Manualios.com

Fox FAI-8200 Instruction Manual

Fox FAI-8200 Manual Online:

3.55, 806 votes
Fox FAI-8200 User Manual
Fox FAI-8200 User Guide
Fox FAI-8200 Online Manual

Text of Fox FAI-8200 User Guide:

  • Fox FAI-8200, 1 FAI-8200 2-Way Color LED FM technology Security System Features 1. 1 Two Way LED Remote Transmitter and 1 one way 2 nd remote 2. Code Hopping and Code Learning Remote System 3. Up to 4 LED remote transmitters Programmable 4. Remote Engine Start 5. Remote Arm/Disarm 6. Mute Arm/Disarm 7. Starter Kill (500mA negative output) in arming mode 8. Remote Trunk Release 9. Passive or Active Lock Programmable 10. Auto Re-arm 11. Lock/Unlock on driving 12. Silent Car Searching 13. Vibrate or Audible Alert 14. Low level of Battery Indication 15. Audible Intrusion Zone Identification 16. Defective Zone Alert and By-pass 17. Back-up Mem

  • Fox FAI-8200, 2 Press Button (3) once Car Finder Car Finder Car Finder Press Button (4) once Lighted Display Lighted Display Lighted Display Press Button (4) over 3 sec. Remote Start On/Off Remote Start On/Off Press Button (1)+(2) once Mute Disarm Mute Arm Valet Mode Press Button (1)+(4) over 1 sec. Timer Start Mode Timer Start Mode Timer Start Mode Press Button (2)+(3) Status Report Status Report Status Report Press Button (3)+(4) Vibrate Alert On/Off Vibrate Alert On/Off Vibrate Alert On/Off Press Button (2)+(4) Save mode Save mode System Features Transmitter Code Learning Take the following procedures to perform t

  • Fox FAI-8200, 3 and off in a cycle (30 seconds) to indicate the door is triggered. f) Hood or trunk open and then closed: The parking lights will flash and siren sound for one cycle 30 seconds. The LED wire will flash 2 times and off in a cycle (30 seconds) to indicate the ignition is triggered. The LED wire will flash 2 times and off in a cycle (30 seconds) to indicate the hood or trunk is triggered. g) Hood or trunk open and not closed: Siren will sound for three cycles (siren will stop for 5 seconds and sound again for next cycle). Hood or trunk switches will be bypassed until they are closed. The L

  • Fox FAI-8200, 4 Emergency Override Mode As an emergency situation happens like the remote transmitters lost, you can override the full security system. a) Open the door by your car key and the alarm will be triggered. b) Switch the ignition on/off 6 times, the siren will be off and the system is disarmed. Remote Valet Mode This mode is a convenient feature to use when you hand the remote transmitter to third person for valet parking or vehicle service. a) When the system is disarmed, switch the ignition on and press button (1) and (2) once simultaneously, the siren will chirp once and then the system enters into the valet mode. Under this mode, drivers can control only door lock/unlo

  • Fox FAI-8200, 5 2. Pull up the parking brake. 3. Remove the key from the ignition. The engine will keep running. 4. Exit the vehicle and close the door after taking Step# 3. Then the engine will shut down and the reservation mode is set up. Important: Reservation mode must be set up every time before exiting manual transmission cars in order to remote start. Reservation mode will be activated only when the engine has been running over 5 minutes, because of the turbo timer function. If the Turbo Timer function is defaulted as 120 sec. (or 180 sec.), the remote start function can be activated afte

  • Fox FAI-8200, 6 a) Under the disarm mode, open car door, and switch the ignition on-off, on-off, on-off and then stay On. b) Siren will chirp 2 seconds and LED will be on for 2 seconds to confirm entering the programming option mode. c) Within 20 seconds, press button (3) over 3 seconds, all programming options will be back as the factory defaults. d) The siren will sound for 2 seconds to quit the system. Programming Option Table Item Function BTN #1 1 Chirp BTN #2 2 chirp BTN #3 3 chirp 01 Chirp Confirmation On/Off On Off 0

  • Fox FAI-8200, 7 Take the same procedure as above. When this feature is defaulted as enable (Select 120 or 180 seconds), the engine will be still running for 120(180) seconds after turning the ignition off in order to protect the engine life. When default Turbo Timer as 120 or 180 seconds, a. If the engine doesn’t run over 5 minutes, the turbo timer will not function. b. When the engine runs over 5 minutes, pull up the handbrake, then switch the ignition off, the engine will still run for another 120 or 180 seconds (depends on the default) and the system is still disarmed. c. During the period (120/180 seconds) of turbo timer, press bu

  • Fox FAI-8200, 8 Dome Light Delay Steps to default Disable, 15 Seconds or 40 seconds: Take the same procedure as above. The central locking system has the various dome light delay time according to different makers, brands or years of the vehicle. Program the right default depending on the dome light delay time the vehicle has. Or just default the dome light delay disable and connect the instant wire of the vehicle to override the dome light delay time the vehicle has. If the dome light delay programmed as disable, All sensors will be activated 3 seconds after the system is armed. If the dome light delay programmed as 15 seconds, All

  • 9 Anti-Hijacking Delay Time Steps to default Anti-Hijacking Delay Time as 15 or 60 seconds: Take the same procedure as above. The anti-hijacking delay time will be activated only when Anti-Hijacking by Remote or Anti-Hijacking by Door is defaulted as enable. Please refer to the followings. Anti-Hijacking by Remote Steps to default Anti-Hijacking by Remote as enable or disable: T

  • 10 a) When default Start Enable as Arm Mode, the remote engine start function can be activated when the system is armed. b) When default Start Enable as Normal, the remote engine start function can be activated either the system is armed or disarmed. c) After the remote engine start is successful, drivers can use transmitter to arm or disarm the system. After the engine stops running,

Related Products and Documents (Car Alarm):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Philips PR1305C User manual manual philips/pr1305c-YHC.pdf 17 Mar 2024 32
2 Behringer NX3000 Quick start manual behringer/nx3000-IQ7.pdf 01 Sep 2023 44
3 JVC DM65USR Quick start manual jvc/dm65usr-182.pdf 14 Oct 2023 24
4 Xerox XDM2525D-WU - DocuMate 252 Quick install manual xerox/xdm2525d-wu-documate-252-9P5.pdf 17 Dec 2023 2 1.05 Mb
5 Thule 1732 Instructions thule/1732-KG3.pdf 11 Oct 2023 4
6 Sperry instrument DSA-540A Operating instructions sperry-instrument/dsa-540a-JNG.pdf 11 Jul 2022 5

Similar Resources:

  • Code Alarm

    CA-500

    (15 pages)
    Avoid mounting components orrouting wires near hot surfacesAvoid mounting components orrouting wires near moving partsTape or loom wires under hoodfor protection and appearanceUse grommets when routing wiresthrough metal surfacesUse a voltmeter for testing andverifying circuitsPROFESSIONAL INSTALLATION STRONGLY RECOMMENDEDInstallation Precautions:Roll down w …
  • Audiovox

    APS996A - Prestige Remote Security System

    (20 pages)
    128-67721 of 20Model APS-996aOwner’s ManualIMPORTANT ! In order to provide you with the highest level of security to yourvehicle, this system is equipped with selectable manual override circuitry. It ispossible that you will need to override you security system if the transmitterbecomes lost, or inoperative due to battery failure. Reading the sections …
  • Mongoose

    M8

    (20 pages)
    Model number: M8 & M824 VEHICLE ALARM SYSTEM Owner’s Operation/Installation Manual Please read and try out all the features For correct operation and warranty compliance, we recommend professional installation of this product by your authorised Mongoose dealer. M8 Suitable for 12volt, negative ground vehicles M824 Suitable for 24volt, negative gro …
  • Autopage

    RF-1050KE

    (1 pages)
    Models: RF-1050KE / RF-1055KE / RST2050KE / RST2053AL / RF-305 / RF-405 / RF-405A / RF-505 TRANSMITTER PROGRAMMING In the event, you should need to add or replace a Remote Control Transmitter, it is important that you follow the instructions below. Note: Each step must be performed within 10 seconds of the previous step otherwise the system will exit …
  • Fortin

    EVO-ALL

    (10 pages)
    ADDENDUM - SUGGESTED WIRING CONFIGURATION ADDENDA - SCHÉMA DE BRANCHEMENT SUGGÉRÉALLREV.: 20171027FLASH LINK UPDATER 2 FLASH LINK UPDATER 2 1XMicrosoft Windows Computer &Internet connection Ordinateur Microsoft Windows & connection InternetFLASH LINK UPDATER 2 FLASH LINK UPDATER 2 1XMicrosoft Windows Computer &Internet connection Ordinateur …
  • Fortin

    EVO-ALL

    (8 pages)
    * HOOD PINHOOD STATUS : THE HOOD PIN SWITCH MUST BE INSTALLED IF THE VEHICLE CAN BE REMOTE STARTED WITH THE HOOD OPEN. CONTACTDE CAPOTMANDATORY INSTALL | INSTALLATION OBLIGATOIRENotice: the installation of safety elements are mandatory. The hood pin is an essential security element and must be installed. Notice: l'installation des éléments de séc …

Comments, Questions and Opinions: