Manualios.com

Aaeon AGD-310D Operation & User’s Manual

Aaeon AGD-310D Manual Online:

3.5, 523 votes
Aaeon AGD-310D User Manual
Aaeon AGD-310D User Guide
Aaeon AGD-310D Online Manual

Text of Aaeon AGD-310D User Guide:

  • Aaeon AGD-310D, LCD Display AGD-310D iv Safety & Warranty 1. Read these safety instructions carefully. 2. Keep this user's manual for later reference. 3. Disconnect this equipment from any AC outlet before cleaning. Do not use liquid or spray detergents for cleaning. Use a damp cloth. 4. For pluggable equipment, the power outlet must be installed near the equipment and must be easily accessible. 5. Keep this equipment away from humidity. 6. Put this equipment on a reliable surface during installation. Dropping it or letting it fall could cause damage. 7. The openings

  • LCD Display AGD-310D For Linux Fedora 14 kernel 2.6.35.6-45.fc14 OS please execute: CD -ROM: \\TouchScreen-DRV\eGalax Touch \Linux\eGalaxTouch 32 1. Open System Input Command (su) and System Password 2. Input command ( Xorg : l –configure) Chapter 4 Touch Screen Driver Installation 4-16

  • Aaeon AGD-310D, LCD Display AGD-310D Chapter 1 General Information 1-4 1.3 General Specification  Type Color TFT  Size 10.4" TFT LCD  Construction IP-65 Aluminum Die Cast Front Bezel  Mounting Panel/ VESA/ Wallmount  Input signal VGA, DVI  Control OSD (On Screen Display) on the rear panel  Power Supply External power adapter  Dimension AGD-310D 12.17” (W) x 8.5”(H) x 1.93”(D) (309mm x 216mm x 49mm) Cutout Size 9.09”(W) x 7.8”(H) (231mm x 198mm)  Gross Weight 8.58 lb (3.9 Kg)  Net Weight 5.06

  • Aaeon AGD-310D, LCD Display AGD-310D Chapter 2 Hardware Installation 2-6 2.5 DVI Port Connector Connecting a standard DVI-D connector through I/O port of this unit. This connector supports digital signals only Pin Signal Pin Signal 1 N.C. 2 TMDS Data 2+ 3 TMDS Data 2/4 shield 4 TMDS Data 4- 5 TMDS Data 4+ 6 DDC clock 7 DDC data 8 N.C. 9 TMDS Data 1- 10 TMDS Data 1 11 TMDS Data 1/3 shield 12 TMDS Data 3- 13 TMDS Data 3+ 14 +5V 15 Ground 16 Hot plug detect 17 TMDS data 0- 18 TMDS data 0+ 19 TMDS data 0/5 shield 20 TMDS data 5- 21 TMDS data 5+ 22 TMDS clock shield 23 TMDS clo

  • LCD Display AGD-310D 7. Select the “ 3 ” USB inte rface. (Select the USB interface and press “Enter” key of the keyboard to start the installation) 8. Select the “1” COM interface (Select the COM interface and press the “Enter” key of the keyboard to start the installation) Chapter 4 Driver Installation 4-19

  • Aaeon AGD-310D, LCD Display AGD-310D 3.7 RGB Color- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Increase the gauge value of the selected option Decrease the gauge value of the selected option Chapter 3 On Screen Display Control 3-8

  • Aaeon AGD-310D, LCD Display AGD-310D 3.10 Mode Resolution- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Increase the gauge value of the selected option Decrease the gauge value of the selected option Chapter 3 AMI BIOS Setup 3-11

  • Aaeon AGD-310D, LCD Display AGD-310D 3.2 OSD Main Menu: Push The MENU Keys Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Increase the gauge value of the selected option Decrease the gauge value of the selected option Chapter 3 AMI BIOS Setup 3-3

  • Aaeon AGD-310D, LCD Display AGD-310D Chapter 2 Hardware Installation 2-4 2.3 Connecting to the Computer Turn off the computer and the LCD Display before connecting.  Use the Monitor-to-PC VGA、DVI cable to connect the LCD Display to your computer. The cable heads are the same on either side.  Fasten the connectors securely.

  • Aaeon AGD-310D, LCD Display AGD-310D Chapter 2 Hardware Installation 2-9 2.8 Panel Mounting This LCD Display can be placed on a shelf or table, or mounted onto the wall. To mount it onto the wall, you need the mounting brackets, which you will find them in the accessory box. Follow the steps described below: *10 Wa ll Sponge f or Bezel Pannel Mount Panel mount

  • Aaeon AGD-310D, LCD Display AGD-310D 4.1 Introduction The optional AGD-310D Series touch screen uses 5-wire resistive technology to provide more accurate sensing capacity than other technologies. The touch screen is specially designed for tough industrial environments, and has been approved by FCC Class A standards. Note: For A1 version, if you connect the RS-232 and USB touch screen interfaces to the system simultaneously, the USB mode will be the priority. For A2 version, the connection will be switched by software. Resistive Type Supply Voltage and Current • +5 Vdc, nominal (+4.90 Vdc to +5.10Vdc) Self powered only. • 50 mA standby, typical at +5 Vdc; during

  • Aaeon AGD-310D, LCD Display AGD-310D iii Packing List The LCD monitor comes with the following standard parts shown as below. Check and make sure they are included and in good condition. If anything is missing or damaged, contact the dealer immediately.  1 AGD-310D  1 Utility CD-ROM Contains User’s Manual (in PDF format), Drivers and Utilities  1 VGA Cable  1 USB Cable  1 RS-232 Cable  1 DC Adapter If any of these items are missing or damaged, you should contact your distributor or sales representative immediately.

  • Aaeon AGD-310D, LCD Display AGD-310D Serial Interface • EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex. • Hardware handshaking: RTS/CTS. • DSR is pulled HIGH (>+3V) by the touch screen control board when connected and powered. DTR can be asserted by the host to interrupt the flow of data from the controller. Note that if the application does not monitor CTS, then an interval of approximately 5 seconds should be inserted between the issuance of a reset command and any other command. Communication Parameters • Baud Rate 9600 bps • 8 Data bits, 1 stop bit, no parity only. Int

  • Aaeon AGD-310D, LCD Display AGD-310D Chapter 2 Hardware Installation 2-5 2.4 VGA Port Connector This DB-15 connector can be connected to the system via the external 15-pin DB-15 connector through the I/O from this unit. Pin Signal Pin Signal 1 Red 2 Green 3 Blue 4 N.C. 5 GND 6 GND 7 GND 8 GND 9 N.C. 10 GND 11 N.C. 12 SDA 13 HSYNC 14 VSYNC 15 SCL

  • Aaeon AGD-310D, LCD Display AGD-310D AGD-310D 10.4” SVGA Rugged Touch Display On Screen Display Control IP-65 Front Bezel 5-wire Resistive Touch Screen AGD-310D Manual 1 st Ed August 2011

  • LCD Display AGD-310D Chapter 2 Hardware Installation 2-10 2.9 VESA Wall Mounting Mounting the LCD Display with UL Listed Wallmount Bracket only. The LCD Display can be mounted on a monitor arm or wallmount plate. Caution: When mounting the LCD Display, take care to tighten the retention screws or bolts until fully secured, but do not over tighten. Over

Related Products and Documents (Monitor):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 VIA Technologies ARTiGO-A1150 Manual  via-technologies/artigo-a1150-3LL.pdf 17 May 2023 2
2 Aiphone 83873900 0602 E Installation manual aiphone/83873900-0602-e-ZG8.pdf 15 Sep 2022 32 1.33 Mb
3 Toshiba E-STUDIO5506AC Hardware troubleshooting manual toshiba/e-studio5506ac-51O.pdf 21 Sep 2022 80
4 Philips SBCSC468/00 Operation & user’s manual philips/sbcsc468-00-1PP.pdf 19 May 2023 173 2.6 Mb
5 Sanyo SCP-8400 Operation & user’s manual sanyo/scp-8400-U8J.pdf 27 Mar 2023 64
6 Central Pneumatic 67696 Set up and operating instructions manual central-pneumatic/67696-JUQ.pdf 02 Aug 2022 22

Similar Resources:

  • ACU-RITE

    06021RM

    (12 pages)
    Archived Products Instruction Manual Display for 3-in-1 Weather Sensormodel 06021RM AU TO DIMTIM E ZON E AUTO DST O N O FF wind chill heat ind ex dw ew point hil auto MPH KPH manual Learning... high indoor humidity! low i n door h umidity ! hh ii g hh h igh low h igh low hh ii g hh low OCT low 12-24 hour forecast barometer current WIND average p …
  • Sharp

    LL-S242A-W

    (4 pages)
    LL-S242A-WLL-P202VLCD MONITORTOUCH PANEL DRIVERfor Windows VistaOPERATION MANUALVersion 1.2Important Information• Thissoftwarehasbeenshippedafterstrictqualitycontrolandproductinspection.If,however,youndanyfailureormalfunction,contactyourproductdealer.• Pleaseunderstand …
  • Crystal Image Technologies

    RMP-161-F17

    (20 pages)
    UM-CV-751-RP-F17-Q113V1 www.rackmountsales.com751User Manual dedicated KVM switch and rackmount screen technology6U Rackmount Display PanelRMP-161-F1717” FHD 1080p LCDOptions : - SDI / MCS- DC power- Touchscreen- MIL-type or lockable connector …
  • HP

    Z27i

    (12 pages)
    EL-MF877-00 Template Revision B Page 1 PSG instructions for this template are available at EL-MF877-01 Product End-of-Life Disassembly Instructions Product Category: Monitors Marketing Name / Model [List multiple models if applicable.] HP Z27i 27-inch IPS Display Purpose: The document is intended for use by end-of-life recyclers or treatment facil …
  • BURG-WACHTER

    SANTEC SLM-17HCV

    (28 pages)
    Version 1.1sfi/0715/dt-engl/A5 BEDIENUNGSANLEITUNG / USER MANUAL Deutsch / English LCD Monitor Modelle / Models: SLM-17HCV SLM-21HCV SLM-17HCV SLM-21HCV …
  • ibis

    A500

    (16 pages)
    IBISIBISA500 MINI MONITOR音箱使用说明书/OWNER’S MANUAL质保卡/ WARRANTY DOCUMENT购买登记卡/ REGISTRATION CARD英文版/GB Page1 - 6中文版/CHN 第 7-11 页 …

Comments, Questions and Opinions: