Aerotech Barracuda Assembly And Operation Instructions Manual
|
1 Assembly and Operation InstructionsAssembly and Operation Instructions BEFORE YOU BEGIN: • Study the illustrations and sequence of assembly. The sequence of assembly is important. Review the parts list and become familiar with all parts before assembly. If any parts are missing or damaged, contact RCS at 1-435-865- 7100 or email at [email protected]. • DO NOT MO
Aerotech Barracuda, 2 NOTE: FROM THIS POINT ON, DO NOT USE ANY CEMENT UNTIL REACHING ASSEMBLY STEP 5. 1. With their motor hook channels aligned with the motor hook, slide a FIN-LOK™ ring and then an AERO-FI- BRE™ centering ring over the front end of the motor tube. Push on the centering ring until the back edge of the FIN-LOK™ ring is moved to the forward most mark made in Step 3 above. (NOTE: The rings are designed to be a tight fit on the motor tube. If the rings are difficult to slide onto the mot
Aerotech Barracuda, 3 FIN-LOK™ ASSEMBLY (CONT.) LABYRINTH™ ASSEMBLY Fin Locks Front End Cement Beads Front Centering Ring Screw Eye Shock Cord Permanent Cooling Mesh (Stretch Out - 6") Ejection Gas Baffle Shoulder Baffle Flange Motor Tube 1/4"/6mm Cuts DO NOT ALLOW CEMENT TO GET IN THE FIN LOCKS DO NOT CEMENT COOLING MESH INTO MOTOR TUBE 1. Make four 1/4" (6mm) long cuts, 90 degrees apart, in the front end of the motor tube. 2. Stretch out the cooling mesh to about 6" (15cm) in length. I
Aerotech Barracuda, 4 BODY AND FIN ASSEMBLY 4. Cement the bulkhead to the end of the coupler tube. 5. Make a pencil mark 2" (51mm) from an end of the coupler tube. Lightly sand the surface of the tube between the mark and the bulkhead. Use a small dowel to apply a bead of cement around the inside of the upper body tube about 1" (25mm) from the end of the tube. Then slide the coupler tube into the upper body tube up to the pencil mark on the coupler tube. 6. Cement the nose cone into the forward end of the upp
Aerotech Barracuda, 5 FINAL ASSEMBLY AND FINISHING 1. Slide the other centering ring over the back of the motor tube and motor hook and push it against the back FIN- LOK™ ring. Apply a bead of cement where the centering ring meets the body tube. 2. Carefully cut out the self adhesive decals and apply them to the rocket body and fins. See "Decal Instructions" for helpful hints. Use the picture on page 1 as a guide to proper positioning. 3. Fasten the fabric parachute to the shock cord at a point about one (1) foot away from the payload bay in
Aerotech Barracuda, 6 OPERATION INSTRUCTIONS 1. RECOMMENDED MOTORS: Only use AEROTECH composite model rocket motors when flying your AEROTECH rocket. See enclosed chart for recommended motors and projected altitudes. 2. RECOVERY SYSTEM PREPARATION: Roll the parachute and shroud lines, starting from the canopy peak, into a loose cylinder that will easily slide into the lower body assembly body tube. Pack the long portion of the shock cord into the body tube first. Next, insert the parachute. Finally, insert the short length of shock cord into the body tube on
Aerotech ASTROBEE D Toy Assembly and operation instructions manual
ASTROBEE D |
Black Horse Model BIRD DOG Toy Instruction manual book
BIRD DOG |
Blade 350 QX3 Toy Instruction manual
350 QX3 |
LAheli maxir 2008 Toy Operation & user’s manual
maxir 2008 |
GAUI Hurricane 255 Toy Assembly instructions manual
Hurricane 255 |
LEGO 4181 Pirates of the Caribbean Toy Assembly manual
4181 Pirates of the Caribbean |
Aerotech G-Force Toy Assembly and operation instructions manual
G-Force |
Sebart Avanti S XXL Toy Instruction manual
Avanti S XXL |
# | Manufacturer | Model | Document Type | File | Updated | Pages | Size |
---|---|---|---|---|---|---|---|
1 | Asus | M2N68-AM SE2 - Motherboard - Micro ATX | Operation & user’s manual | asus/m2n68-am-se2-motherboard-micro-atx-5YW.pdf | 01 Jul 2022 | 40 | 1.78 Mb |
2 | Insignia | NS-C2116 | Operation & user’s manual | insignia/ns-c2116-FZB.pdf | 02 Apr 2023 | 68 | |
3 | Cisco | 3G Omnidirectional Outdoor Antenna - 3G Omnidirectional Outdoor Antenna | Operation & user’s manual | cisco/3g-omnidirectional-outdoor-antenna-3g-omnidirectional-outdoor-antenna-M41.pdf | 13 Aug 2023 | 26 | 3.04 Mb |
4 | Meyer Sound | AMIE | Quick start manual | meyer-sound/amie-LD7.pdf | 09 Feb 2024 | 2 | |
5 | Planar | PS5580 | Operation & user’s manual | planar/ps5580-ZS2.pdf | 07 May 2023 | 39 | |
6 | Zanussi | ZWH 5145 | Operation & user’s manual | zanussi/zwh-5145-M17.pdf | 21 Jul 2022 | 24 | 2.72 Mb |
Eduard
1/423 02323 023ORIGINAL KIT PARTSPŮVODNÍ DÍLY STAVEBNICEPHOTO-ETCHED PARTSLEPTANÉ DÍLYPARTS TO BE REMOVEDDÍLY K ODSTRANĚNÍFILLTMELITeduardREMOVEODSTRANITOPTIONVOLBA?REPLACENAHRADITBENDOHNOUTGRINDOBROUSITSYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁŽDRILL HOLEVRTAT OTVORAPPLY EXPRESS MASK AND PAINT BEFORE GLUINGPOUŽÍT EXPRESS MASK NABARVIT PRED SLEPENÍM1C …
Typhoon Mk.Ib Car Door landing flaps(4 pages) |
LGB
23701NNÖÖLLBB--DDaammppffllookk UU11DAS VORBILDDie Baureihe U ist eine derbekanntesten österreichischenDampflokomotiven. Ab 1889 wur-den 70 dieser zuverlässigen C1'-Lokomotiven von der Lokomoti-vfabrik Krauss & Co. gebaut.Dank ihrer niedrigen Achslast undihrer angemessenen Höchstgeschwindigkeit von 35 bis 45 km/hließ sich die Baureihe U fast …
23701(13 pages) |
AeroWorks
1 30cc LC-126ARF-QB (Quick Build) ASSEMBLY MANUAL AEROWORKS 4903 Nome Street, Denver, CO. 80239 - Phone 303-371-4222 - Fax 303-371-4320 E-mail - [email protected]
…
LC-126ARF-QB(103 pages) |
Eduard
1/3Pz.IV J Mesh Schürzen35 59535 5951/35 scale detail set for Tamiya kit 35 181 • sada detailù pro model 1/35 Tamiya 35 181ORIGINAL KIT PARTSPÙVODNÍ DÍLY STAVEBNICEPHOTO-ETCHED PARTSLEPTANÉ DÍLYPARTS TO BE REMOVEDDÍLY K ODSTRANÌNÍFILLTMELITeduardREMOVEODSTRANITOPTIONVOLBAREPLACENAHRADITBENDOHNOUTGRINDOBROUSITSYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁ� …
Pz.IV J Mesh Schürzen(3 pages) |
Phoenix Model
Instruction ManualGPversionEPversionGP/EP Size .46-.55 Scale 1:8 ARFSPECIFICATION - Wingspan: 1900mm (74.8 in) - Length: 1182mm (46.5 in)- Flying weight: 3.4-3.6 kg- Wing area: 43.8dm2- Wing loading: 79g/dm2- Covering type: Genuine ORACOVER®- Gear type: Plate Aluminum hi-grade(included)- Spinner size: Plastic SCALE 75mm (included)- Radio: 4 channel minimum …
westland lysander(48 pages) |
Meccano
182108+InstructionsÚtmutatóPokynyInstrucţiuniNotice de montageInstrucciones de construcciónBauanleitungBouwinstructieInstrukcjaIstruzioniInstruçõesИнструкцииDUMP TRUCKCAMION BENNE
…
18210(16 pages) |
Ariens Lawn Mower Pro Zoom 54Ariens Pro Zoom 54 Guide (Manual ), @8631I6 Pro Zoom 54, 50 |
LENCO MP3 Player MES-224MES-224 (MP3 Player ePDF User Manual, #8FY7RY) MES-224, 1 |
Electrolux Refrigerator ERE 39350 W#8U7RC3 ERE 39350 W: Electrolux Refrigerator Owner Documentation ERE 39350 W, 60 |
Life Fitness Home Gym G3-GLPA-001Home Gym Parts manual (Life Fitness G3-GLPA-001) G3-GLPA-001, 7 |
A.O. Smith Boiler HW 300 THRU HW 610#7J3PJV: HW 300 THRU HW 610 Boiler Specification sheet HW 300 THRU HW 610, 2 |
Patterson Bathroom Aid Sonaris 2Patterson Sonaris 2 User Manual (Operation & user’s manual), @9L86W8 Sonaris 2, 9 |
Huawei Modem Mobile Broadband USB StickHuawei Mobile Broadband USB Stick Guide (Operation & user’s manual), @M1BDY2 Mobile Broadband USB Stick, 2 |
Zanussi Electrolux Refrigerator ZX97/5ZX97/5 Instruction booklet - 7LSW96 ZX97/5, 16 |
Yard-Man Blower YM320BVYard-Man Blower Operator's manual (File: yard-man-ym320bv-blower-72, 26/11/2023) YM320BV, 72 |
Zeuz Audio Subwoofer 200.480#EBCQUE 200.480: Zeuz Audio Subwoofer Owner Documentation 200.480, 7 |
Nortel Software Remote Gateway 50Nortel Software Remote Gateway 50 Update manual Remote Gateway 50, 45 |
JVC Car Speakers CS-HX536UJVC CS-HX536U Guide (Doc Type: Car Speakers Instructions) CS-HX536U, 2 |