Extech Instruments 2000i Series Operation & User’s Manual

Text of Extech Instruments 2000i Series User Guide:

• Extech Instruments 2000i Series, 2 Section 1 … The Printer User Interface . Introduction This guide summarizes the operation and maintenance features of Extech 2000i dot matrix impact printers. Membrane Switch Functions (see Figure 1) § <ON> The <ON> switch turns printer power on. § <FEED> The <FEED> switch advances the paper at a fast rate. § <OFF> The <OFF> switch turns the printer power off, or pauses and cancels

• Extech Instruments 2000i Series, 3 Front Panel Indicators (continued) § <FAULT> Red l Indicates printer is out of paper. l Indicates error was encountered while reading the magnetic card. l The FAULT and LOW POWER LED on simultaneously, indicate the printer is unable to print due to low battery power. § <READY, FAULT, LOW POWER> Flashing Ÿ Indicates printer is paused. Press FEED to resume printing, or press OFF to cancel the current print and clear any data in print buffer. Ÿ Pressing the OFF switch while printing pauses the printer.

• 4 Section 2 … Charging The Printer Battery . Charging the Battery Cartridge § Insert the battery Cartridge into the printer. l Remove the battery door at the back of the printer, by placing a coin into the slot and pushing the cover to release the lock; (see Figure 2). l Install the battery cartridge in the battery compartment located at the back of the p

• 5 Section 3 … Loading Printer Paper . Impact Printer 2000I - Manually Installing Paper and Ribbon § Open the hinged paper supply door to load paper or replace the printer ink cartridge. § To unlock the top hinged paper cover, hold the printer with both hands and place each thumb on the two locking ribs located

• Extech Instruments 2000i Series, 6 Impact Printer 2000I - Replacing the Inked Ribbon Cartridge (figure 1) § Open the paper supply door to access the ribbon cartridge § Remove the worn out ribbon cartridge by pressing with one finger at the location labeled “EJECT” on the ribbon cartridge. § Insert the new ribbon cartridge in place and press at the extreme ends to secure it in place. § Tighten the ribbon by rotating the ribbed wheel clockwise on the ribbon cartridge. § Feed paper to insure that the paper passes through exposed r

• Extech Instruments 2000i Series, 7 Section 4 … Auto Paper Load Operation f Auto Paper Load … 2000i Printers (Option 1) § Open the hinged paper door by pushing up the two locking ribs (figure 4). § If the printer is not already on, turn it on by pressing the ON switch. § Remove any paper remaining in the printer mechanism, using the FEED switch. § Unroll a leader from the new roll (about 3 inches); do not place roll in the printer at this time. § Trim the leading edge of the roll to a wedge shape. § Place t

• Extech Instruments 2000i Series, 8 Section 5 … Serial RS232, IrDA and XMODEM Communications Select a serial RS232 or IrDA communication interface (see Figure1) • The S2000i printers support Serial RS232 and IrDA compatible infrared communication interfaces. • These interfaces are selected using DIP switches located on the printer control card, located on the side of the paper supply. • Refer to Table 2 for Dipswitch settings. • Dipswitch #8 in the ON position selects IrDA interface. In the OFF position, serial RS232 mode is selected. l If RS232 interface is selected, connect the data connector and set the serial

• Extech Instruments 2000i Series, 9 RS232 Communication Interface - General notes & DIP switch settings § Eight-position dipswitch, located to one side of the paper roll, is used to select and set the serial RS232 interface. The printer reads these switches once, on initial power-up. The functions assigned to each switch are listed in Table 2. § Proper Baud Rate and protocol settings are required to communicate with a host computer. The standard factory setting is 19,200 BAUD, 8 DATA BITS, NO PARITY BIT, and one STOP BIT, all switches in off position. The Extech Extended XMODEM protocol The Extech XMODEM software option is designed to overcome the unreliability of data transmission us

• Extech Instruments 2000i Series, 10 Section 6 … Printer Control Codes and Resident Fonts Character Hex/Dec CONTROL ACTION EOT 04/04 End Of Text BS 08/08 Back Space HT 09/09 Horizontal Tab LF 0A/10 Line Feed VT 0B/11 Vertical Tab FF 0C/12 Form Feed CR 0D/13 Carriage Return SO 0E/14 Shift Out – Select double wide print SI 0F/15 Shift In – Clear double wide print XON 11/17 Transmitter On. AUXON 12/18 Printer on. XOFF 13/19 Printer receiver is off NORM 14/20 Return to

• Extech Instruments 2000i Series, 11 Troubleshooting Guide PROBLEM POSSIBLE CAUSE SOLUTION Printer will not turn on Discharged Battery Recharge battery overnight. Charge LED not lighting when AC adapter is plugged in. No AC power or AC adapter defective Check AC outlet or adapter (note: battery pack may be fully charged) Battery not charging. Battery incorrectly installed or no AC. Battery dead Check battery installation and AC adapter Change to a new battery Paper not feeding. Obstruction in paper path or paper improperly installed Check the paper path. Verify installation Use paper of the correct specification F

• Extech Instruments 2000i Series, 12 TABLE A - Optional printer parts and supplies Part Number Description 757059 2000i paper pack (2.2” / 57.5 mm wide, 1.5” O.D. 5 rolls) 7A100005 2000i Battery Cartridge - 5 Cells – 1400mA 767700 External 4 bays charger for 2000i 767600 Single Bay Fast Charger 157120 Battery charger adapter 2000i 120VAC/9VDC/1A 157220 Battery charger adapter 2000i 220VAC/ 9VDC/1A S2000i-UG.doc User’s Guide – 2000I 7A060028 Programmer’s Guide – 2000i Available from Extech Email

• Extech Instruments 2000i Series, 13 Regulatory Notes FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur

Related Products and Documents (Printer):

Comparable Devices:

Similar Resources:

• HP LASERJET P2055d (4 pages) HP LASERJET P2050 PRINTER SERIES P2055d • P2055dn Reduce your environmental impact and still get the print speeds and ease of use you require. • Use less energy with intelligent features like Instant-on Technology. • Conserve resources by reducing paper use and recycling empty cartridges. • Make a difference by using simple tools to optimize …

• Canon PIXMA MX522 (4 pages) 1XXXXXXXX © CANON INC. 201356134212721321seriesRetire las hojas protectoras y la cinta.Compruebe que se le han suministrado los siguientes elementos.No conecte aún el cable USB o Ethernet.Conecte el cable de alimentación.55Pulse el botón ACTIVADO (ON).66Abra la cubierta delantera, la bandeja de salida del papel y la cubierta de documentos.11Retire la cin …

• Brother PT-1760 (71 pages) User’s GuideGuía de UsuarioPT-1760HPT007• Read this User’s Guide before you start using your labeler.• Keep this User’s Guide in a handy place for future reference. • Antes de usar su equipo por primera vez, lea cuidadosamente esta Guía de Usuario.• Guarde esta Guía de Usuario para futuras referencias. …

• FujiFilm ApeosPort C7070 (9 pages) Prepared by Customer Training Team © FUJIFILM Business Innovation Hong Kong Limited Quick Reference Notes - Daily Care 簡易操作 - 日常保養 ApeosPort ® C7070 / C6570 / C5570 / C4570 / C3570 / C3070 …

• Dell 3330dn - Laser Printer B/W (4 pages) DELL 3330dn LASER PRINTERThe Dell™ 3330dn laser printer brings a new level of high-performance monochrome printing within reach of any company, from small businesses to large enterprises. It oers exceptional resolution, intuitive operation, and very low print costs, enabling everyone in the workgroup to benefit from aordable, quality …

• Lexmark E360DN - Hv Taa/gov Compliant (8 pages) Lexmark™ E360Quick ReferenceLoading paperLoading the standard 250-sheettrayThe printer has two trays to select from: the standard tray (Tray 1),also known as the 250-sheet tray, and either the optional250-sheet tray or the optional 550-sheet tray (Tray 2). Only oneoptional drawer (which includes an optional tray) may be attachedto the printer at one time.N …

Comments, Questions and Opinions: