Manualios.com

Fujitsu Eternus DX200F Setup Manual

Fujitsu Eternus DX200F Manual Online:

4.85, 2783 votes
Fujitsu Eternus DX200F User Manual
Fujitsu Eternus DX200F User Guide
Fujitsu Eternus DX200F Online Manual

Text of Fujitsu Eternus DX200F User Guide:

  • Fujitsu Eternus DX200F, Setup Guide Setup Guide FUJITSU Storage ETERNUS DX200F All Flash Array P3AM-8482-01ENZ0 An installation space and network environment must be prepared in advance. Prepare the following manuals: ● Manuals for the ETERNUS DX200F All Flash Array ● Related manuals, such as manuals for the server or the networking equipment that is used Installation Space Site Planning Guide Network Environment • Configuration Guide (Basic) • Configuration Guide (Web GUI) Preparation STEP Installation space Check that the installation area meets the space r

  • Fujitsu Eternus DX200F, 2 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 The rack rail needs to be attached to the rack and the ETERNUS DX (controller enclosure) needs to be installed. Installation in a Rack STEP Configuration Guide (Basic) The center of gravity must be taken into consideration to prevent a rack from toppling over. The controller enclosure should generally be installed from bottom to top to lower the center of gravity and to ensure the safe use of racks. IMPORTANT 2. Install and fasten the controller enclosure in the rack. Make sure to install or remove the controller enclosure to or fr

  • Fujitsu Eternus DX200F, 3 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 Various cables need to be connected to the rear of the ETERNUS DX. Rear viewCable ● MNT port A port that is used to connect to an operation management LAN. Before connecting to the operation management LAN, change the IP address of the MNT port in the Setup Network Environment settings. ● RMT port A port that is used for initial setup or to connect to the remote support center. Cable Connection STEP ● To help with cable management and prevent incorrect connection, attach labels to the cables and make a note of connection

  • 4 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX. Connect a PC terminal to the ETERNUS DX. Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the ETERNUS DX directly with the LAN cable. Turn on the PC terminal and the ETERNUS DX. PC

  • Fujitsu Eternus DX200F, 5 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 Perform the settings that are required before operation of the ETERNUS DX on the Initial Setup screen. Perform the following settings according to the wizard screen: ● Set Storage System Name ● Change User Password ● Set Thin Provisioning ● Setup Network Environment In the Setup Network Environment settings, set the IP address of the MNT port to connect the ETERNUS DX to the operation management LAN. After the settings are complete, close the Web browser. Initial Setup

  • 6 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 Use ETERNUS Web GUI to set RAID configurations in the ETERNUS DX. Perform the following settings: ● RAID group creation ● Volume creation ● Hot spare registration 1. RAID group creation Create RAID groups to create volumes. To display the screen to create RAID g

  • Fujitsu Eternus DX200F, 7 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 The host affinity settings ensure security when multiple servers are connected by assigning the host interface ports that the hosts (servers) can access and the volumes that the hosts (servers) can recognize. Follow the procedure below to set host affinity by associating a host group, a CA port group and a LUN group. 1. Host group addition Add the information on the hosts (servers) that access the ETERNUS DX. To display the screen to

  • Fujitsu Eternus DX200F, 8 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 5. Host affinity creation Create an association between a host group and a port group and an association between a host group and a LUN group. To display the screen to create a host affinity: Click [Create Host Affinity] in [Action] on the [Connectivity] tab. Perform the ETERNUS DX monitoring setup if required. ● Notification of the ETERNUS DX problems as they occur is possible if the event notification method and level have been set. ● If remote support is required,

  • Fujitsu Eternus DX200F, 9 FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide Copyright 2014 FUJITSU LIMITED P3AM-8482-01ENZ0 • The content of this manual is subject to change without notice. • This manual was prepared with the utmost attention to detail. However, Fujitsu shall assume no responsibility for any operational problems as the result of errors, omissions, or the use of information in this manual. • Fujitsu assumes no liability for damages to third party copyrights or other rights arising from the use of any information in this manual. • The content of this manual may not be repro

Related Products and Documents (Disk array system):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 EVGA GeForce 8400 GS Specification evga/geforce-8400-gs-Y3A.pdf 12 Jul 2022 1 1.03 Mb
2 Yamaha MFC2 Owner's manual yamaha/mfc2-UW7.pdf 23 Sep 2023 16 0.8 Mb
3 WAGNER W400SE Operating instructions manual wagner/w400se-546.pdf 08 May 2023 34 3.76 Mb
4 Craftsman HORSEPOWER 580.75231 Owner's manual craftsman/horsepower-580-75231-2F2.pdf 25 Jan 2023 48 12.62 Mb
5 Image Fitness 510home Trainer Manual  image-fitness/510home-trainer-E69.pdf 09 Nov 2022 11
6 Canon AS 6 Instructions manual canon/as-6-J2D.pdf 14 Dec 2023 48 1.9 Mb

Similar Resources:

  • IBM

    FlashSystem 900

    (24 pages)
    FlashSystem 900 Product Guide 1򔻐򗗠򙳰 ®FlashSystem 900 Product GuideIBM Redbooks Product GuideToday's global organizations depend upon the ability to unlock business insights from massive volumes of data. Now, with IBM FlashSystem 900, they can make faster decisions based on real-time insights and unleash the power of the most demanding applicati …
  • Dell

    PowerVault MD3600f

    (94 pages)
    Dell PowerVaultMD3600f and MD3620fStorage ArraysGetting StartedWith Your SystemGuide de mise en routeHandbuch zum Einstieg mit dem SystemIntroducción al sistema …
  • NetApp

    FC4600

    (230 pages)
    NetApp™ HardwareHardware Cabling GuideNetApp, Inc.495 East Java DriveSunnyvale, CA 94089 U.S.A.Telephone: +1 (408) 822-6000Fax: +1 (408) 822-4501Support telephone: +1 (888) 4-NETAPPDocument comments: [email protected]Information Web: http://www.netapp.comPart number: 52904-00, Rev. AApril 2012 …
  • D-Link

    DSN-1100-10 - xStack Storage Area Network Array Hard Drive

    (5 pages)
    b u s i n e s sDSN-1100-10 iSCSI SAN ArrayxStack Storage® 4x1GbE iSCSI SAN Array with 5 SATA BaysIntroductionD-Link’s DSN-1100-10 iSCSI SAN array is an entry-level network storage solution in a compact, desktop form factor, ideal for small businesses. The heart of the DSN-1100-10 is a powerful 10Gbit iSCSI System-on-a-Chip (SoC) capable of handling over 8 …
  • D-Link

    DSN-5000-10

    (3 pages)
    Page 1 E X P A N S I O N A R R A Y DSN-5000-10 Expansion Array – 5/2010 Copyright © 2010 D-Link, Inc. - All Rights Reserved DSN-5000-10 Expansion Array Quick Start Guide The DSN-5000-10 Expansion Array Quick Start Guide provides the information needed to connect additional DSN-5000-10 hot-pluggable expansion arrays to your primary arr …
  • Ciprico

    Media Vault U210-R

    (147 pages)
    Release Date: 01/08 Media Vault™ U320-R, U320-RXUser Manual …

Comments, Questions and Opinions: