Manualios.com

Faroudja NRS-DVI Installation And Operation Manual

Faroudja NRS-DVI Manual Online:

3.7, 1197 votes
Faroudja NRS-DVI User Manual
Faroudja NRS-DVI User Guide
Faroudja NRS-DVI Online Manual

Text of Faroudja NRS-DVI User Guide:

  • Faroudja NRS-DVI, QUICK START INSTRUCTIONS The NRS-DVI requires only a few adjustments to be set for proper operation. However, since the processor must be integrated with a display device, and the settings on one will affect the other, careful attention must be made to the settings on both products. CONNECTIONS Read the complete Owner’s Manual for the NRS-DVI before installation. Review the owner’s manual of the display. Most display devices require specific settings to properly integrate with an external processor. Be sure to connect all sources to the proper inputs of the NRS-DVI. Note on DVDs: For proper aspect ratio and to insure the highest quality image

  • Faroudja NRS-DVI, Quick Start ...............................................................................................................................................a Installation ................................................................................................................................................2 Connections .............................................................................................................................................2 Connecting HDTV Satellite Receivers..............................................

  • Faroudja NRS-DVI, INSTALLATION Unpacking Remove the NRS-DVI unit from the shipping container and examine it for any signs of shipping damage or missing items (check inventory list below). All shipping materials should be saved if the unit is to be moved or returned for service. Shipping unit back to Faroudja for service not in the original box may result in voiding warranty. Placement The processor can be either placed on a table or rack mounted. A rack mounting installation kit is available. Securely mount the side rack brackets with the screws that are provided with the kit. Ventilation The unit uses convection to cool. A fan is not needed. As hot air

  • Faroudja NRS-DVI, INSTALLATION 3 5. D15F connector output for use with computer monitors or to a second display device. Use only short cable runs. This output can be used at the same time as the BNC outputs 6. BNC connectors for main output with RGBHV or YPrPb signals to display devices. Cable runs up to 100ft are okay if good quality cables are used. For YPrPb outputs use: Red = Pr Green = Y Blue = Pb RGBHV is recommended. Note: If Computer signals are to be used, separate H & V sync cables must be connected to the display. 7. 12V trigger to activate automatic screen relays. Voltage is constant when unit power is on. (12V, 3

  • 4 FRONT PANEL CONTROL 1. Firmware Reset: push a small paper clip into this opening to reset the unit’s CPU. Note: Use this reset only if the unit will not respond to commands. It will not erase custom settings. Use the Factory Restore command in the Setup Menu to completely reset firmware. See the setup section of the manual for details. 2. Power/Standby: Press to turn the unit On (LE

  • Faroudja NRS-DVI, SETUP 5 Set: Screen Shape Wide Screen / 4:3 / Wide 4:3 Note: This sets the processor for the screen shape of the display to be used. If this is not set properly, the aspect ratio selection for the different sources located in the user menu will be incorrect. •Wide Screen-Choose this when the screen is Widescreen and the projector will provide the anamorphic vertical squeeze. Example: A 16:9 plasma, a digital or CRT projector set to Anamorphic using a wide angle screen or when using a Panamorph lens, or a 1280x720 digital projector. •4:3

  • Faroudja NRS-DVI, IR REMOTE AND OSD OPERATION The NRS-DVI is shipped with an eight button remote for controlling all Functions available in the unit. The remote control allows for easy operation by simple navigation through the On Screen Display (OSD) menus. Repeated Pressing of a button toggles through the available choices. ON SCREEN DISPLAY (OSD) Accessing the OSD • Press Menu button to bring up main Index. • Use Function Keys until the triangle at the top of the OSD turns yellow. • Press the Select Key to toggle to the

  • The OSD consists of four menu tabs: Input – Picture – Display – Patterns Input Menu Formats Input Select: OSD Video-S-Video- RGB-YCrCb Note: The Pass-Thru input cannot be selected from the OSD since an OSD is not available on that input. Use the Input button on the remote to select it. Input Select: Input Button Video-S-Video- RGB-YCrCb- PassThrough-PassThruTranscoded Aspect Ratio* 4:3-Lett

  • Faroudja NRS-DVI, Contrast Factory 50 Note: It is best to set Brightness and Contrast levels using the controls of the display with the proper test pattern and with the NRS-DVI in the Factory default setting for the initial setup. This means with day-to- day use, when the Factory preset button is pressed, the system is back to the original optimum settings, while changes made for specific sources can be saved in the custom Presets. Color Factory 50 This adjusts the amount of color. The Faroudja processor is calibrated to meet broadcast (SMPTE) color specifications so only minor color adjustments should be needed. Tint Factory 50 Tint is not available with YPrPb so

  • Faroudja NRS-DVI, OPERATING INSTRUCTIONS / RS232 9 Bottom Blanking This adjusts the bottom edge blanking Right Blanking Adjusts the right edge blanking Left Blanking Adjusts the left edge blanking Top Blanking Adjusts the top edge blanking Blanking Level This adjusts the blanking from black to white. This can be used to create a gray side bar for use with 4:3 aspect ratio sources on wideangle screens to help reduce the chance of image burn-in. Image burn in is not covered by Faroudja’s warrantee. Note: The NRS-DVI will store unique blanking and H&V position settings for each aspect ratio which are

  • Faroudja NRS-DVI, 10 RS232 CODES Following the header, a comma is used to delimit the header from the command. All the commands with their descriptions are listed below. All the text strings are terminated with a carriage return (0x13). Maximum command string length is 250 characters. The header and command are not case sensitive . OPERATION COMMANDS (Used for day-to-day operation) COMMAND OPTIONS OR RANGE DESCRIPTION A# (0-2) 0=4x3,1=Letterbox, 2=Anamorphic Input Aspect Ratio – for all sources B# (0-170) 128 default Brightness C# (0-155) 110 default Contrast D# (0-13) 8 default Detail EXT Pass-through Input FST Re

  • 11 RS232 CODES G# (0-2) [0=OFF 1=Bi-Level 2=Tri-Level] SYNC on G/Y HP# (0-50) 25 default Horizontal Position HPOL 0=Neg 1=Pos Horizontal Sync Polarity LB# (0-200) Left Blanking M# (0-2) [0=RGB, 1=YCrCb, 2=YPrPb] Output Mode OSDOFF OSD Off – for processor OSDON OSD On -for processor OUTMOD 0=Analog, 1=Digital Output Mode PY PassThru Transcoded Input PY YCrCb to RGB – activates transcod

  • Faroudja NRS-DVI, 12 INFRARED COMMAND LIST IR Command List Power On/Off 0 4:3 (toggle) (aspect ratio) 1 Letterbox (aspect ratio) Input 2 Anamorphic (aspect ratio) Aspect Ratio 3 Power On Brightness 4 Power Off Contrast 5 Preset 1 Color 6 Preset 2 Tint 7 Preset 3 Detail 8 Preset 4 Noise Reduction 9 Factory Function Up / DVD (input) Return DCS (Up Direction) Function Down / Video (input) (Down Direction) Value up / S-video (input) (Right Direction) Value Down / YCrCb (input) (Left Direction) Preset / Enter RGB (input) Menu Pass-Thru (input) Direct access Infrared commands are available. Contact Faroudja technical support for details.

  • Faroudja NRS-DVI, 13 SPECIFICATIONS Inputs (Interlaced) Format NTSC Only Composite(BNC) 1vpp S-Video (4-pin DIN) 1vpp C -286mvpp Component (BNC) Auto-detect: Y -1vpp(SMPTE) 480i/480p sent to upconverter, Cr -700mvpp 1080i or 720p sent to pass-through. Cb -700mvpp RGB ( BNC) Interlaced Comp. Sync -1vpp RGB -700mvpp HD/PC Pass-Thru D15M DVI Input (for pass-through only to DVI out) DVI-I (female) Digital Only Remote Control “D9F” RS-232 ASCII Remote IR sensor input 5V-12V, 3.5mm, Tip=+ Outputs (Progressive) R,G,B (BNC or DB15) 700mvpp, TTL Sync YPrPb 700mvpp, Sync on Y -1vpp RGsB Gs -1vpp RGB -700mvpp D15F P

  • Faroudja NRS-DVI, LIMITED WARRANTY Faroudja Laboratories, Inc. (“Faroudja”) warranties that its products will be free of defects in workmanship and material and conform substantially to published specifications under normal use and service. This warranty is made to the first purchaser of the products and extends for twelve (12) months from the date of sale. The warranty does not apply to products damaged as a result of accident, misuse, neglect, alteration, improper installation, unusual physical or electrical stress or unauthorized repair. Image burn-in on display devices is not covered under warranty. All warranty claims should be made at the place of

Related Products and Documents (DVD Player):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Maxtor 20302300 Quick start manual maxtor/20302300-AEY.pdf 01 Nov 2022 13
2 Briggs & Stratton Axion 7800376 Initial setup manual briggs-stratton/axion-7800376-L89.pdf 11 Feb 2024 18 1.89 Mb
3 Heath kit DX-35 Assembly Assembly manual heath/kit-dx-35-assembly-EAB.pdf 02 Mar 2023 22 0.88 Mb
4 Asus S46CA-XH51 Specifications asus/s46ca-xh51-KZ3.pdf 11 Feb 2024 2
5 Shindaiwa DGM60MK Owner's manual shindaiwa/dgm60mk-P82.pdf 06 Jul 2023 48
6 Billion BIPAC 6500W Operation & user’s manual billion/bipac-6500w-9Y1.pdf 18 Mar 2023 61 3.39 Mb

Similar Resources:

  • JVC

    KV-DV7

    (4 pages)
    KV-DV7Installation/Connection ManualManual de instalación/conexiónManuel d’installation/raccordementFRANÇAISESPAÑOLENGLISHLVT0591-001A[J]WARNING• DO NOT INSTALL THE UNIT IN A LOCATION WHICHOBSTRUCTS DRIVING, VISIBILITY OR WHICH ISPROHIBITED BY APPLICABLE LAWS AND REGULATIONS.If the unit is installed in a location which obstructs forward visibilityor …
  • Sharp

    DV-SL1000W

    (2 pages)
    DV-SL1000W1No.S4614DVL1000WThis document has been published to be used forafter sales service only.The contents are subject to change without notice.• In the interests of user-safety (Required by safety regula-tions in some countries) the set should be restored to itsoriginal condition and only parts identical to those specifiedbe used. REF.N …
  • Philips

    PET736

    (3 pages)
    PhilipsPortable DVD Player17.8 cm/7" widescreen LCDPET736Movies that travel with youwith 3 hours playback and USB portEnjoy your movies anytime, anyplace! The portable PET736 DVD player featuring 7” TFT LCD display lets you indulge in the pleasure of enjoying DVD movies, MP3-CD/CD music and JPEG photos on the go.Play your movies, music and photos on …
  • RCA

    M4508

    (2 pages)
    Getting Started1. Connect your player to your computer.• The RCA easyRipTM Media Software installer is stored in the player, go to MyComputer in the Start menu,  nd and open the drive letter associated with the player (i.e. LYRA) and then double-click the rcaeasyrip_setup  le to launch the installer.• The player charges automatically every tim …
  • FUNAI

    Magnavox DP170MW8B

    (28 pages)
    PRECAUTIONSSETUPDVD FUNCTIONSINFORMATIONEspañolINSTRUCCIONES ENESPAÑOL INCLUIDAS.If you need additional operating assistance after reading this owner’s manual, please callTOLL FREE : 1-800-605-8610or visit our web site athttp://www.magnavox.com/supportremote control(NA475UD) RCA audio/video cables(WPZ0102TM018 / WPZ0102LTE01) batteries(AAA x 2)owner’s …
  • Dynex

    DX-P7DVD11

    (2 pages)
    Reproductores portátiles de DVD de 7 y 9 pulg.GUÍA DE INSTALACIÓN RÁPIDADX-P7DVD11 y DX-P9DVD11Felicitaciones por la compra de un producto de alta calidad de Dynex. Su DX-P7DVD11 o DX-P9DVD11 representa el más moderno diseño de reproductor de DVD personal y está concebido para brindar un rendimiento conable y sin problemas.Contenido del paquete• …

Comments, Questions and Opinions: