bar aid 400 Installation And Operation Instruction Manual

Text of bar aid 400 User Guide:

• bar aid 400, 21618-A-01-09 3 DE GB F NL CONTENT Page 1 IMPORTANT NOTES ...................................................................... 4 2 INSTALLATION ............................................................................. 5 2.1 Location ........................................................................................ 5 2.2 Electrical connection ....................................................................... 5 2.3 Water connection ........................................................................... 5 2.4 Drain connection ..........

• bar aid 400, 4 21618-A-01-09 DE GB F NL 1 IMPORTANT NOTES Use in Accordance with Regulations This machine is exclusively to be used to wash glasses. Do not use for electrically heated cooking and heat conservation appliances. Safety Never hose down the machine. The "Attention" symbol is shown beside instructions that are essential for the safe operation of the machine. Please read these passages thoroughly. Liability Installations and repairs which are carried out by non authorized technicians or the use of other than original spare parts, and any technica

• bar aid 400, 21618-A-01-09 5 DE GB F NL 2.1 LOCATION Wall clearence is not required. Level machine by turning the feet. Distribute machine weight equally onto all feet. Vapour may escape from the glasswasher door. Therefore adjacent furniture has to be protected to prevent swelling. 2.2 ELECTRICAL CONNECTION Must be carried out by an authorized technician according to the local and national codes. The electrical supply shall comply with the name-plate data. Adaptation to an alternative electrical supply is achievable as per wiring diagram. Line fuses a

• bar aid 400, 6 21618-A-01-09 DE GB F NL ➀ Machine ON / OFF Pushing this button switches the machine on. In case of operating error or faults, it is possible to switch-off the machine immediately without the drain cycle, by pushing this button again. After switch off, the machine is not voltage free! ➁ Start button By pushing this button the wash cycle will be started. Furthermore the button illuminates to indicate the mode of the machine: GREEN GREEN (flashing) (permanent) = Machine fills and starts heating Wash cycle is running Machine draining / switch-

• 21618-A-01-09 7 DE GB F NL 4.1 DETERGENT / RINSE AID Use only commercial detergent and rinse aid. Please pay attention to the manufacturers safety instructions. Before changing to a different product type (even from the same supplier), the suction hoses must be rinsed thoroughly with fresh water (procedure as described under 4.4). Otherwise, the mixing of different

• bar aid 400, 8 21618-A-01-09 DE GB F NL START-UP Push Start button ➁ . At the temperature indicator Wash ➄ appears "- - 1". Wait until the indicator displays "- - 0". Close the door. The machine switches off and is now ready for operation. 4.4 PRIMING THE SUCTION HOSES ATTENTION: The machine has to be switched off. Open the door. Push Program button ➃ and Drain button ➂ simultaneously until the upper Display ➄ shows "boF". Push Program button repeatedly, until "H02" is displayed. Close the door. In the upper Display appears "SF1", in the lower one "0".

• bar aid 400, 21618-A-01-09 9 DE GB F NL 5.1 PREPARATION Check correct position of wash arms and strainers. You should be able to turn the wash arms easily by hand. If not, clean the wash arms as described in chapter 8.3 Open shut-off valve. Switch on main switch or put the plug in. Check level of detergent and rinse aid containers. Close door and push the ON button ➀ , tank will be filled. The Start button flashes green during fill and heating cycle. This process can take several minutes. When the but

• bar aid 400, 10 21618-A-01-09 DE GB F NL SELECT PROGRAM: The machine is operating automatically with standard cycle time. If needed, it is possible to select the shorter program. To show the present program, push the Program button ➃ before starting the wash cycle. To change the program, push the Program button again. P01 = Short cycle (for light / medium soiled glasses) P02 = Standard cycle (for medium / heavy soiled glasses) The machine continues with the chosen cycle time until it is switched off or another program is chosen. – OPERATION Press and hold (3 seconds) the Program button ➃ until the actual temperatures (°C) are displayed (top = rinse, bottom

• 21618-A-01-09 11 DE GB F NL 8.1 SWITCH-OFF Close the door. Push and hold Drain-button ➂ for 2 seconds. NOTE : During the drain cycle, the interior of the machine is cleaned automatically. A final inspection is recommended to remove any food debris. Machines with built-in Softener: If the drain cycle has been started while regeneration is running, cycle time is extendin

• bar aid 400, 12 21618-A-01-09 DE GB F NL ATTENTION: The machine has to be switched off. Open the door. Push Program button ➃ and Drain button ➂ simultaneously until the upper display ➅ shows "boF". If no button is pressed for 10 seconds, the indicator automatically switches off and the new settings will be saved. 9.1 ADJUSTMENT OF DETERGENT DOSAGE QUANTITY Push Program button ➃ again. In the upper Display ➅ appears"CH1". In the lower Display ➄ appears e.g.: "09" = pre-adjusted value of the detergent dosage time = 9 seconds ≈ 2.5 g/l. To adjust the detergent dosage time, push Start button ➁ repeatedly, un

• bar aid 400, 21618-A-01-09 13 DE GB F NL In case of frost or longer operation pauses (e.g. for seasonal operations) the machine must be completely drained. This should be carried out by after sales service. RESET FOR OPERATION: Open the door. Push Program button ➃ and Drain button ➂ simultaneously until the upper display ➅ shows "boF". Push Start button ➁ (at the lower display ➄ appears "- - 1") and hold until water come out of the booster overflow. Close the door. The machine switches off and is now ready for operation. – – – – For trouble free operation we recommend you enter into a service contract with your local Service Of�

• bar aid 400, 14 21618-A-01-09 DE GB F NL 13 TROUBLESHOOTING GUIDE TYPE OF FAILURE POSSIBLE CAUSE REMEDY Poor wash result Glasses are not clean. Wash arms stiff (you should be able to turn them easily by hand). Take out wash arms and clean them thoroughly. Check water outlet from machine to wash arms is clear. Wash nozzles are clogged (visual check). Take out wash arms and rinse thoroughly until soil is removed. Replace correctly. Rinse nozzles are clogged (possibly by lime deposit) Take out wash arms and decalcify them in separate container. Detergent concentration is too low or too high. Ch

• bar aid 400, 21618-A-01-09 15 DE GB F NL If no button will be pressed during 6 hours, the machine switches off automatically without draining. Follow the description below during the next switch on: – Push the ON/OFF button ➀ . – Push the Drain button ➂ and wait, until the machine is drained and switched off. Restart the machine as described at chapter 5. TROUBLESHOOTING GUIDE TYPE OF FAILURE POSSIBLE CAUSE REMEDY Poor wash result Stripes and staines on glasses. Rinse aid concentration too high. Reduce quantity (see instructions). Hard water or high mineral content. Ch

Related Products and Documents (Dishwasher):

Comparable Devices:

Similar Resources:

• GE PDW8400 Series (20 pages) PDW8100 SeriesPDW8200 SeriesPDW8400 SeriesPDW8500 SeriesPDW8600 SeriesPDW8700 SeriesPDW8800 SeriesPDW9200 SeriesPDW9700 SeriesPDW9800 SeriesOwner’s ManualDishwashers165D4700P273 49-5948 06-03 JRSafety Instructions . . . . . . . . . . . 2, 3Operating InstructionsCare and Cleaning . . . . . . . . . 13, 14Control Panel and Settings . . . . 4–6Flashing …

• Frigidaire FDB2830CES1 (2 pages) Trouble Shooting TipsExploded View of Wash SystemTub and Door SealThe door seal is pressed into the tub channel foran interference fit. Center the gasket (marked onback) at the tub top center and press in placeProduct SpecificationsElectricalRating ...................................120 Volts, 60HzSeparate Circuit..15 amp min.- 20 amp max.Motor (Amps) ...... …

• GE EDW4000 Series (16 pages) GEAppliances.comI_2)W4000 S_iesGSD6200 S_iesGSD6300 S_iesGSD6500 S_iesGSD6600 S_iesGSD6700 S_iesGSD6800 S_iesGSD6900 S_iesSafety Instructions ....... 2, 3Operating InstructionsCare and Cleaning ......... 10Control Panel and Settings.. 4-6Loading Place Settings ....... 9Loading the Racks .......... 8Optional Accessories ......... 9Using the Dishw_her ...... 6 …

• KitchenAid W10205937A (20 pages) Thank you for Choosing KitchenAid® Appliances. We hold our company to the highest quality standards and it is important to us that you have a positive experience owning a KitchenAid® product. For your convenience, we have provided an easy to follow User Instruction Book. These instructions include a “Troubleshooting” section to help you through any pro …

• GE GSD3400 series (32 pages) GE AppliancesGE Answer Center®800.626.2000DishwashersPart No. 165D4700P205 Pub. No. 49-5879 2-00 JRGSD3400 seriesGSD3600 seriesGSD3700 seriesGSD3900 seriesOwner’s Manual …

• KitchenAid KUDK03CTBL0 (14 pages) DOOR AND PANEL PARTS1For Models: KUDK03CTBL0, KUDK03CTWH0, KUDK03CTSS0(Black) (White) (Stainless)08−08 Litho in U.S.A. (els) (eeb)Part No. W10128997 Rev. BUNDERCOUNTERDISHWASHERIllus. PartNo. No. DESCRIPTION1 Literature PartsW10078153Instructions,InstallationW10111124Energy Guide8574093 Guide, Use & CareW100778 …

Comments, Questions and Opinions: