarete soddisfatti del vostro acquisto.Il display grafico pGD è un dispositivo elettronico, compatibile con i precedenti terminali della linea PCOI/PCOT, che consente la completa gestione della …

• Vitek VTM-LCD561 (2 pages) VTM-LCD561ModelVTM-LCD561Display Type5.6" TFT LCD PanelInput SignalNTSC or PALVideo: 1Vp-p/75 ohmAudio: 1Vp-p/100k ohmDisplay FrequencyNTSC: Fh=15.73KHz, fv=60HZPAL: Fh=15.63KHz, fv=50HZDisplay Resolution960 x 234 dpiDisplay ColorFull colorInputVideo Input x2Audio input x2FunctionsFunctions controlled by OSD (On screen display)Audio Volume: Audio outpu …

Comments, Questions and Opinions: