Manualios.com

Crypto F200 Operation & User’s Manual

Crypto F200 Manual Online:

3, 2863 votes
Crypto F200 User Manual
Crypto F200 User Guide
Crypto F200 Online Manual

Text of Crypto F200 User Guide:

  • Crypto F200, CONTENTS 1. Introduction 4 2. Specifications 4 2.1 ADSL Standards supported 4 2.2 Supported Protocols 4 2.3 Connections 5 3. Hardware Installation Procedures 5 3.1 Hardware Requirements 5 3.2 Preparing your network information 5 3.3 Configure the ISP parameters for your Windows XP 6 3.4 Driver Installation on Windows XP 7 3.5 Software Configuration 8 3.6 Connection to the Internet 11 4. Troubleshooting 13

  • 1. Introduction F200 ADSL USB modem is a high performance and high-speed device that provides a full rate ADSL modem with the superb reliability and is a complete solution for home and office. The F200 ADSL USB modem can have a maxi- mum downstream data rate of up to 8Mbps and an upstream of up to 1Mbps. You can safely enjoy the new generation broadband Internet with the F200 A

  • Crypto F200, 2.3 Connections USB – Connects the USB cable from the USB port of the F200 modem to the USB port of the computer. LINE – Connects the RJ11 telephone cable from the telephone line port of F200 modem to the telephone plug.. LED indications: POWER: After successfully installing the modem, the POWER LED light turns on. It will stay on every time you start your computer. 3. Hardware Installation Procedures 3.1 Hardware Requirements The following hardware is necessary to configure and use the F200: ñRJ-11 (ADSL Ready) telephone Line ñUSB cable (Included in the p

  • Crypto F200, Table 3 WAN (PPPoE/PPPoA parameters) Information Value PVC Settings VPI VCI Encapsulation (LLC ‹ VCMux) Login Username Information Password Line Modulation Automatic ITU G.dmt or G.lite preferred Automatic ANSI T1.413 i2 preferred ITU (G.dmt or G.lite) G.dmt G.lite table 4 LAN (Bridged/Routed/IPoA parameters) Information Value PVC Settings VPI VCI Encapsulation (LLC or VC Mux) IP Information IP Address Subnet Mask Gateway IP Address Preferred DNS address Alternate DNS address (If available) Line Modulation Automatic ITU G.dmt or G.lite preferred Automatic ANSI T1.413 i2 preferred ITU (G.dmt or G.lite) G.dmt G.

  • Crypto F200, 3.4 Driver Installation on Windows XP Step 1: Windows will detect the newly installed device and the screen below will appear after the F200 USB ADSL Modem is attached to the systems USB port. Select "Install from a specific Location", and click "NEXT". Step 2: Select "Include this location in the search" and type d:\driver\Wan (where D:\ the CD-ROM) Note: If the protocol being used is Bridged, Routed or IpoA, then type d:\driver\Lan Step 3: Click Continue Anyway. This window appea

  • Crypto F200, Step 4: Click "Finish" Step 5: Left click on 'My Computer' icon and click on 'Properties_ > _Device Manager' Double click on Network adapters and check to see for: 'Crypto F200 USB ADSL WAN adapter' 3.5 Software Configuration Continue the setup process of the F200. Step 1: Double click on the ‘Access Runner’ icon Step 2: Initially there is no connection / synchronization with the ADSL line ‘Attempting to Activate Line’. Press ‘ALT – P’ on your keyboard 8

  • Step 3: Here you can see that the connection has not been established. ‘Attempting to Activate Line’. Click the ‘Line Setup’ tab Step 4: Initially it is set to Annex B (ADSL over ISDN) as shown on the bottom right. Note: If the line was ISDN, then we do not change it. Step 5: Select Annex A (ADSL over POTS) (given that the line was PSTN). Click Apply. Note: Incase

  • Crypto F200, Step 7: For the example insert: VPI = 8 VCI = 35 Click Apply. Step 8: For Encapsulation Mode select the connection protocol: PPP over ATM VCMUX (RFC2364) Click Apply Click on the General tab Step 9: Under Line Status, the indication ADSL Connection Established, indicates that the connection / synchronization with the ADSL line has been done with success. Note: 1 to 2 minutes are required after you make the above configurations, in order for the F200 to be synchronized with the ADSL line. Step 10: To see information regarding t

  • Crypto F200, Double click on the Access Runner icon ADSL Connection Established indicates that the connection / synchronization with the ADSL line has been done with success. Note: After power on the PC, it takes 1 to 2 minutes in order for the F200 to be synchronized with the ADSL line. 3.6 Connection to the Internet Step 1: To connect to the Internet, double click on the Connect Access Runner DSL icon which is found on the Desktop Step 2: Insert the "User Login & Password" that has been given to you by your ISP, click Dial to connect. Step 3: Double click on the connection icon on the Windows toolbar. 11

  • Crypto F200, Step 4: To ensure that the F200 has been successfully installed, under the General tab, check to see that Connected is indicated next to Status. You can also check your connection speed: Speed -> 448.0kbps. Step 5: Under the Details tab, you can see various information regarding the connection. (i.e. Server Type, Server IP address etc.). 12

  • Crypto F200, 4. Troubleshooting The POWER LED is not on ñCheck to see that the connections between the USB port of the F200 and the USB port of your computer are plugged in correctly. Cannot access ISP ñIf in PPPoA & PPPoE mode, check your login account and password for the remote server. ñCheck your VPI/VCI value and encapsulation mode are the same as your ISP gave you. ñTry to dial the phone to check if the phone line to CO is good if telephone service is available. Note: Incase you take out the USB plug from your computer and plug it back to the USB port of t

  • Crypto F200, Declaration of Conformity The 'F200 ADSL USB MODEM' is approved for use for within the European Union, and the compatibility of this unit and it’s basic requirements are declared with the CE symbol. Passage extract of the authentic declaration of conformity: CE Verification of Compliance Technical Standards: EMC: ETSI EN 300 386 v1.3.2/2002.12 LVD: EC LOW VOLTAGE DIRECTIVE 73/23/EEC, 93/68/EEC Measurement standards: (1) EN 55022 : 1998 (2) EN 61000-3-2: 2000 (3) EN 61000-3-3: 1995 (4) EN 61000-4-2: 1998 (5) EN 61000-4-3: 1998 (6) EN 61

Related Products and Documents (Modem):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 Asus P2-M2A690G - P Series - 0 MB RAM Installation manual asus/p2-m2a690g-p-series-0-mb-ram-67C.pdf 26 Feb 2023 8 1.7 Mb
2 Fuji Xerox DocuCentre-III 3007 Quick user manual fuji-xerox/docucentre-iii-3007-Y8I.pdf 01 Nov 2022 44
3 innovair Oasis WOE36C2DB1 Troubleshooting manual innovair/oasis-woe36c2db1-18J.pdf 28 Aug 2023 5
4 Nordyne M3RL Series Maintenance and service manual nordyne/m3rl-series-R2A.pdf 11 Sep 2022 8
5 Peavey XXL 212Combo Operation manual peavey/xxl-212combo-XV4.pdf 08 Aug 2022 36 2.82 Mb
6 HIKVISION DS-72xx Series Operation & user’s manual hikvision/ds-72xx-series-KQQ.pdf 12 Aug 2022 73 3.16 Mb

Similar Resources:

  • NETGEAR

    DGN2200v1

    (2 pages)
    Ressourcen-CDInternetADSLTelefonLeitungN300 Wireless ADSL2+ ModemrouterDGN2200B InstallationsanleitungLieferumfang:NetzteilTelefonkabel1234NetzwerkkabelLaptop oder Desktop-ComputerModemrouterEin-/Ausschalternach LandunterschiedlichN300 Wireless ADSL2+ ModemrouterDGN2200Ressourcen-CDTipp: Verwenden Sie einenADSL-Filter, -Splitter oder-Filter/-Splitter für je …
  • Multitech

    MultiConnect MicroCell MTCM-LAT3

    (2 pages)
    MultiConnect®MicroCell Cellular Modem(MTCM-LAT3 and MTCM-LSP3 )MTCM-LAT3 and MTCM-LSP3 Quick StartMultiConnect®MicroCell Cellular Modem (MTCM-LAT3 and MTCM-LSP3 ) MultiTech Systems MultiConnect®MicroCell Cellular Modem (MTCM-LAT3 and MTCM-LSP3 ) MultiTech SystemsQuick Start Quick StartMounting Device1. Locate the groove on the bottom of the cellular modem …
  • NETGEAR

    DGND3700v2

    (22 pages)
    NETGEAR, Inc.350 East Plumeria DriveSan José, CA 95134, EE. UU.Marzo de 2012Servicio técnicoGracias por elegir un producto NETGEAR.Una vez instalado el dispositivo, busque el número de serie en la etiqueta del producto y regístrelo en NETGEAR.com/register. De lo contrario, no podrá hacer uso de nuestro servicio telefónico de asistencia. Le recomendamos …
  • C-motech

    CMU-300

    (15 pages)
    DBDM(CDMA&WI-MAX) USB MODEM User Manual Model Name: CMU-300 (CDE-680 CDMA module + CME-325 Wimax module) C-motech Co., Ltd. Proprietary and ConfidentialThis document is the sole and exclusive property of C-motech. Not to be distributed or divulged without prior written agreement. 8,9F Yongsan Bldg. 14-14 Yoido-Dong, Youngdungpo- …
  • Digicom

    BlueGATE

    (27 pages)
    http://www.digicom.itAccess Point Bluetooth Access Point senza fili Bluetooth V.92/V.90 Ideale per collegare i PC con Bluetooth ad Internet via modem Modem analogico 56K V.92/V.90 Integrato Compatibile Bluetooth 1.1 Bluetooth Wireless Access Point V.92/V.90 Ideal to connect Bluetooth PCs to the Internet via modem Built-in 56K V.92/V.90 …
  • Telenetics

    MIU/PowerPort Series 14.4

    (31 pages)
    Installation, Operation & Diagnostics for the MIU/PowerPort Series / 2.4 / 9.6 / 14.4 / 28.8 Industrial Grade Dial Modems Book 1 of 2 (See Book 2 for AT Commands) Document No. 49-0002-002 …

Comments, Questions and Opinions: