LG LG270N1C(W)-G3 Installation Instructions Manual

Text of LG LG270N1C(W)-G3 User Guide:

• Table of Contents Revisions Table 1 CONTENTS 1. Safety 2 2. Before & After Installation 3 3. Electrical Installation 4 4. Mechanical Installation 5 5. Product Specifications 8 6. Disclaimer of Liability / Disposal 9 7. Transporting and Storage 9 Date 2012.08.01 2013.04.20 1.0 (1 st edition) 2.0 Add description of Mechanical Installation Version RemarkDescription of change

• LG LG270N1C(W)-G3, Safety 2 Do not make holes in the frame or glass of the module. It may decrease the strength of the frame or break the glass. Do not touch the glass surface or frame of the solar module after installation of the module. It may result in injury. Do not locate a heavy object onto the module. Do not stand on or step on the module. Do not drop or suddenly lay down the module. It may result in injury. Do not scratch the coating surface of the frame. It may decrease the strength due to corrosion of the frame. Do not concentrate sunlight on the module surface. It may result in damage of the product. Do not apply a shock to the junction box o

• LG LG270N1C(W)-G3, 3 Before & After Installation • Wear a safety belt if working high above the ground. • Contact with electrically active parts of the panels, such as terminals, can result in burns, sparks and lethal shock whether the panel is connected or disconnected. • Even partial shadowing can substantially reduce panel and system output. • Care must be taken to avoid low tilt angles which may cause dirt to buildup on the glass against the frame edge. • Dirt build-up on the surface of the panel can cause active solar cells to be sh

• LG LG270N1C(W)-G3, -- Parallel connection for more current 4 Electrical Installation Parallel Connection • The solar modules may be combined in parallel to produce the desired current output. • When modules are combined in parallel, the total current is equal to the sum of currents from each module. • The voltage of each module connected in parallel should be same. • When connecting plural strings of modules in parallel every series string or solar module must be fused prior to combining with other strings. By pass diodes are factory installed in the solar modules. • Please

• LG LG270N1C(W)-G3, 5 Mechanical Installation Module Mounting • The LG Electronics’ (LGE) Limited Warranty for solar modules is contingent upon modules being mounted in accordance with the requirements described in this section. • The solar modules are in Application Class A and have the Safety Class II. Therefore they can be operated in systems with 120 V DC and higher. General access is not restricted. Site Consideration LGE solar modules should be mounted in a loca-tion that meets the following requirements. Operating Temperature • Maximum Operating Temperature: +9

• LG LG270N1C(W)-G3, 6 Mechanical Installation • A 6mm gap between module frames should be allowed to avoid tension from thermal expansion. • The solar module may be mounted using the following methods: (*Torque:8~12Nm ) • When installing modules in heavy snow areas, it is recommended to be taken an appropriate countermeasure to prevent possible damages to the lower side frame by slipping snow . (e.g. attach supporting part to the lowest modules) Bolt Flat washer Flat washer Nut Support More than 40mm More than 10mm

• LG LG270N1C(W)-G3, 7 Mechanical Installation LGXXXN1C(W)-G3 Mounting Type Clamping Type (Long Side) Clamping Type (Short Side) Use four mounting holes on two opposite sides. Use four clamps on the long frame. Use four clamps on the short frame and two clamps at the center of long Frame. Clamping Range (230mm) Use four clamps on the Short frame. This method is not tested by IEC/UL. This installation is allowed in the following cases: 1. Slope roof: If module is installed parallel to the rooftop. 2. Flat roof: If installed with an additional stand such as wind shield or deflector.

• 8 Product Specifications - Electrical and Mechanical Properties (Rated electrical characteristics are within 10 percent) Standard Test Condition(STC) : Irradiation 1,000W/m 2 , Cell temp. 25°C, AM1.5 Note : *Relative efficiency reduction by respect to irradiance LGXXXN1C(W)-G3 Cross-sectional drawings Unit: mm / in. Long side frame Short side frame - Dimensions of Modu

• LG LG270N1C(W)-G3, 9 Disclaimer of Liability / Disposal Disclaimer of Liability • Since the use of this Safety, Installation and Operation instructions and the conditions or methods of installation, operation, use and maintenance of the panel are beyond the control of LG Electronics, LG Electronics does not assume responsibility and expressly disclaims liability for loss, damage, injury or expense arising out of or in any connected with such installation, operation, use or maintenance of the panel. • LG Electronics assumes no responsibility for any infringement of patents or other righ

• LG LG270N1C(W)-G3, LG Electronics Deutschland GmbH Berliner Straße 93 D-40880 Ratingen, Germany Contact: [email protected] http://www.lg-solar.com This document is subject to change without notice. LG, LG logo and Life's Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws. Document: II-N-IEC-V2-EN-201304

Related Products and Documents (Solar panel):

Comparable Devices:

Similar Resources:

• Bresser 3810070 (16 pages) 3x - 4xMobile Solar PanelMobile Solar PanelMobile Solar Panel Mobile Solar PanelPower Station Phone USB Device TabletMade in ChinaBresser GmbHGutenbergstr. 246414 Rhede, GermanyBresser UK Ltd.3G Eden House, Enterprise Way,Edenbridge, TN8 6Hf, Kent, UKMOBILE SOLAR PANEL 120WArt. No. 3810070GB Instruction manualDE BedienungsanleitungMobile Solar Panel …

• RGC 4110020 (12 pages) SOLAR PANEL 12 & 24 VDC INSTRUCTIONS (Applies to P/Ns 4110020 & 3641357) REIMANN & GEORGER CORPORATION MARINE PRODUCTS BUFFALO, NY P/N 6114200 04/09/18 …

• Apricus etc (2 pages) •Lay the Front Tracks out parallel on the ground with Bottom Track in place. •Standard positions for Front Tracks are underneath tubes:! 10T: 8 tubes apart! 20T: 16 tubes apart! 22T: 16 tubes apart! 30T: 19 tubes apart •Front Tracks must be within +/- 2 tubes (140mm / 5.5” ) of the standard position. •Use the Bottom Track holes as a guide …

• Sanyo HIP-190BE3 (4 pages) 1 Printed in Japan 04.09.22.000 INTRODUCTION Thank you for choosing SANYO HIT PV modules. With proper operation and maintenance, SANYO HIT PV modules will provide you with clean, renewable solar electricity for many years. Retain this manual for reference. This manual contains important information about installation, maintenance and safety. Please …

• Go Power GP-ECO-10 (22 pages) ECO SOLAR POWER KITS™User ManualGP-ECO-10GP-ECO-20GP-ECO-80© 2018 Go Power!®Worldwide Technical Support and Product Information gpelectric.comGo Power! Headquarters#201-710 Redbrick St., Victoria, BC Canada V8T 5J3Tel: 1.866.247.652773839_MAN_GP_ECO_80_20_10_RevDpowered by® …

• ubbink SolarMax 600 Accu (84 pages) SolarMaxSolarMax® ® 600 Accu / 1000 Accu600 Accu / 1000 AccuManual Solarmax® 600 Accu / 1000 Accu.indd 1Manual Solarmax® 600 Accu / 1000 Accu.indd 1 08.11.21 14:0108.11.21 14:01 …

Comments, Questions and Opinions: