Epson PS-100 Series Operation & User’s Manual

Text of Epson PS-100 Series User Guide:

• Epson PS-100 Series, 4 Remove the product from the cradle. Press the small tab down and push the PS-100 out from the back. The product is ready for Bluetooth pairing when fully charged and detached from the charging cradle. Start-up operation All LEDs light up in sequence and the PS-100 vibrates. ! Important - Pair with your smart device after purchase. The memory of your device will not be enabled until pairing is completed. - If you remove the PS-100 from your wrist and no movement is detected, it will go int

• Epson PS-100 Series, Viewing data Log onto PULSENSE View for iOS or Android on your smart device. Log onto the PULSENSE View web application. Note: To charge the PS-100, a USB port is required. You can use the USB port on a PC or the optional AC adapter. Use only the specified AC adapter (SFAC04). Introduction • 3

• Epson PS-100 Series, Turn off airplane mode 1 Repeatedly tap the face of the product. The LEDs will light up and display the pattern below to confirm it is still in Airplane Mode. 2 Keep tapping until the LEDs turn off . The product will resume heart rate measurement and wireless communication. Using your PS-100 • 27

• Epson PS-100 Series, Appendix 32 Product Specification .................................................................................................. 32 Device Specifications ............................................................................................. 32 Cradle Specification ............................................................................................... 32 Options specifications ............................................................................................ 32 Troubleshooting 32 Ca

• Epson PS-100 Series, Notes on using the product and components Warning Exercise according to your physical capabilities. Stop exercising and consult your doctor if you feel unwell during exercise. This product is not intended for use to diagnose, prevent, or treat disease or other conditions, and is not a medical device. If you have any concerns, consult your doctor before using this product. Do not keep your eyes on the device while exercising. Pay attention to your surroundings while usin

• Epson PS-100 Series, 3 Set up your PULSENSE View account by following the on-screen instructions. Once you have created your account and completed your profile, follow the on-screen instructions to pair your PS-100 with your smart device. When pairing is successful, the LEDs will light up twice in sequence and the above screen is displayed on the smart device. Set up and basic operation • 18

• Epson PS-100 Series, Heart rate measurement Heart rate detection 1 Heart rate detection starts when the product is moved and the LEDs flash in sequence as shown belo w. Note: Heart rate detection will stop if the product is not worn and has not been moved for three minutes. Heart rate detection will start again when the product is moved. 2 After putting on the product, the blue LEDs flash two times when it detects your heart rate. The product is in pulse measurement mode. Note: - Try to keep your body and arm still to facilitate heart rate detection. - If the device does not detect your heart rate within on

• Contents Introduction 2 Description in the User’s Manual .................................................................................. 2 Trademarks................................................................................................................... 2 Caution: ..............................................................................................

• Epson PS-100 Series, Wearing the PS-100 When wearing the product, make sure it does not touch the ulna bone on your wrist. Note: The Pulsense band needs to be worn snugly around the wrist to collect more accurate heart rate data. This may cause a slight impression on the wrist. Adjust the band for the comfort and performance you choose. 1 Measure the circumference of your wrist closely at the position indicated in the illustration without touching the ulna bone. 2 Check the hole numbers from the length around the arm using table below. The hole number is stamped in the back of band. The PS-100 S/M siz

• Epson PS-100 Series, Pairing issues When using the product for the first time, check the following: 1. Attach the PS-100 to the cradle to wake the PS-100 from battery protection mode. 2. Enable Bluetooth ® communication on your smart device. 3. Check smart device compatibility: epson.com/PSdevices 4. Ensure your smart device is connected to the Internet. 5. Remove any other product from the area that could interfere with the Bluetooth ® communication. If pairing is lost or the PS-100 has been paired with another smart device, check the following: 1. The PS-100 may already be un-paired. Put the PS-10

• System Reset If device operations become unstable, perform a system reset by connecting the product to the cradle. Charging resets the system, and returns the product to normal operation. If this suggestion does not solve your problem, check “Problem Solving” on page 34. Troubleshooting • 35

• Using this device safely Make sure you read the documentation (Quick Start guide and User’s Guide) first before using this product safely. The product may malfunction, or an accident may occur if it is handled incorrectly. - Keep the documentation handy to help you resolve any problems. - When taking this product out of the country of purchase, check the

• Epson PS-100 Series, Caution ・ To avoid the possibility of skin irritation or discomfort from wearing the PS-100, you must keep the skin under the band clean and dry at all times. Do not allow water, sweat, dead skin, or dirt to build up under the band. It is important to keep the band clean and dry at all times by wiping the band with a damp cloth, removing the moisture with a towel, and letting it air dry. Do not use the cradle, USB cable, or AC adapter if they are in any way damaged, faulty or contaminated by foreig

• Epson PS-100 Series, 4 Insert the band fastener into the hole number you checked in step 2. 5 Put your hand through the wristband and fasten the buckle. When wearing the product, make sure it does not touch the bone. Adjust the wristband to a smaller hole number if the wristband is too loose. Bone Sensor Set up and basic operation • 16

• Epson PS-100 Series, What’s in the box Contact your reseller if there are any missing or damaged components. PS-100 Charging Cradle Quick Start Guide Options You can purchase the following optional accessories. AC Adapter （SFAC04） Set up and basic operation • 10

• Epson PS-100 Series, Airplane mode Wireless communication must be turned OFF during a flight. Set the product to Airplane Mode before take- off. When transporting the product it is recommend that you use this mode. 1 Remove the product from your wrist and repeatedly tap the face of the product as shown below. ! Important If you tap the PS-100 continuously as shown above while the device is connected to the charging cradle, the pairing settings will be deleted. The device will not go into airplane mode while measuring heart rate on your wrist; remove the product before tapping as above. 2 When the product is successfully set to Airplane Mo

• Epson PS-100 Series, Low battery notification If the battery level is low, the orange LED will flash every 4 seconds. Once the remaining battery level is down to 1 hour, the orange LED flashes once a second for a duration of 30 seconds and the PS-100 stops measuring heart rate until the product has been charged. Using your PS-100 • 25

• Epson PS-100 Series, Note: Please note that even if not in use, the PS-100 should be charged at least once within a 6 month period. Failing to do so might affect the performance of the rechargeable battery. Notes on using the cradle Warning Do not use the charging cradle, AC adapter, or USB cable if they are damaged, faulty, or contaminated by foreign material such as dust, water, or dirt. Do not use any adapter other than the specified adapter for charging. Warning In areas in which usage is restricted, such as on airplanes and in hospitals, follow the rules and regulations provided (such as in-flight announcements). Do not use th

• Epson PS-100 Series, Troubleshooting This section explains how to solve problems that occur during use. “Caution” on page 33 “Problem Solving” on page 34 “System Reset” on page 35 “Contacting us” on page Error! Bookmark not defined. Troubleshooting • 32

• When the heart rate can’t be detected LED Issue How to solve The device is not being worn correctly onto your wrist. Wear the product closely around your wrist without touching the ulna bone. The device is not being worn correctly on your wrist or the temperature on the surface of your skin is too low. Wear the product closely around your

• Epson PS-100 Series, Getting started Recording your data ! Important To record your data it is necessary to register your device with the PULSENSE View smart device application. Data Calculated Heart rate Reads and records your heart rate from the changes in light reflected through the blood vessels in your wrist. Calories Calculates burned calories based on body motion and heart rate information. When heart rate measurement is disabled, the PS-500 will calculate calories burned based on body motion only. Steps Records the number of steps using the accelerometer. Distance The approximate distance is calculated based on your step count and heig

More Instructions:

	Epson PS-100 Series Quick start manual 30-07-2023 2	DOWNLOAD
	Epson PS-100 Series Operation & user’s manual 27-04-2023 44	DOWNLOAD

Related Products and Documents (Heart Rate Monitor):

Comparable Devices:

Similar Resources:

• Polar Electro F6 (3 pages) F6 Quick Start Guide1Press OKScroll UPScroll DOWNLight ButtonBack ButtonWrist Unit Buttonswww.polarusa.com© 2005 Polar Electro Inc. HO 1885HEART TOUCHIn the exercise mode, you can seethe time of day by bringing the wristunit close to the Polar logo on thetransmitter.Attach one end of the transmitter to theelastic strap.Adjust the transmitter’s strap len …

• Oregon Scientific SE139 (12 pages) 1ENSMART TRAINER - HEART RATE MONITOR MODEL: SE139USER MANUALCONTENTSIntroduction .............................................................. 2 Smart Training Program ....................................... 2 Fitness Index .............................................................. 3 Training Tips .................................................... …

• Sportline Solo 920 (24 pages) 5/2/06SP3638IS01SPORA 12 3 4 5 6 7 8 910 11 121415 16 17 18 19 20 21 22 23© 2006 Sportline Inc. Distributed by Sportline Inc., Hazleton, PA 18202Distributed in UK by StarCase (UK) LtdWorcester, WR4 9FATo learn more, log onto www.sportline.comSP3638IS01SPORASOLO 920 HEART RATE WATCH©2006 Sportline, Inc.#3638#3639®This equipment has been tested and found …

• Suunto VECTOR HR (2 pages) [SELECT]• Enter sub modes• >2 sec. = enter setup• Setup: move• TIME ALTI BARO COMP HRM• Return to main mode[MODE][-BUTTON]• Quick viewof logbook• Setup: Decrease (-)• Scroll logbook &memory information• In TIME mode Date Seconds• Start / Stop• Setup: Increase (+)• Scroll logbook &memory information[+BUTTON]SUUNTO VECTOR …

• Timex SPORTS 1440 (3 pages) FITNESS GUIDE & INSTRUCTION BOOKheart rate monitor517-095000Dieline (does not print)BlackColors used:Part Number: 517-095000Business Group: SportsProgram Name: AdGAP Number: 917Dieline Drawing Number: n/aVendor: HEHDesigner/Location: Lisa Berko/MDFile Name: 517-095000HRMCover.txtFonts used: N/ARelease Date: June 19, 2002Size: x: 3.375” y: 3.5”Note …

• Polar Electro POLAR M51 (30 pages) How the Polar Heart Rate Monitor works .................... 6Parts ........................................................................................ 6Getting going ........................................................................ 7Buttons and their functions .................................................. 8Modes and their functions ......... …

Comments, Questions and Opinions: