Xtralis Manuals

Top User Guides by Xtralis:

• Xtralis Power Supply VESDA VPS-VEA-115UL Installation instructions (2 pages) OperationTThe Xtralis Model VPS-VEA-115UL and VPS-VEA-230UL are power supplies that convert a 120VAC / 60Hz or 230VAC / 50Hz respectively input to 24VDC nominal output (see specications). They are intended for use in applications requiring UL Listing for Fire Protective Signaling. The units must be installed in accordance with the National Electric Code …

• Xtralis Measuring Instruments OSID Installation sheet (2 pages) Installation Sheet - OSID Smoke Detection SystemDetach Detector Mounting Bracket from Front Cover. • To detach the unit from the Mounting Bracket (A), open the front cover and with a screwdriver push the lip backwards to then slide the unit up to detach from the Mounting Bracket• To provide cable access to the Termination Card of the Imager or externa …

• Xtralis DVR ADPRO FastTrace Quick setup manual (4 pages) Quick Setup Guide201335.06 Page 1 Vision Fire & SecurityADPRO®FastTrace™Use this guide for the first-time setup of the ADPRO FastTrace Remote Access DVR.The setup procedure is the same for 5-channel, 10-channel and 20-channel models.Unpack the ADPRO FastTrace and check for signs of damage. If any damage is found, before installation please reportto yo …

• Xtralis Security Sensors VESDA VLF Installing instructions (2 pages) Installing the VN interface card into an Xtralis VESDA VLF detectorDepress the security tab with a at blade screw driver and lift the eld service access door.Unscrew the two front cover retaining screws, lift and swing down the front cover. Unplug the detector’s incoming power connection.Plug the interface cable into the card, then plug the other end …

• Xtralis Smoke Alarm VESDA VLF-250 Installation instructions (2 pages) These installation instructions provide essential information for installing VESDA VLF Aspirating Smoke Detectors in accordance with the system design. Additional installation and product documentation is listed below in the Reference Documents section.System ComponentsThe detector is shipped with the following components:• 1 VESDA VLF detector with tt …

• Xtralis Control Unit ADPRO HeiTel IFM-485-ST Quick installation manual (2 pages) DeutschEnglishEspañolGeneral If the installation and usage instructions in these directions are not observed, the manufacturer’s liability for damages or violations is expressly excluded for:• In case of improper use• Use of non-original parts/replacement parts• Impermissible changes to the device without the consent of the manufacturer in writing� …