Manualios.com

Hubsan X4 DESIRE Instruction Manual

Hubsan X4 DESIRE Manual Online:

4.4, 545 votes
Hubsan X4 DESIRE User Manual
Hubsan X4 DESIRE User Guide
Hubsan X4 DESIRE Online Manual

Text of Hubsan X4 DESIRE User Guide:

  • Hubsan X4 DESIRE, I INTRODUCTION Thank you for buying HUBSAN products. The quadcopter is designed as an easy to use, full featured RC model capable of hovering, fast forward, and aerobatic flight maneuvers. Please read the manual carefully and follow all instructions in this. Be sure to retain the manual for future reference, routine maintenance, and tuning. 1.1 lmportont Notes This RC quadcopter is not a toy, it utilizes various high-techs to provide superior performance. Please read this manual carefully before operating this product. Any improper use of this product will result in serious injury. Be aware of your personal safety, safety of

  • Hubsan X4 DESIRE, SAFETY ADVISORY NOTICE I Lithium-Polymer (LiPo) Batteries ] LiPo batteries are differ from conventional batteries in that their chemical contents are encased in a relatively insubstantial foil packaging. This has the advantage of significantly reducing their weight, but does make them more susceptible to damage if roughly or inappropriately handled. As with all batteries, there is a risk of fire or explosion if safety practices are ignored: gl Charge and store LiPo batteries in a location where a battery fire or explosion (including smoke hazard) will not endanger Iife or property. M Keep LiPo batteries away from children an

  • Hubsan X4 DESIRE, 4 TRANSMITTER 4,1 ldentification and functions of the Main Menu Main Menu (MODE 2) 6 Throttle Trim (1 ) Throttle /Aileron stick 7 Power SW 3 Aileron Trim 4 Elevator Trim 2 Elevator/Aileron stick 7 Power 5W 3 Aileron Trim lnput Key Function Rudder Trim display + Battery voltage Elevator trim Expen modes Rudderilim Batteryvoltaqe dlsplay - Throttle trim Expefr modes Data display Elevator trim Aileron trim (MODE 1) TRANSMITTER B Antenna 4 Elevator Trim (2) Elevator/Rudder Stick 5 Rudder Trim 8 Antenna LCD 6 Throttle Trim 1 Throttle/Rudder Stick 5 Rudder Trim Data display s/N ldentification F

  • 4.2 Battery Mounting Notice: >Do not mix old and new batteries >Do not mix different types of batteries >Do not charge non-rechargeable battery. Take out the cover lnstall 4 x AAA battery according to the correct polarities 5 LI-PO BATTERY CHARGING 5.1 The quadcopter equipped with a 3,7V 240mAh Lipo battery 5.1.1 Take out the batt

  • Hubsan X4 DESIRE, 6.i.3 Apply power on the X4 by connecting the battery plug with correct polarity. Please disconnect the X4 battery plug after turning off the TX when you stop flying. 6.'l .4 lnsert the battery to the bottom of your X4. Make sure the battery and wires are pushed into the end of the battery compartment, so they will not negatively affect the center of gravity(COG) and cause unstable flight. Please twist the wires and squeeze them into the notched holder as the picture shows, to prevent inflight shaking or oscillations. 6.1.5 About LED lights: After a "beep",

  • Hubsan X4 DESIRE, LEFT movement Aileron (Cyclic Roll) moves your quadcopter'sideways' Left/Right RIGHT movemenl CAUTION: Controls will oppeor reversed when the model is flying towards you I 7.2 Normal and Expert Flight Modes The X4 is factory set for Normal Mode flying, and it will always power up in Normal Mode. While fast and responsive in Normal Model, the X4 has even greater performance capability when Expert Model is activated. Activate Expert Mode by pressing the Elevator stick (the model and transmitter must both be on). Two "beep", expert mode; one "beep", normal mode. The LCD will display EXPERT and t

  • Hubsan X4 DESIRE, (c)Aileron Sensivity Adjustment You can also set up the sensitivity in Expert mode. Use the same method above. (-'------'--- '------l irm fq1'o* i iL5ffl LE--BP-qr-:i i I I I I 3 dots displayed in Normal(Sensivity reach 20-600/o) i I -l I i-l 5 dots displayed in Expert(Sensivity reach 60-1000/o) Press the Elevator stick to switch between Normal and Expert mode at any time. 7.5.1 Leftsideflip Push the joystick to the right side and then quickly push the joystick to the left and then release the stick to the center position after the flip. 7.5.2 Right sideflip Push the joystick to the full left side and then quickly p

  • Hubsan X4 DESIRE, 7.5.3 Forwordflip Pull the joystick to the back and then quickly push the joystick to the front and release the stick to the center after the flip. MODE 2 7.6.4 Backwardflip Push the joystick to the front and then quickly pull the joystick to the back and release the stick to the center after the flip. 8 PROPELLER INSTALLATION AND REMOVAL The X4's props are not identical. Each prop is labeled with an A or B. When installing replacement props, be certain to install them as shown. The X4 will not fly, and will f

  • Hubsan X4 DESIRE, Removing Props.'Hold the prop, insert the U wrench under the prop, press down and the prol will easily come off the motor shaft. The propellors are dangerous when the quadcopter is flying. To avoid injury or damage, please consider installing the protection cover. Instructions: Remove the props. Position the cover's four holes with the motors. Press each of them on the motors, then re-install the props in their correct positions on the X4 . When removing the protection cover, please remove the props first as in the above steps,

  • Hubsan X4 DESIRE, l.Transmitter and X4 will not bind. Answer: Throttle position needs to be fully minimized. Please do not move the transmitter sticks or trims during initial power-on binding. 2. Transmitter LED light on and then suddenly off. Answer: Replace new AAA batteries 3. LCD transmitter not showing the setting interface after hold down the joystick for 1 second. Answer: The throttle stick is not in the lowest position. 4. Gyro not working well Answer: (1) Battery voltage too low. (2) Re-bind (3) Land on to the ground with the throttle fully min

  • 12. One or more motors stop working Answer: (1) Motor is damaged. Replace the motor. (2) The motor connections(s) are disconnected. Resolder. (3) An FET on the flight controller looks burned. Replace the flight controller. 13. The X4 is still drifting excessively when hovering even after a good accelerometer calibration, Answer: Set it on a level surface and shim the

Related Products and Documents (Quadcopters):

Comparable Devices:

# Manufacturer Model Document Type File Updated Pages Size
1 gfm V7PFDVD20 Owner's manual funai/v7pfdvd20-515.pdf 17 Dec 2022 44 5.43 Mb
2 ADS Technologies RDX-155-EF Operation & user’s manual ads-technologies/rdx-155-ef-2XC.pdf 05 Apr 2023 4 0.36 Mb
3 SPT SPARCIN 9 User manual manual spt/sparcin-9-2FH.pdf 02 Sep 2023 32
4 AMX AXB-DMX512 DMX512 INTERFACE Specifications amx/axb-dmx512-dmx512-interface-5Y2.pdf 29 Dec 2022 2 2.03 Mb
5 Ninja AF100 Series Owner's manual ninja/af100-series-45Y.pdf 21 Sep 2023 9
6 Lifescan ONETOUCH SURESTEP (WITH DATA PORT) Owner's booklet lifescan/onetouch-surestep-with-data-port-D24.pdf 04 Feb 2023 88

Similar Resources:

  • Intel

    FALCON 8+

    (8 pages)
    PAYLOAD & COMPASS CALIBRATIONThe payload calibration and the compass calibration must be performed once with each payload. If the status display shows the message “No calib on payload found!”, you must perform the payload calibration rst. If the status display shows the message “No c.calib. matching pID, using default.”, you must perform t …
  • SYMA

    Giros SYM0X3

    (36 pages)
    Drone Quadcopter R/C MANUAL DE UTILIZAÇÃO CARACTERÍSTICASDrone 4 Canais R/C Quad CopterSuper resistente, versátil, garantia de qualidade Syma / Giros®.Função 4 CH: cima e baixo, esquerda e direita, frente e trás, deslocação diagonalFunção Especial Drone rotação 360º incluídaInclui função de luzes: flash lights em vooTempo de Carga: +/- …
  • Holystone

    HS100

    (35 pages)
    INSTRUCTIONS FOR [email protected] (America)[email protected] (Canada)[email protected] (Europe)[email protected] (Japan)16age+1(855) 888-6699Navigator …
  • Lynx

    SPIDER 73

    (6 pages)
    SPECIFICATIONS:Weight: Frame: 8.8g, total weight with FPV Camera mount: 10gMaterials: Plastic.Size: 73mm.Maximum propeller: 40 mm.Motor mount: 7x20 mm.Flight controller mount: 29mm x 29mm.SPIDER 73 FPV RACER - USER MANUALREV. 01-Date:02/16/20171/6HELI INNOVATIONS …
  • devention

    Scout X4

    (16 pages)
    Scou tY cleention Auto Take off Altitude hold mode Object Round fly mode One key Return To Home Hyper IOC mode Retractable Landing Gear GPS telemetry 5.8G video down link Match with DEVO F12E Radio Quick Start Guide and Systems Flowchart M1 M2 • Specifications: Main Rotor Dia. : 233mm Overall (L x W x H): 335 x 335 x 275mm Weight: 1770g(Batt …
  • Snelflight

    QuadPod 2

    (20 pages)
    1 QuadPod 2 Brushless Quadcopter Thank you for purchasing the Snelflight QuadPod 2, a compact but powerful brushless-motor Quadcopter. The model can be built up in about an hour, thanks to its delightfully simple construction and plain English instructions. Everything is included, no gluing or soldering is requir …

Comments, Questions and Opinions: