Manualios.com

ClearWater CWC-9 Installation Manual

ClearWater CWC-9 Manual Online:

3.25, 2196 votes
ClearWater CWC-9 User Manual
ClearWater CWC-9 User Guide
ClearWater CWC-9 Online Manual

Text of ClearWater CWC-9 User Guide:

  • ClearWater CWC-9, Page 2 Step 1: Parts and Overview Congratulations on your purchase of the ultimate car audio upgrade available for the Mazda Miata/MX5! Below are some of the features associated with this speaker component set: • This system was specifically designed for the Miata/MX5. • Hundreds of hours have gone into the testing and design of this audio system. • Measurements were made with the industry’s top equipment. • No other speakers in the world have been so meticulously designed specifically for one vehicle

  • ClearWater CWC-9, Page 3 Step 2: Factory Speaker Removal • With the door handle held in the “open-the- door” position, gently insert a small flat head screwdriver behind the blank plastic insert and apply enough prying force to loosen. • With the door handle still in the “open-the-door” position, insert the small flat head screwdriver into the front of the now loosened blank plastic insert and pry it out. • Using a #2 Phillips head screwdriver, unscrew the screw from behind the blank plastic insert that you just removed. • Gently insert your small flat head screwdr

  • ClearWater CWC-9, Page 4 Step 2: Factory Speaker Removal • Remove the screw at the top of the grab handle with your #2 Phillips head screwdriver. • Locate the screw inside the doors cup holder and remove with your #2 Phillips head screwdriver. • Using your hands, start at the bottom of the door panel and pull outward to release the snaps from the back side of the panel. These snaps will make a “pop” sound as they release one by one. Once all 8 snaps have been released, the door panel can be lifted and pulled away from th

  • ClearWater CWC-9, Page 5 Step 2: Factory Speaker Removal • Press the door handle from the back to “pop” it off of the door panel. Twist the door handle assembly so it can pass through the hole in the door panel. • Remove the connector from the door lock wires on the back side of the door panel. Remove the connector from the factory tweeter. (these connec- tors can be tricky as they require the insertion of your small sized flat head screwdriver into their “release” tabs as you are pulling them out) CWC9 Factory Tweeter CWC9B Factory Tweeter

  • Page 6 • Unplug the remaining factory wire connectors from the back of the door panel. (one connector is removed in the same manner as the tweeter connector, the other has a thumb tab to release) • Place the door panel on a flat smooth surface (to prevent scratches) with the back side of the panel facing upwards. • Remove the two screws hol

  • ClearWater CWC-9, Page 7 Step 3: Clearwater Speaker Installation • There is a “groove” around the top and bot- tom of the oval opening that the factory put in place for us to easily be able to install the round CWC-9 speakers. Using the corner of your small flat head screwdriver, score the plastic along this groove until you have carved into the plastic about half way through. Be patient here, this will take about 5-8 minutes per door and will result in plastic shavings falling away as you go. The deeper you make the grooves, the easier the next steps will be. • Using your pliers, grab the corners

  • ClearWater CWC-9, Page 8 Step 3: Clearwater Speaker Installation Custom Sound Module: • Inside the door cavity there is a side impact protection bar. Using the provided large zip tie secure the “Custom Sound Module” to the bar using the following directions: a) Feed the zip tie through one of the holes on the sound module. b) Insert the sound module into the door cavity through the speaker opening. c) With the wires pointing toward the front of the car, wrap the zip tie around the protection bar and back through the second hole of the sound module. (this will not compromise any protection). After the module is secured against the bar, cut off the excess tie

  • ClearWater CWC-9, Page 9 Step 3: Clearwater Speaker Installation F G f) Place the tweeter wire in the “groove” with the factory input wire and hold in place with a small zip tie. Cut off the end of the zip tie. g) The factory tweeter wire will not be used. Wrap the factory tweeter wire around itself and hold in place with a small zip tie. (the tweeter wire will make a rattling sound if it is left loose) Cut off the end of the zip tie. Door Speaker: • Plug the wires coming from the sound module labeled “woofer” into the rear of the Clearwater door speaker. The red wire connects to the “red” terminal, the black wire c

  • ClearWater CWC-9, Page 10 Step 3: Clearwater Speaker Installation • Insert one of the supplied screws through the frame and the top hole of the water shield. • Insert the door speaker and water-shield into the door and loosely secure the top screw into place. Make sure that the wires do not get pinched between the woofer and door. • Using the screwdriver and the three remaining supplied screws, gradually tighten each screw making sure the speaker goes in straight. Be careful not to slip with the screwdriver, this could seriously damage the door speaker. Custom Tweeter: • Place the cu

  • Page 11 Re-Installation: • Make sure to re- connect the wiring for the power door locks and electric window controls. • The door panel can now be re-installed in the reverse order that it was removed. • Make sure that all of the snaps are pushed into place. (Don’t forget the one in the middle of the door, shown above on the right) • Make sure to r

  • ClearWater CWC-9, Thank you for purchasing your Clearwater Speakers. Please feel free to send us comments or suggestions at any time. We love to hear from our customers. If you have the time we would love to see some pictures of you and your car. Send your photos to us at [email protected] or mail them to us at P.O. Box 428, Folsom, CA, 95630. Sincerely, Glenn and the team at Clearwater. The Clearwater Company | 2546 Mercantile Dr. Ste B | Rancho Cordova, CA 95742 Phone: (916) 852-7029 | Fax: (916) 852-9410 | www.clearwateraudio.com Version 6.0 | 7/20/12

Related Products and Documents (Car Stereo System):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 ProForm J81I Operation & user’s manual proform/j81i-P9G.pdf 01 Feb 2024 26
2 Peavey Impulse Impulse 200P Operation & user’s manual peavey/impulse-impulse-200p-O99.pdf 16 Oct 2023 20 3.58 Mb
3 Datalogic PowerScan PM8300 Brochure & specs datalogic/powerscan-pm8300-MWA.pdf 30 May 2023 2 0.42 Mb
4 Enable-IT 350 Operation & user’s manual enable-it/350-28P.pdf 19 Nov 2022 12
5 Sound Acoustics PRO-DESK-C Owner's manual sound-acoustics/pro-desk-c-NY3.pdf 05 Aug 2022 3
6 Sharp LC-C46700UN Operation manual sharp/lc-c46700un-9RE.pdf 24 Jan 2023 32 1.66 Mb

Similar Resources:

  • Kicker

    PWRA415

    (10 pages)
    ©2015 Stillwater Designs PWRA415-A1-20150224Page 1 of 10 PWRA415Designed for 2015 and newer Jeep® Wrangler four door with base audio T-TAP x210MM BOLTFUSE WIRETIES x6SUBWOOFER ASSEMBLY 200 WATT AMP/BRACKET POWER HARNESS OVERLAY HARNESS …
  • Philips

    CEM250

    (17 pages)
    Register your product and get support atCEM250_55CEM250/55© 2008 Koninklijke Philips Electronics N.V.All rights reserved.Document order number: EN User manual 3 …
  • Panasonic

    CF-P2

    (7 pages)
    Operating Instructionsfor Car MounterHandheld Computer®ContentsIntroduction ................................................... 2Installation ..................................................... 3Operating Instructions .................................. 6Model No. CF-P2 SeriesPlease read this instructions manual carefully before using this product and save …
  • JVC

    KS-FX470

    (37 pages)
    INSTRUCTIONSMANUAL DE INSTRUCCIONESMANUEL D’INSTRUCTIONSGET0015-001A[J]For customer Use:Enter below the Model No. andSerial No. which are located onthe top or bottom of the cabinet.Retain this information for futurereference.Model No.Serial No.For installation and connections, refer to the separate manual.Para la instalación y las conexiones, refiérase a …
  • JVC

    KD-AR770

    (46 pages)
    ENGLISHESPAÑOLFRANÇAISCD RECEIVER KD-AR770/KD-G720RECEPTOR CON CD KD-AR770/KD-G720RECEPTEUR CD KD-AR770/KD-G720 For canceling the display demonstration, see page 8. Para cancelar la demostración en pantalla, consulte la página 8. Pour annuler la démonstration des affichages, référez-vous à la page 8.For installation and connections, refer to th …
  • Blaupunkt

    Madrid 210

    (180 pages)
    Bedienungs- und Einbauanleitung Operating and installation instructionsMode d’emploi et de montageInstrucciones de manejo e instalaciónInstruções de serviço e de montagemMadrid 210 7 649 068 510 / 7 649 069 510San Francisco 310 7 649 073 510 / 7 649 074 510Toronto 410 BT 7 640 000 510 / 7 640 001 510www.blaupunkt.comRadio | CD | USB | MP3 | WMAwww.b …

Comments, Questions and Opinions: